2008 JEEP WRANGLER heater

▫Operating Instructions - Hands-Free Phone
(If Equipped) ........................257
▫ Operating Instructions - Video Entertainment
System (VES) (If Equipped) .............258
 CD/DVD Disc Maintenance ...............258
 Radio Operation And Cellular Phones ........258
 Climate Controls .......................259 ▫
Manual Heater Only ...................259
▫ Manual Air Conditioning And Heating System
— If Equipped .......................261
▫ Air Conditioning .....................264
▫ Operating Tips .......................265
UNDERSTANDING YOUR INSTRUMENT PANEL 203
4

CLIMATE CONTROLS
Manual Heater Only
The controls for the heating/ventilation system in this
vehicle consist of a series of rotary knobs. These comfort
controls can be set to obtain desired interior conditions.
Mode Control
The mode control allows you
to choose from several pat-
terns of air distribution. You
can select either a primary
mode, as identified by the
symbols, or a blend of two of
these modes. The closer the
control is to a particular
mode, the more air distribu-
tion you receive from that
mode.
Panel Air is directed through the outlets in the instrument
panel. These outlets can be adjusted to direct airflow.
Bi-Level Air is directed through the panel and floor outlets.
UNDERSTANDING YOUR INSTRUMENT PANEL 259
4

STARTING AND OPERATING
CONTENTS
Starting Procedures .....................271
▫ Manual Transmission ..................271
▫ Automatic Transmission ................271
▫ Normal Starting ......................271
▫ Extreme Cold Weather (Below –20°F
Or –29°C) ...........................272
▫ If Engine Fails To Start .................273
▫ After Starting ........................274
 Engine Block Heater — If Equipped .........275
Manual Transmission ....................275
▫ Shifting ............................276
▫ Downshifting ........................277
▫ Reverse Shifting ......................278
 Automatic Transmission ..................279
▫ Shift Lock Manual Override ..............279
▫ Brake/Transmission Interlock System .......281
▫ Automatic Transmission With Overdrive .....281
5

Turn the ignition switch to the START position and
release when the engine starts. If the engine fails to start
within 10 seconds, turn the ignition switch to the LOCK
position, wait 10 to 15 seconds, then repeat the normal
starting procedure.
Tip Start Feature — Automatic Transmission Only
Turn the ignition switch to START position and release it
as soon as the starter engages. The starter motor will
continue to run, but will automatically disengage itself
when the engine is running. If the engine fails to start, the
starter will disengage automatically in 10 seconds. If this
occurs, turn the ignition switch to the LOCK position,
wait 10 to 15 seconds, then repeat the normal starting
procedure.
Extreme Cold Weather (below –20°F or –29°C)
To ensure reliable starting at these temperatures, use of
an externally-powered electric engine block heater (avail-
able from your authorized dealer) is recommended.
Ignition Key Positions
272 STARTING AND OPERATING

ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms engine coolant and
permits quicker starts in cold weather. Connect the cord
to a standard 110-115 Volt AC electrical outlet with a
grounded, three wire extension cord. The engine block
heater cord is found under the hood bundled in front of
the battery tray.
WARNING!
Remember to disconnect the cord before driving.
Damage to the 110-115 Volt AC electrical cord could
cause electrocution.
Use the heater when temperatures below 0°F (-18°C) are
expected to last for several days.
MANUAL TRANSMISSION
WARNING!
You or others could be injured if you leave the
vehicle unattended without having the parking
brake fully applied. The parking brake should al-
ways be applied when the driver is not in the vehicle,
especially on an incline.
CAUTION!
Never drive with your foot resting on the clutch
pedal, or attempt to hold the vehicle on a hill with the
clutch pedal partially engaged, as this will cause
abnormal wear on the clutch.
STARTING AND OPERATING 275
5

IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate ac-
tion.
•On the highways — Slow down.
•In city traffic — While stopped, shift transmission into
NEUTRAL, but do not increase engine idle speed.
NOTE: There are steps that you can take to slow down
an impending overheat condition. If your air conditioner
is on, turn it off. The air conditioning system adds heat to
the engine cooling system and turning off the A/C
removes this heat. You can also turn the Temperature
Control to maximum heat, the Mode Control to floor, and
the Fan Control to High. This allows the heater core to act
as a supplement to the radiator and aids in removing heat
from the engine cooling system.
CAUTION!
Driving with a hot cooling system could damage
your vehicle. If the temperature gauge reads HOT
(H), pull over and stop the vehicle. Idle the vehicle
with the air conditioner turned off until the pointer
drops back into the normal range. If the pointer
remains on HOT (H), and you hear continuous
chimes, turn the engine off immediately, and call for
service.
WHAT TO DO IN EMERGENCIES 365
6

2. Park the booster vehicle within cable reach but with-
out letting the vehicles touch. Set the parking brake on
both vehicles, shift the automatic transmission into
PARK, or the manual transmission into NEUTRAL, and
turn the ignition OFF.
3. Turn off the heater, radio, and all unnecessary electri-
cal loads.
4. Connect one end of a jumper cable to the positive
terminal of the booster battery. Connect the other end of
the same cable to the positive terminal of the discharged
battery.
WARNING!
Do not permit vehicles to touch each other as this
could establish a ground connection and personal
injury could result.5. Connect the other cable, first to the negative terminal
of the booster battery and then to the engine of the
vehicle with the discharged battery. Make sure you have
a good contact on the engine.
6. Start the engine in the vehicle which has the booster
battery, let the engine idle a few minutes, then start the
engine in the vehicle with the discharged battery.
7. When removing the jumper cables, reverse the above
sequence exactly. Be careful of the moving belts and fan.
372 WHAT TO DO IN EMERGENCIES

Cavity CartridgeFuseMini
Fuse Description
M11 10 Amp
Red (Ignition Off Draw)
IOD-HVAC/ATC, MW
SENSR, Underhood
Lamp (UH LMP)
M12 30 Amp GreenAmplifier (AMP)
M13 20 Amp YellowIgnition Off Draw—
Cabin Compartment
Node (IOD-CCN),
Wireless Control Mod-
ule (WCM), SIREN,
Multifunction Control
Switch (MULTIFCTN
SW)
M14 20 Amp YellowTrailer Tow (Export
Only)Cavity Cartridge
FuseMini
Fuse Description
M15 20 Amp
Yellow COL MOD, IR SNS,
Heater Ventilation, Air
Conditioning/
Automatic Temperature
Control (HVAC/ATC),
Rear View Mirror (RR
VW MIR), Cabin Com-
partment Node (CCN),
Transfer Case Switch
(T-CASE SW), RUN/ST,
Multi-Function Control
Switch (MULTIFTCN
SW), Tire Pressure
Monitor (TPM), Glow
Plug Module (GLW
PLG MOD) — Export
Diesel Only
416 MAINTAINING YOUR VEHICLE