2008 HYUNDAI TUCSON wipers

1
FEATURES OF YOUR HYUNDAI
61
B350B01JM-GATWindshield Washer Operation
B350B03JM-U B350A02A-AAT
Windshield wipers
B350A10JM-U
MIST : For a single wiping cycle, push the lever
upward and release it with the lever in the
OFF position. The wipers will operate
continuously if the lever is pushed up-
ward and held.
O F F : Wiper is not in operation
INT : Wiper operates intermittently at the same
wiping intervals. Use this mode in a light
rain or mist. To vary the speed setting,
turn the speed control knob.
L O : Normal wiper speed
HI : Fast wiper speedNOTE:To prevent damage to the wiper system, do
not attempt to wipe away heavy accumula-
tions of snow or ice. Accumulated snow
and ice should be removed manually. If
there is only a light layer of snow or ice,
operate the heater in the defrost mode to
melt the snow or ice before using the wiper
or activate the windshield wiper blade
deicer.(If installed) Type A
B350A11JM-U
Type B
Operates as follows when the ignition switch is
turned ON.To use the windshield washer, pull the wiper/
washer lever toward the steering wheel.Type A
B350B05JM-U
Type B Fast
FastSlow
Slow

1FEATURES OF YOUR HYUNDAI62
If a single wipe is desired in mist, push the
windshield wiper and washer control lever up-
wards.
B350B04JM-U
Mist Wiper OperationType A
B350B06JM-U
Type B When the washer lever is operated, the wipers
automatically three passes across the wind-
shield. The washer continues to operate until
the lever is released.
NOTE:o Do not operate the washer more than 15
seconds at a time or when the fluid
reservoir is empty.
o In icy or freezing weather, be sure the
wiper blades are not frozen to the glass
prior to operating the wipers.
o In areas where water freezes in winter,
use windshield washer antifreeze.
B350C01O-GATAdjustable Intermittent Wiper Operation
B350C02JM-U
Type A
B350C03JM-U
Type B

6
DO-IT-YOURSELF MAINTENANCE
10
WINDSHIELD WIPER BLADESG080A02A-AATThe wiper blades should be carefully inspected
from time to time and cleaned to remove accu-
mulations of road film or other debris. To clean
the wiper blades and arms, use a clean sponge
or cloth with a mild soap or detergent and water.
If the wipers continue to streak or smear the
glass, replace them with genuine Hyundai re-
placement parts or their equivalent.
!
CAUTION:
o Do not operate the wipers on dry glass.
This can result in more rapid wear of the
wiper blades and may scratch the glass.
o Keep the blade rubber out of contact
with petroleum products such as engine
oil, gasoline, etc.
HJM5032
HJM5038
CHANGING THE AIR CLEANER
FILTERG070A01E-AATTo change the filter, unsnap the clips around the
cover. When this is done, the cover can be lifted
off, the old filter removed and the new filter put
in its place. Genuine Hyundai Replacement
Parts are recommended.
CAUTION:
o Operating your vehicle without a proper
air filter in place can result in excessive
engine wear.
o When removing the air cleaner filter, be
careful that dust or dirt does not enter
the air intake. These may result in dam-
age to the air cleaner filter.
!