2008 JEEP LIBERTY warning light

²The use of leaded gas is prohibited by Federal law.
Using leaded gasoline can impair engine performance,
and damage the emission control system.
²An out-of-tune engine, or certain fuel or ignition
malfunctions, can cause the catalytic converter to
overheat. If you notice a pungent burning odor or
some light smoke, your engine may be out of tune or
malfunctioning and may require immediate service.
Contact your dealer for service assistance.
²The use of fuel additives, which are now being sold as
octane enhancers, is not recommended. Most of these
products contain high concentrations of methanol.
Fuel system damage or vehicle performance problems
resulting from the use of such fuels or additives is not
the responsibility of the manufacturer.
NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
Carbon Monoxide Warnings
WARNING!
Carbon monoxide (CO) in exhaust gases is deadly.
Follow the precautions below to prevent carbon
monoxide poisoning:
²Do not inhale exhaust gases. They contain carbon
monoxide, a colorless and odorless gas, which can kill.
Never run the engine in a closed area, such as a
garage, and never sit in a parked vehicle with the
engine running for an extended period. If the vehicle is
stopped in an open area with the engine running for
more than a short period, adjust the ventilation system
to force fresh, outside air into the vehicle.
358 STARTING AND OPERATING

CAUTION!
²Damage to the fuel system or emission control
system could result from using an improper fuel
tank filler tube cap (gas cap).
²A poorly fitting gas cap could let impurities into
the fuel system.
²A poorly fitting gas cap may cause the Malfunc-
tion Indicator Light to turn on.
²To avoid fuel spillage and overfilling, do not ªtop
offº the fuel tank after filling. When the fuel
nozzle ªclicksº or shuts off, the fuel tank is full.
WARNING!
²Never have any smoking materials lit in or near
the vehicle when the gas cap is removed or the
tank filled.
²Never add fuel to the vehicle when the engine is
running.
²A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on
the ground while filling.
360 STARTING AND OPERATING

CAUTION!
If the trailer weighs more than 1,000 lbs (454 kg)
loaded, it should have its own brakes, and they
should be of adequate capacity. Failure to do this
could lead to accelerated brake lining wear, higher
brake pedal effort, and longer stopping distances.
WARNING!
Do not connect trailer brakes to your vehicle's hy-
draulic brake lines. It can overload your brake sys-
tem and cause it to fail. You might not have brakes
when you need them and could have an accident.
Towing any trailer will increase your stopping dis-
tance. When towing you should allow for additional
space between your vehicle and the vehicle in front
of you. Failure to do so could result in an accident.
Towing Requirements Ð Trailer Lights & Wiring
Whenever you pull a trailer, regardless of the trailer size,
stoplights and turn signals on the trailer are required for
motoring safety.
The Trailer Tow Package may includea4and7pin
wiring harness. Use a factory approved trailer harness
and connector.
NOTE:Do not cut or splice wiring into the vehicles
wiring harness.
STARTING AND OPERATING 375
5

5. Raise the vehicle by turning the jack screw to the right.
Raise the vehicle only until the tire just clears the surface
and enough clearance is obtained to install the spare tire.
Minimum tire lift provides maximum stability.
WARNING!
Raising the vehicle higher than necessary can make
the vehicle less stable and cause an accident. It could
slip off the jack and hurt someone near it. Raise the
vehicle only enough to remove the tire.
6. Remove the lug nuts and wheel.
7. Position the spare wheel/tire on the vehicle and install
lug nuts with cone-shaped end toward wheel. Lightly
tighten the nuts. To avoid the risk of forcing the vehicle
off the jack, do not tighten the nuts fully until the vehicle
has been lowered.
8. Lower the vehicle by turning the jack screw to the left,
and remove the jack and wheel blocks.
9. Finish tightening the lug nuts. Push down on the
wrench while tightening for increased leverage. Alternate
Rear Jacking Location
WHAT TO DO IN EMERGENCIES 389
6

²Inspect the brake hoses whenever the brake system is
serviced and at every engine oil change. Inspect hy-
draulic brake hoses for surface cracking, scuffing, or
worn spots. If there is any evidence of cracking,
scuffing, or worn spots, the hose should be replaced
immediately! Eventual deterioration of the hose can
take place resulting in a possibility of a burst failure.
WARNING!
Worn brake hoses can burst and cause brake failure.
You could have an accident. If you see any signs of
cracking, scuffing, or worn spots, have the brake
hoses replaced immediately.
Master Cylinder - Brake Fluid Level Check
Check the fluid level in the master cylinder immediately
if the brake system warning light indicates system fail-
ure.Check the fluid level in the master cylinder when per-
forming underhood services.
Clean the top of the master cylinder area before removing
the cap. If necessary, add fluid to bring the fluid level up
to the requirements described on the brake fluid reser-
voir.
Overfilling of fluid is not recommended because it may
cause leaking in the system.
Fluid level can be expected to fall as the brake pads wear.
Brake fluid level should be checked when pads are
replaced. However, low fluid level may be caused by a
leak and a checkup may be needed.
Use only manufacturer's recommended brake fluid. Re-
fer to ªFluids, Lubricants, and Genuine Partsº in this
section for the correct fluid type.
MAINTAINING YOUR VEHICLE 423
7

use polishes, oils, cleaning fluids, solvents, detergents, or
ammonia-based cleaners to clean leather upholstery. Ap-
plication of a leather conditioner is not required to
maintain the original condition.
WARNING!
Do not use volatile solvents for cleaning purposes.
Many are potentially flammable, and if used in
closed areas they may cause respiratory harm.
YES EssentialstFabric Cleaning Procedure ± If
Equipped
YES Essentialstseats may be cleaned in the following
manner:
²Remove as much of the stain as possible by blotting
with a clean, dry towel.
²Blot any remaining stain with a clean, damp towel.
²For tough stains, apply MopartTotal Clean or a mild
soap solution to a clean, damp cloth and remove the
stain. Use a fresh, damp towel to remove the soap
residue.
²For grease stains, apply MopartMulti-Purpose
Cleaner to a clean, damp cloth and remove the stain.
Use a fresh, damp towel to remove the soap residue.
²Do not use any solvents or protectants on Yes Essen-
tialstproducts.
Cleaning Headlights
Your vehicle has plastic headlights that are lighter and
less susceptible to stone breakage than glass headlights.
Plastic is not as scratch resistant as glass and therefore
different lens cleaning procedures must be followed.
432 MAINTAINING YOUR VEHICLE

About Your Brakes....................... 308
ABS (Anti-Lock Brake System).........195,310,315
Adding Engine Coolant (Antifreeze).......... 418
Adding Fuel........................... 359
Adding Rear Washer Fluid................. 181
Adding Washer Fluid..................145,181
Additives, Fuel......................... 357
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 406
Air Conditioner Maintenance............... 411
Air Conditioning........................ 260
Air Conditioning Controls................. 260
Air Conditioning Filter.................271,412
Air Conditioning, Operating Tips............ 272
Air Conditioning Refrigerant............. 411,412
Air Conditioning System.............260,264,411
Air Filter.............................. 406
Air Pressure, Tires....................190,338
Airbag................................ 52
Airbag Deployment....................... 64Airbag Light.......................67,81,204
Airbag Maintenance....................... 66
Alarm, Panic............................ 24
Alarm (Security Alarm).................18,204
Alarm System (Security Alarm)............... 18
Alignment and Balance................... 343
Alterations/Modifications, Vehicle............. 8
Antenna, Satellite Radio................... 255
Antifreeze (Engine Coolant)...........417,418,447
Disposal............................ 419
Anti-Lock Brake System (ABS)............310,315
Anti-Lock Warning Light.................. 195
Anti-Theft Security Alarm (Theft Alarm)........ 18
Anti-Theft System....................... 204
Appearance Care........................ 428
Arming Theft System (Security Alarm)......... 18
Assist, Hill Start........................ 319
Audio Systems (Radio).................... 237
Auto Down Power Windows................ 36
470 INDEX

Auto Unlock, Doors....................... 32
Automatic Dimming Mirror................. 88
Automatic Door Locks...................31,32
Automatic Headlights.................... 134
Automatic Oil Change Indicator..........201,209
Automatic Temperature Control (ATC)......... 264
Automatic Transaxle
Special Additives...................... 425
Automatic Transmission................283,425
Adding Fluid......................425,449
Fluid and Filter Changes................. 425
Fluid Change......................... 425
Fluid Level Check...................... 425
Fluid Type........................... 449
Gear Ranges.......................... 283
Overdrive........................... 285
Special Additives...................... 425
Torque Converter...................... 287
Automatic Transmission Limp Home Mode..... 287Auxiliary Electrical Outlet (Power Outlet)...... 169
Auxiliary Power Outlet................... 169
Axle Fluid............................. 449
Axle Lubrication (Axle Fluid)............... 449
Battery............................... 409
Charging System Light.................. 194
Emergency Starting..................... 390
Gas Caution.......................... 410
Jump Starting......................... 390
Keyless Transmitter Replacement (RKE)....... 25
Belts, Drive............................ 406
Belts, Seat............................42,81
Body Mechanism Lubrication............... 413
B-Pillar Location........................ 333
Brake Assist System...................... 316
Brake Assist Warning Light................. 196
Brake Control System, Electronic............. 314
Brake Fluid............................ 449
INDEX 471
10