2008 HONDA ODYSSEY clock

Open the tailgate.Install the rear light assembly in
the rear pillar. Tighten the two
bolts. Snap the bolt covers into
position. Put the socket back into the light
assembly, and turn it clockwise to
lock it in place. Testthelightstomakesurethe
new bulb is working.
Remove the two bolt covers on the
rear pillar by prying on the bottom
edge with a flat-tip screwdriver.
Remove the bolts with a Phillips-
head screwdriver, and remove the
light assembly f rom the rear pillar. Push the new bulb straight into
the socket until it bottoms. Remove the bulb by pulling it
straight out of its socket. Remove the socket by turning it
one-quarter turn counterclockwise. Determine which of the two bulbs
is burned out: turn signal or
brake/taillight.
2. 3.
5.6.
1. 4.7.
8.
Lights
Replacing Rear Bulbs (in Rear
Pillar)
Maint enance
433
COVER
BOLTS BULBS
SOCKETS
——y
y
(yy
2008 Odyssey

Open the tailgate. Place a cloth on
the edge of the light assembly
cover. Remove the cover by
caref ully prying in the notch on its
middle edge with a f lat-tip
screwdriver.
Determine which of the two bulbs
is burned out: taillight or back-up
light.Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.Turn on the lights to make sure
the new bulb is working.
Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Reinstall the light assembly cover.
1.
2. 3.
4.5.
7. 6.
Lights
Replacing Rear Bulbs
(in Tailgate)
434
COVER
BULBS
SOCKETS
——y
y
(yy
2008 Odyssey

Remove the socket f rom the light
assembly by turning it one-quarter
turn counterclockwise.
Remove the two screw covers on
the light assembly by prying on
the side edge with a flat-tip
screwdriver.
Remove the screws with a Phillips-
head screwdriver, then remove
the light assembly f rom the
tailgate. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.Press the brake pedal to make
sure the new bulb is working.
Put the socket back into the light
assembly, and turn it clockwise to
lock it in place.
Reinstall the high-mount brake
light assembly into the tailgate.
Tighten the two screws and
reinstall the covers.
1.
2. 3.
4.5.
6.
7.
Lights
Replacing a High-mount Brake
Light Bulb
Maint enance
435
SCREWS
BULB
SOCKET
COVER
——y
y
(yy
2008 Odyssey

CONT INUED
Loosen the jack from its holder by
turning the end counterclockwise.Remove the bracket from the jack
storageareabyunscrewingthe
bracket mounting wing bolt.
Remove the vinyl storage bag.Move the seat belt out of the way
by hanging the latch plate on the
holder.
Fold down the third row seat (see
page ).
6.
7.
5.
4.
181
Changing a Flat Tire
T aking Care of t he Unexpect ed
459
VINYL BAG
JACK
COVER BRACKET MOUNTING
WING BOLT
HOLDER
BRACKET
——y

y
(yy
2008 Odyssey

The spare tire is stored behind spare
tire cover on the sidewall of the
cargo area on the driver’s side.Placethejackunderthejacking
point nearest the tire you need to
change. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
restinginthejacknotch.
Remove the cover by holding the
two handles on the spare tire
cover and pulling the cover out. If you are changing a rear tire,
close the sliding door.
Unscrew the tire mounting wing
bolt, and take the spare tire out of
its holder. Make sure you also turn of f the
sliding door main switch.
Loosen each wheel nut 1/2 turn
with the wheel nut wrench.
8.
9. 10.
12.
11.
On EX, EX-L and Touring models
Changing a Flat Tire
460
SEAT BELT
COVER
TIRE MOUNTING
WING BOLT
SPACER CONE
WHEEL NUT WRENCHWHEEL NUTS
——y


y
(yy
2008 Odyssey

CONT INUED
Install the bracket and the bracket
mountingwingboltonthe
attachment point as shown, and
tighten the bolt. Make sure the
bracket is securely tightened.Install the flat tire on the bracket
with the inside of the wheel facing
toward you. Install the tire
mounting wing bolt to the bracket
through one of the f ive wheel nut
holes as shown. Poke a hole in the
vinyl bag as needed. Secure the
f lat tire by tightening the tire
mounting wing bolt.
Store the jack in its holder. To
store the jack, align the locator
stud in the holder with the hole in
the jack base. Turn the jack’s end
bracket clockwise to lock it in
place. Store the tools in the
holders on the back of the jack
storage cover.
Return the third row seat to an
upright position.
YouwillfindaU-shapedcarpet
piece behind the seat bottom of
the third row seat. Pull up the U-
shaped carpet piece, f old it, and
tack the end under the carpet.
Remove the spacer, and unfasten
the plastic screw with a coin.
20.
21.
22.23.
24.
Changing a Flat Tire
T aking Care of t he Unexpect ed
463
BRACKET
TIRE MOUNTING WING BOLT
SPACER
PLASTIC SCREW BRACKET MOUNTING WING BOLT
ATTACHMENT
POINT
——y
y
(yy
2008 Odyssey

If you do not f ind an obvious leak,
check the coolant level in the
radiator reserve tank. Add coolant
if the level is below the MIN mark.
If there was no coolant in the
reserve tank, you may need to add
coolant to the radiator. Let the
engine cool down until the pointer
reaches the middle of the tempera-
ture gauge, or lower, bef ore check-
ing the radiator.Using gloves or a large heavy
cloth, turn the radiator cap
counterclockwise, without pushing
down, to the f irst stop. Af ter the
pressure releases, push down on
the cap, and turn it until it comes
off.
Start the engine, and set the
temperature control dial to
maximum heat (climate control to
AUTO at ‘‘ ’’). Add coolant
to the radiator up to the base of
the f iller neck. If you do not have
the proper coolant mixture
available, you can add plain water.
Remember to have the cooling
system drained and ref illed with
the proper mixture as soon as you
can.Put the radiator cap back on
tightly. Run the engine, and check
the temperature gauge. If it goes
back to the red mark, the engine
needs repair (see
on page ).
If the temperature stays normal,
check the coolant level in the
radiator reserve tank. If it has
gone down, add coolant to the
MAX mark. Put the cap back on
tightly.
6.
7.
8.
9.10.
11.
480
If theEngineOverheats
Emergency
Towing
470
Removing the radiator cap
while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.
——y
y
(yy
2008 Odyssey

................
DANGER, Explanation of .ii
...................................
Dashboard .3, 64
..............
Daytime Running Lights .138
Daytime Running Lights
.......................................
Indicator .73
.................................
Dead Battery .467
............
Def ects, Reporting Saf ety . 504
..............
Def ogger, Rear Window . 140
..............
Def rosting the Windows . 214
....................................
Dimensions .486
.............
Dimming the Headlights . 136
Dipstick ..........
Automatic Transmission . 425
..................................
Engine Oil .363
........................
Directional Signals .136
................................
Cancel Button .321
............................
Capacities Chart .486
.............
Carbon Monoxide Hazard . 60
..........................
Cargo Area Light .207
....................
Cargo, How to Carry .370
..............
CAUTION, Explanation of . ii
.........................................
CD Care .272
..........................
CD Changer .244, 263
CD Changer Error ...........................
Messages .251, 271
.......................................
CD Player .226
...............................
Center Pocket .202
...................................
Center Tray .195
........................
Certif ication Label .484
.................................
Chains, Tires .447
Changing Oil ........................................
How to .420
......................................
When to .407
....................
Changing a Flat Tire .458
...
Charging System Indicator . 67, 471
............
Checklist, Bef ore Driving . 376
................
Childproof Door Locks . 157
.....................................
Child Saf ety .38
..............................
Booster Seats .57 ...................................
Child Seats .46
.....
Important Saf ety Reminders . 41
..........................................
Inf ants .43
..........................
Larger Children .47
.........................................
LATCH .48
......................
Risks with Airbags .39
.............................
Small Children .44
.........................................
Tethers .53
........
Where Should A Child Sit? . 39
.......................................
Child Seats .43
......
LATCH Anchorage System . 48
..........
Tether Anchorage Points . 54
Cleaning ...................................
Seat Belts .436
...............
Climate Control System . 215
..............................................
Clock .281
.....................
Code, Audio System .284
........................
CO in the Exhaust .495
............
Cold Weather, Starting in . 377
......................
Compact Spare Tire .457
.................
Consumer Inf ormation . 502
.............
Controls, Instruments and . 63
....................
Conversation Mirror .198
Coolant ........................................
Adding .422
....................................
Checking .364 .........................
Proper Solution .422
...................
Temperature Gauge . 77
Crankcase Emissions Control ........................................
System .495
................
Cruise Control Indicator . 75
............
Cruise Control Operation . 319
...................................
Cup Holders .195
.............
Customer Service Of f ice . 502
Index
C
D
II
——y

y
(y
y
2008 Odyssey