2008 JEEP PATRIOT headlights

activated will cause the alarm to sound. Press the UN-
LOCK button to deactivate the Security Alarm.
5. If the desired programming was not achieved or to
reactivate this feature, repeat the above steps.
To Lock The Doors And Liftgate
Press and release the LOCK button on the RKE transmit-
ter to lock all doors. The turn signal lights will flash and
the horn will chirp once to acknowledge the lock signal.
If desired, the “Sound Horn On Lock” feature can be
turned on or off. On EVIC equipped vehicles refer to
“Personal Settings” under “Electronic Vehicle Informa-
tion Center (EVIC)” in Section 4.
For vehicles not equipped with an EVIC, perform the
following steps:
1. Press the LOCK button for four to 10 seconds.
2. While the LOCK button is pressed (after four seconds),
press the PANIC button. Release both buttons.The “Sound Horn On Lock” and “Flash Lamps With
Lock” features can be reactivated by repeating this pro-
cedure.
Using The Panic Alarm
To turn the Panic Alarm feature ON or OFF, press and
hold the PANIC button on the RKE transmitter for at
least one second and release. When the Panic Alarm is on,
the headlights and park lights will flash, the horn will
pulse on and off and the interior lights will turn on.
The Panic Alarm will stay on for three minutes unless
you turn it off by pressing the PANIC button a second
time or if the vehicle speed is 5 mph (8 km/h) or greater.
NOTE:When you turn off the Panic Alarm by pressing
the PANIC button a second time, you may have to be
closer to the vehicle due to the radio frequency noises of
the system.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 21
2

Seats................................109
▫Front Seat Adjustment..................109
▫Manual Seat Height Adjustment —
If Equipped.........................110
▫Manual Lumbar — If Equipped...........111
▫Driver’s Seatback Recline................112
▫Adjustable Head Restraints..............113
▫Heated Seats — If Equipped.............114
▫Fold-Flat Front Passenger Seat............115
▫Folding Rear Seat.....................116
▫Reclining Rear Seat — If Equipped.........117

To Open And Close The Hood.............118
Lights...............................120
▫Map/Reading Lights...................120
▫Multifunction Control Lever..............121
▫Headlights, Parking Lights, Instrument Panel
Lights .............................121
▫Daytime Running Lights (DRL) —
If Equipped.........................122
▫Lights-On Reminder...................122
▫Fog Lights — If Equipped...............123
▫Turn Signals.........................123
▫Highbeam/Lowbeam Select Switch.........124
▫Passing Light........................125
▫Off-Road Lights — If Equipped...........125
74 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Multifunction Control Lever
The Multifunction Control Lever controls the operation
of the headlights, parking lights, turn signals, headlight
beam selection, instrument panel light dimming, interior
lights, the passing lights, and the fog lights. The Multi-
function Control Lever is located on the left side of the
steering column.
Headlights, Parking Lights, Instrument Panel
Lights
Turn the end of the Multifunction Control Lever to the
first detent for parking light operation. Turn to the
second detent for headlight operation.
Headlight Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 121
3

To change the brightness of the instrument panel lights,
rotate the center portion of the Multifunction Control
Lever up or down.Daytime Running Lights (DRL) — If Equipped
The high beam lights will come on as Daytime Running
Lights (DRL) at DRL intensity (lower), whenever the
ignition is on, the engine is running, the headlight switch
is off, the parking brake is off, the turn signal is off, and
the shift lever is in any position except park.
Lights-On Reminder
If the headlights or parking lights are left on after the
ignition is turned OFF, a chime will sound to alert the
driver when the driver’s door is opened.
Dimmer Control
122 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Fog Lights — If Equipped
The front fog light switch is on the Multifunction
Control Lever. To activate the front fog lights, turn
on the parking lights or the low beam headlights and pull
out the end of the Multifunction Control Lever.NOTE:The fog lights will only operate with the head-
lights on low beam. Selecting high beam headlights will
turn off the fog lights.
Turn Signals
Move the Multifunction Control Lever up or down and
the arrows on each side of the instrument cluster flash to
Front Fog Lights Control
Turn Signal Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 123
3

show proper operation of the front and rear turn signal
lights. You can signal a lane change by moving the lever
partially up or down without moving beyond the detent.
If either light remains on and does not flash, or there is a
very fast flash rate, check for a defective outside light
bulb. If an indicator fails to light when the lever is
moved, it would suggest that the fuse or indicator bulb is
defective.Highbeam/Lowbeam Select Switch
Push the Multifunction Control Lever away from you to
switch the headlights to HIGH beam. Pull the Multifunc-
tion Control Lever toward you, to switch the headlights
back to LOW beam.
High Beam Control
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Passing Light
You can signal another vehicle with your headlights by
lightly pulling the Multifunction Control Lever toward
you. This will cause the headlights to turn on at high
beam and remain on until the lever is released.
NOTE:If the Multifunction Control Lever is held in the
flash-to-pass position for more than 15 seconds, the high
beams will shut off. If this occurs, wait 30 seconds for the
next flash-to-pass operation.
Off-Road Lights — If Equipped
CAUTION!
The auxiliary Off-Road lights mounted on the front
bumper should be illuminated during “Off-Road
Use Only”. Having them illuminated on public
streets, highways, roads, etc. may be illegal in your
state. Your state may also require auxiliary Off-Road
lights to be covered when operating your vehicle on
public streets, highways, roads, etc. Further illumi-
nating these lights with supplied covers installed
could cause permanent damage to the lights or cov-
ers. Before using these auxiliary Off-Road lights,
contact your State Authorities for proper operation
and use of these lights.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 125
3

NOTE:The auxiliary Off-Road lights can only be acti-
vated when the high beam headlights are on.
Press the top of the switch to turn on the auxiliary
Off-Road lights when off-road conditions require addi-
tional lighting. Press the bottom of the switch to turn off
the auxiliary Off-Road lights.
Off-Road Light Switch
126 UNDERSTANDING THE FEATURES OF YOUR VEHICLE