2008 HONDA S2000 low beam

Î
Î
ÎÎ
The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
1:
2 : Only on CR models. CR models are not available in Canada.
Instrument Panel
Inst rument s and Cont rols
45
TRUNK-OPEN INDICATOR
IMMOBILIZER SYSTEM INDICATOR
ANTI-LOCK BRAKE
SYSTEM (ABS)
INDICATOR
DOOR-OPEN INDICATOR
VEHICLE STABILITY
ASSIST (VSA) SYSTEM
INDICATOR
(P.50)
(P.50)
(P.47)
(P.46) CHARGING SYSTEM INDICATORLOW OIL PRESSURE INDICATOR MALFUNCTION INDICATOR LAMP CRUISE CONTROL INDICATOR (P.47)
(P.47) (P.47)
(P.49) (P.47)
(P.48)
(P.49)
SUPPLEMENTAL RESTRAINT SYSTEM
INDICATOR
VSA ACTIVATION INDICATOR
OUTSIDE TEMPERATURE INDICATOR
TURN SIGNAL AND HAZARD WARNING
INDICATORS
MAINTENANCE MINDER INDICATOR(P.50)
INFORMATION DISPLAY
HIGH BEAM INDICATORTPMS INDICATOR
(P.48) DAYTIME RUNNING
LIGHTS INDICATOR
LOW TIRE PRESSURE
INDICATOR (P.49)
LOW FUEL
INDICATOR
SEAT BELT REMINDER
INDICATOR
ELECTRIC
POWER
STEERING (EPS)
INDICATOR
(P.48)
PARKING BRAKE AND
BRAKE SYSTEM INDICATOR (P.51)
(P.51)
(P.52)
PEAK POWER INDICATOR (P.53,161)
(P.55)
(P.46,220) (P.46,218)
(P.46,218) (P.47,219)
1 2
——y
y
(yy
2008 S2000

This indicator comes on as a
reminder that you must ref uel soon.
This indicator comes on f or a f ew
seconds when you turn the ignition
switch to the ON (II) position. It will
then go of f if you have inserted a
properly-coded ignition key. If it is
not a properly-coded key, the
indicator will blink, and the engine
will not start (see page ).
This indicator also blinks several
times when you turn the ignition
switch f rom the ON (II) position to
the ACCESSORY (I) or LOCK (0)
position.
This indicator comes on with the
high beam headlights. For more
inf ormation, see page .
When the daytime running lights
(DRL) are on, this indicator comes
on with reduced brightness.
When the indicator comes on, there
is about 2.22 US gal (8.4
)of fuel
remaining in the tank bef ore the
reading reaches E. There is a small
reserve of f uel remaining in the tank
when the reading does reach E.
59
63
Instrument Panel Indicators
Low Fuel Indicator
Immobilizer System
Indicator
High Beam Indicator
Inst rument s and Cont rols
49
\f—\f—y

y
(\fy\f\fy
2008 S2000

µµ µ
Push down on the
lever to signal a lef t turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
Turning the
switch to the ‘‘ ’’ position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on with the key
removed f rom the ignition switch,
you will hear a reminder buzzer
when you open the driver’s door.
Turn Signal
Of f
Parking and indicator lights
Headlights on
High beams
Flashhighbeams Push the lever
f orward until you hear a click. The
high beam indicator will come on
(see page ). Pull the lever back to
return to the low beams.
To f lash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
With the headlight switch off, the
high beam headlights and the high
beam indicator come on with
reduced brightness when you turn
the ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch of f , even if you
set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.
1.
2.
3.
4.
5.
6. 49
Turn Signal
Headlights On High Beams
Daytime Running L ights
Turn Signals and Headlights
Inst rument s and Cont rols
59
\f—\f—y

y
(\fy\f\fy
2008 S2000

The low beam headlight bulbs are a
type of high voltage discharge tube.
High voltage can remain in the
circuit even with the light switch of f
and the key removed. Because of
this, you should not attempt to
examine or change a low beam
headlight bulb yourself . If a low
beam headlight bulb fails, take the
vehicle to your dealer to have it
replaced.Halogen bulbs are used f or the high
beam headlight bulbs. When
replacing a high beam headlight bulb,
handle it by its base, and protect the
glass from contact with your skin or
hard objects. If you touch the glass,
clean it with denatured alcohol and a
clean cloth.
Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
trunk, readjustment may be required.
Adjustment should be done by your
dealer or other qualif ied mechanic.
CONT INUED
Headlight A iming Replacing a Headlight Bulb
Lights
Maint enance
179
Halogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.
\f—\f—y

\fy
(\fy\f
y
2008 S2000

.............................................
Gauges .53
...
Engine Coolant Temperature .55
...............................................
Fuel .54
Gearshif t Lever Positions ..............
Manual Transmission .148
Gross Vehicle Weight Rating .............................
(GVWR) .139,234
.............
Halogen Headlight Bulbs .179
.......................
Hardtop, Removable .78
...................................
Installation .79
.......................................
Removal .84
..........................................
Storing .86
.......................................
Washing .86
............................
Wind Def lecter .75
..............
Hazard Warning Flashers .60
Headlights
........................................
Aiming .179
............
Daytime Running Lights .59
..................
High Beam Indicator .49
...........................
Reminder Tone .59
........
Replacing Halogen Bulbs .199
...................................
Turning on .59
.....................................
Heating .96,100 .
Heating and Cooling System .96,100
............................
High Beam Lever .59
.......................
Hood, Opening the .130
..................................................
Horn .57
...........................
Hydraulic Clutch .178
Identif ication Number,
.......................................
Vehicle .232
Ignition ..............................................
Keys .62
...........................................
Switch .64
............
Timing Control System .243
........................
Immobilizer System .63
.........
Important Safety Precautions .6
Indicators
..............
ABS (Anti-Lock Brake) .47
Brake (Parking and Brake
............................
System) .46,220
................
Charging System .46,220
.............................
Cruise Control .47
....................................
Door-open .47
DRL(Daytime Running
......................................
Lights) .48 EPS (Electrical Power
..................................
Steering) .48
...................................
High Beam .49
........
Key (Immobilizer System) .49
......................................
Low Fuel .49
................
Low Oil Pressure .46,218
..............
Low Tire Pressure .51,240
...............
Maintenance Required .50
Malf unction Indicator
................................
Lamp .47,219
..................................
Peak Power .52
.......................................
Seat Belt .46
...............................................
SRS .47
...........................
TPMS System .240
..................................
Trunk-open .47
Turn Signal and Hazard
...................................
Warning .48
..
VSA (Vehicle Stability Assist) .50
.........
Indicators, Instrument Panel .46
...................
Inf lation, Proper Tire .189
........
Recommended Pressures .190
...................................
Inside Mirror .87
.............................
Inspection, Tire .190
....................
Installing a Child Seat .34
............................
Instrument Panel .45
........
Instrument Panel Brightness .60
Index
I
H
IV
\f—\f—y
\f\fy
(\fy\f
y
2008 S2000