2008 HUMMER H3 spare wheel

The spare tire is attached to the outside of the
swing-gate. To remove the spare tire:
1. If your vehicle has a spare tire cover release the
latch by pulling the latch straight back and turning
it away from the cover at the same time.Notice:Opening the endgate before completely
closing and latching the spare tire cover may result
in damage to your vehicle. Close and latch the
spare tire cover before opening the endgate to avoid
possible damage.
2. Remove the center
cap, if equipped, by
placing the at end of
the wheel wrench
in the slot on the wheel
and gently pry the
center cap out.
5-82

3. Use the wheel wrench
to remove the wheel
nuts securing the
spare tire.
If your vehicle has locking lug nuts, the key is
supplied in the tool bag. Use the key along with the
wheel wrench to remove the wheel nuts from
the tire.
4. Pull off and gently lower the spare tire to the
ground. Set it next to the at tire.
In order to remove the spare tire, you may need
someone to assist you.Removing the Flat Tire and
Installing the Spare Tire
1. Do a safety check before proceeding. SeeChanging
a Flat Tire on page 5-79for more information.
2. Remove the center cap
by placing the at end
of the wheel wrench
in the slot on the wheel
and gently pry the
center cap out.
5-83

5. Assemble the jack and tools as follows:
Front Tire Flat:If the at tire is on a front tire of
the vehicle, you will need to use the jack handle and
both jack handle extensions. Attach the wheel
wrench to the jack handle extensions. Attach the
jack handle to the jack. From the front of the vehicle
position the jack on the front lower control arm
along the bar that runs front to back. Turn the wheel
wrench clockwise to raise the vehicle. Raise the
vehicle far enough off the ground so there is enough
room for the spare tire to clear the ground.Refer to the graphic above to locate the placement
of the jack if the at tire is on the rear of the
vehicle. Front Position
Rear Positions
5-85

Rear Tire Flat:You will need to use the jack
handle and both jack handle extensions. Attach the
wheel wrench to the jack extensions. Attach the
jack handle to the jack. From the rear of the vehicle
align the jack under the rear axle. Turn the wheel
wrench clockwise to raise the vehicle. Raise
the vehicle far enough off the ground so there is
enough room for the spare tire to clear the ground.6. Turn the wheel wrench clockwise to raise the jack
head to the lifting point.
{CAUTION:
Getting under a vehicle when it is jacked up is
dangerous. If the vehicle slips off the jack, you
could be badly injured or killed. Never get
under a vehicle when it is supported only by
a jack.
{CAUTION:
Raising your vehicle with the jack improperly
positioned can damage the vehicle and even
make the vehicle fall. To help avoid personal
injury and vehicle damage, be sure to t the
jack lift head into the proper location before
raising the vehicle.
5-86

7. Remove all the wheel
nuts and take off the
at tire.
{CAUTION:
Rust or dirt on a wheel, or on the parts to which
it is fastened, can make wheel nuts become
loose after time. The wheel could come off and
cause an accident. When you change a wheel,
remove any rust or dirt from places where the
wheel attaches to the vehicle. In an emergency,
you can use a cloth or a paper towel to do this;
but be sure to use a scraper or wire brush later,
if needed, to get all the rust or dirt off. See
Changing a Flat Tire on page 5-79.8. Remove any rust or dirt
from the wheel bolts,
mounting surfaces
and spare wheel.
{CAUTION:
Never use oil or grease on studs or nuts.
Because the nuts might come loose. The
vehicle’s wheel could fall off, causing a crash.
9. Put the spare tire on the mounting surface.
10. Put the wheel nuts back on with the rounded end of
the nuts toward the wheel after mounting the spare.
5-87

Storing a Flat or Spare Tire
and Tools
{CAUTION:
Storing a jack, a tire, or other equipment in the
passenger compartment of the vehicle could
cause injury. In a sudden stop or collision,
loose equipment could strike someone. Store
all these in the proper place.
To store the at or spare tire on the spare tire mount:
1. Slide the at or spare tire onto the swing-gate.
In order to store the at or the spare tire, you
may need someone to assist you.
2. Reinstall the nuts to retain the at or spare tire.
3. Tighten the nuts by hand.
{CAUTION:
Incorrect or improperly tightened wheel nuts
can cause the wheel to come loose and even
come off. This could lead to a crash. If you
have to replace them, be sure to get new
original equipment wheel nuts. Stop
somewhere as soon as you can and have the
nuts tightened with a torque wrench to the
proper torque specication. SeeCapacities
and Specifications on page 5-107for wheel nut
torque specication.
4. Use the wheel wrench
to tighten the nuts
rmly. Try to move the
tire back and forth
slightly to be sure it is
secure.
5-89

Spare Tire
Your vehicle, when new, had a fully-inated spare tire.
A spare tire may lose air over time, so check its
ination pressure regularly. SeeInflation - Tire Pressure
on page 5-62andLoading Your Vehicle on page 4-42
for information regarding proper tire ination and loading
your vehicle. For instruction on how to remove, install
or store a spare tire, seeRemoving the Flat Tire
and Installing the Spare Tire on page 5-83andStoring
a Flat or Spare Tire and Tools on page 5-89.
After installing the spare tire on your vehicle, you should
stop as soon as possible and make sure the spare is
correctly inated. The spare tire is made to perform well
at speeds up to 70 mph (112 km/h) at the recommended
ination pressure, so you can nish your trip.
Have the damaged or at road tire repaired or replaced
as soon as you can and installed back onto your
vehicle. This way, a spare tire will be available in case
you need it again. Do not mix tires and wheels of
different sizes, because they will not t. Keep your spare
tire and its wheel together.
Appearance Care
Interior Cleaning
Your vehicle’s interior will continue to look its best if it is
cleaned often. Although not always visible, dust and
dirt can accumulate on your upholstery. Dirt can damage
carpet, fabric, leather, and plastic surfaces. Regular
vacuuming is recommended to remove particles
from your upholstery. It is important to keep your
upholstery from becoming and remaining heavily soiled.
Soils should be removed as quickly as possible. Your
vehicle’s interior may experience extremes of heat
that could cause stains to set rapidly.
Lighter colored interiors may require more frequent
cleaning. Use care because newspapers and garments
that transfer color to your home furnishings may also
transfer color to your vehicle’s interior.
5-91

Starting the Engine.........................................2-20
Steering.......................................................... 4-8
Steering Wheel, Tilt Wheel................................. 3-7
Storage Areas
Convenience Net.........................................2-59
Cupholder(s)...............................................2-56
Front Armrest Storage Area...........................2-57
Front Seat Storage Net................................2-57
Glove Box..................................................2-56
Luggage Carrier..........................................2-57
Rear Storage Area.......................................2-59
Stuck in Sand, Mud, Ice, or Snow.....................4-39
Sun Visors.....................................................2-13
Sunroof.........................................................2-60
Swing-gate.....................................................2-10
T
Tachometer....................................................3-27
Taillamps
Turn Signal, Stoplamps and Back-up Lamps....5-50
Theft-Deterrent, Radio.....................................3-61
Theft-Deterrent Systems...................................2-14
Content Theft-Deterrent................................2-14
PASS-Key
®III+...........................................2-16
PASS-Key®III+ Operation.............................2-16
Passlock®...................................................2-15Tilt Wheel........................................................ 3-7
Time, Setting..................................................3-48
Tire
Pressure Light.............................................3-35
Tires.............................................................5-54
Aluminum or Chrome-Plated Wheels,
Cleaning.................................................5-97
Buying New Tires........................................5-71
Chains.......................................................5-77
Changing a Flat Tire....................................5-79
Cleaning....................................................5-98
Different Size..............................................5-73
If a Tire Goes Flat.......................................5-78
Ination - Tire Pressure................................5-62
Inspection and Rotation................................5-68
Installing the Spare Tire................................5-83
Pressure Monitor Operation...........................5-65
Pressure Monitor System..............................5-63
Removing the Flat Tire.................................5-83
Removing the Spare Tire and Tools...............5-81
Spare Tire..................................................5-91
Storing a Flat or Spare Tire and Tools............5-89
Tire Sidewall Labeling..................................5-55
Tire Terminology and Denitions....................5-59
Uniform Tire Quality Grading.........................5-74
Wheel Alignment and Tire Balance.................5-75
Wheel Replacement.....................................5-75
When It Is Time for New Tires......................5-70
12