2008 HONDA RIDGELINE bulb

This monitor includes two f unctions;
the door open indicator and the
tailgate open indicator. This monitor
works with the ignition switch in any
position.
The specif ic door indicator comes on
in this monitor if any door is not
closed tightly.
Thetailgateindicatorcomeson
whenthetailgateisswungopenorif
it is not closed completely af ter you
swing it closed.If the tailgate is swung open or is not
closed tightly, you will hear six beeps
and see the indicator blinking when
you turn the ignition switch to the
ON (II) position. The beeper also
sounds and the indicator blinks when
you move the shif t lever out of the
Park or neutral position.
The tailgate open indicator does not
monitor the tailgate when it is
dropped open.
If the driver does not f asten the seat
belt and the tailgate is swung open,
the seat belt reminder alarm will
sound at first, then the tailgate open
reminder beeper will sound.
For more inf ormation on the tailgate,
see page .
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages and ).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle f lash.
95
258
259
Turn Signal and
Hazard Warning
Indicators
Door and T ailgate Monitor
Instrument Panel Indicators
64
\f—\f—y
\fy
(\fy\f\fy
2008 Ridgeline

Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items on the
pickup bed or pull a trailer,
readjustment may be required.
Adjustmentsshouldbedonebyyour
dealer or other qualif ied mechanic.
Your vehicle has halogen headlight
bulbs. When replacing a bulb, handle
it by its base, and protect the glass
f rom contact with your skin or hard
objects. If you touch the glass, clean
it with denatured alcohol and a clean
cloth.Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire f rom its slot. Pivot it out of
the way, and remove the bulb.
Remove the electrical connector
f rom the bulb by pulling the
connector straight back.Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Install the rubber weather seal
over the back of the headlight
assembly.Makesureitisright
side up.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
1.
2.
3. 4.
5.
6.
Headlight A iming
Replacing a Headlight Bulb
Lights
Maint enance
257
WEATHER SEAL
CONNECTOR HOLD-DOWN WIRE
BULB
Halogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.
\f—\f—y

\fy
(\fy\fy
2008 Ridgeline

To change the passenger’s side
bulb, start the engine, turn the
steering wheel all the way to the
lef t, and turn of f the engine. To
change the driver’s side bulb, turn
the steering wheel to the right.
Use a f lat-tipped screwdriver to
remove the two holding clips f rom
the inner f ender, and pull the inner
f ender cover back.Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.Turn on the lights to make sure
the new bulb is working.
Put the inner f ender cover in place.
Install and lock each holding clip
bypushingonthecenter.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
5.
6.
1.
2. 3.
4.7.
Lights
Replacing a Front T urn Signal/
Hazard/Parking L ight Bulb
258
HOLDING CLIPS
\f—\f—y

y
(\fy\fy
2008 Ridgeline

Drop open the tailgate.
Remove the two bolts, and remove
the rear light assembly f rom the
rear pillar.
Determine which of the three
bulbs is burned out: brake/
taillight, turn signal/hazard light,
or back-up light.Remove the socket by turning it
one-quarter turn counterclockwise.
Remove the burned-out bulb by
pulling it straight out of the socket.Install the new bulb into the
socket.
Push the socket into the light
assembly, and turn it clockwise
until it locks.
Turn on the lights to make sure
the new bulb is working.
Install the rear light assembly in
the rear pillar. Tighten the two
bolts securely.
1.
2.
3. 4.
5.6.
7.
8.
9.
Lights
Replacing Rear Bulbs
Maint enance
259
\f—\f—y

y
(\fy\fy
2008 Ridgeline

Place a cloth on the edge of the
lens segment. Remove each lens
segment by caref ully prying on its
edge with a small f lat-tipped
screwdriver.
Remove the screw under each lens.
Pull the high-mount brake light
assembly out of the vehicle.Remove the three mounting
screws f rom the light assembly.
Remove the lens f rom the light
assembly.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.Turn on the lights to make sure
the new bulb is working.
Put the lens back on the light
assembly, and tighten the
mounting bolts securely.
Put the light assembly back into
the vehicle. Install the screws and
tighten them securely.
Reinstall the lens segments.
1.
2.
3. 4.
5.7.
8.
9.
6.
Lights
Replacing a High-mount Brake
Light Bulb
260
LENS SEGMENT
\f—\f—y

y
(\fy\fy
2008 Ridgeline

Remove the license plate light
assembly by pulling it towards you,
and then pulling the f ront edge
upward.
Remove the socket f rom the light
assembly by turning it one-quarter
turn counterclockwise.Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Push the socket into the light
assembly, and turn it clockwise
until it locks.Turn on the lights to make sure
the new bulb is working.
Reinstall the light assembly in the
bumper.
1.
2. 3.
4.5.
6.
Lights
Replacing a Rear License Plate
Bulb
Maint enance
261
\f—\f—y

\fy
(\fy\fy
2008 Ridgeline

Remove the mounting screw f rom
the bed light assembly.
Pull out the light assembly.
Remove the socket f rom the light
assembly by turning it one-quarter
turn counterclockwise.Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Push the socket into the light
assembly, and turn it clockwise
until it locks.Turn on the lights to make sure
the new bulb is working.
Reinstall the light assembly.
Reinstall the mounting screw, and
tighten it securely.
1.
2.
3. 4.
5.6.
7.
8.
Lights
Replacing a Bed L ight Bulb
262
\f—\f—y


y
(\fy\fy
2008 Ridgeline

CONT INUED
Back Window.......................................
Indicator .69
...................................
Operation .107
Battery Charging System ...........................
Indicator .62,290
............................
Jump Starting .286
..............................
Maintenance .272
............................
Specif ications .305
Bed Lights .......................................
Indicator .69
...................................
Operation .122
..............................
Bef ore Driving .179 ....................................
Belts,Seat .8,18
.........................
Beverage Holders .116
..................................
Booster Seats .50
Brakes
...........
Anti-lock System (ABS) .213
.............
Break-in, New Linings .180
...........................................
Fluid .255
............
Bulb Replacement .259,260
.......................................
Parking .111
.................
System Indicator .63,292
........................
Wear Indicators .212
.............................
Braking System .212
.................
Break-in, New Vehicle .180
..
Brightness Control, Instruments .78
........................
Brights, Headlights .76
...
Accessories and Modif ications .188
ACCESSORY (Ignition Key
.......................................
Position) .82
............
Accessory Power Sockets .118
....................
Additives, Engine Oil .249
........
Adjusting the Steering wheel .79
...........................
Advanced Airbags .25
.....................................
Airbag (SRS) .9
..............
Air Conditioning System .124
.........................................
Usage .128
...............
Air Outlets (Vents) .126,131
.......................
Air Pressure, Tires .268
......................................
Antif reeze .251
Anti-lock Brakes (ABS)
...............................
Indicator .63,213
...................................
Operation .213
..............
Anti-thef t, Audio System .166
.
Anti-thef t Steering Column Lock .82
........................................
Armrests .102
................
Audio System .135,144,150
.....
Auto Door Locking/Unlocking .84
Automatic Heated Wiper
......................................
Zone .76,129
...
Automatic Seat Belt Tensioners .19 .............
Automatic Speed Control .169
..............
Automatic Transmission .201
..........................
Capacity, Fluid .304
...............
Checking Fluid Level .253
.......................................
Shif ting .201
Shif t Lever Position
...............................
Indicators .201
................
Shif t Lever Positions .202
....................
Shif t Lock Release .205
......................
Auxiliary Input Jack .165
Index
A
B
INDEX
I
——y
y
(yy
2008 Ridgeline