2008 HONDA FIT mount

Mount tire chains on your tires when
required by driving conditions or
local laws. Install them only on the
f ront tires.
Because your vehicle has limited tire
clearance, mount only SAE Class ‘‘S’’
cable-type traction devices, with
rubber chain tensioners, on the f ront
tires. Use traction devices only when
required by driving conditions or
local laws. Make sure they are the
correct size f or your tires. Metal link-
type ‘‘chains’’ should not be used. Check the condition of the batterymonthlybylookingatthetest
indicator window. The label on the
battery explains the test indicator’s
colors. The test indicator window’s
location dif f ers according to the
battery manuf acturer.
When installing cables, f ollow the
manuf acturer’s instructions, and
mount them as tight as you can.
Make sure they are not contacting
the brake lines or suspension. Drive
slowly with them installed. If you
hear them coming into contact with
the body or chassis, stop and
investigate. Remove them as soon as
you begin driving on cleared roads.
Tires, Checking the Battery
Checking the BatteryT ire Chains
214
TEST INDICATOR WINDOW
Traction devices that are the wrong
size or improperly installed can
damage your vehicle’s brake lines,
suspension, body, and wheels. Stop
driving if they are hitting any part of
the vehicle.
\f—\f—y\f
y
(
\fy\f
y
2008 Fit

Check the inf lation pressure of the
compact spare tire every time you
check the other tires. It should be
inf lated to:Follow these precautions:
Never exceed 50 mph (80 km/h).
This tire gives a harsher ride and
less traction on some road
surf aces. Use greater caution
while driving.
Use the compact spare tire as a
temporary replacement only. Get
your regular tire repaired or replaced,
and put it back on your vehicle as
soon as you can.
Replace the tire when you can see
the tread wear indicator bars. The
replacement should be the same size
and design tire, mounted on the
samewheel.Thesparetireisnot
designed to be mounted on a regular
wheel, and the spare wheel is not
designed f or mounting a regular tire.
Do not use your compact spare
tire on another vehicle unless it is
thesamemakeandmodel.
Do not mount tire chains on the
compact spare tire.
On vehicles with the TPMS
system, the low tire pressure
indicator comes on and stays on
after you replace the flat tire with
the compact spare tire. Af ter
several miles (kilometers) driving
with the compact spare tire, the
TPMS indicator comes on and the
low tire pressure indicator goes of f .
Compact Spare Tire
218
INDICATOR LOCATION MARK
TREAD WEAR INDICATOR BAR
60 psi (420 kPa , 4.2 kgf/cm)
\f—\f—y\f\fy
(
\fy\fy
2008 Fit

Ú
CONT INUED
Use the extension and the wheel
nut wrench as shown to raise the
vehicle until the f lat tire is of f the
ground.
Remove the wheel nuts, then
removetheflattire.Handlethe
wheel nuts caref ully; they may be
hot from driving. Place the flat tire
on the ground with the outside
surface facing up.Bef ore mounting the spare tire,
wipeanydirtoff themounting
surface of the wheel and hub with
a clean cloth. Wipe the hub
carefully;itmaybehotfrom
driving.
Place the jack under the jacking
point nearest the tire you need to
change. It is pointed to by a
mark molded into the underside of
the body (Sport model). Turn the
end bracket clockwise until the top
of the jack contacts the jacking
point. Make sure the jacking point
tab is resting in the jack notch.
9.
11. 12.
10.
Changing a Flat Tire
T aking Care of t he Unexpect ed
221
WHEEL NUT WRENCH BRAKE HUB
JACKING POINT EXTENSION
\f—\f—y\f\fy
(
\fy\fy
2008 Fit

If your vehicle gets stuck in sand,
mud, or snow, call a towing service
to pull it out (see page ).
For very short distances, such as
f reeing the vehicle, you can use the
detachable towing hook that mounts
on the anchor in the f ront bumper.To use the towing hook:Take the towing hook and the
extension out of the tool kit in the
cargo area.
Lift the upper part of the cover
f rom the bumper by pushing the
lower part with your f inger. Put a
cloth into the space behind the
upper part of the cover. Using the
extension, remove the cover f ully.
1.
2.
238
CONT INUED
Emergency Towing, If Your Vehicle Gets Stuck
If Your Vehicle Gets Stuck
T aking Care of t he Unexpect ed
239
Trying to lif t or tow your vehicle by the
bumpers will cause serious damage.
The bumpers are not designed to
support the vehicle’s weight.
The steering system can be damaged if
the steering wheel is locked. Leave the
ignition switch in the ACCESSORY (I)
position, and make sure the steering
wheel turns f reely bef ore you begin
towing.
\f—\f—y\fy
(
\fy\fy
2008 Fit

µµµ
Î
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
Î
Î
Î
Specif ications
Technical Inf ormation
245
Air Conditioning
Battery
Lights
Fuses
Tires
Alignment
HFC-134a (R-134a)
14.1 15.9 oz (400 450 g) SP-10
12 V
12 V 60/55 W
21 W
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V 21 W
5W
Refrigerant type
Charge quantity
Lubricant type
Capacity
12 V
Headlights
Front turn signal lights
Parking lights/side marker
lights
Fog lights
Rear turn signal lights
Stop/Taillights
Back-up lights
License plate lights
Ceiling light
Cargo area Light
Taillights
High-mount brake light 8W
3CP
21 W
21/5 W
21 W
5W
55 W
3CPInterior
Under-hood
0.0in(0mm)
0.10 in (2.5 mm) 0°
1°30’
3°45’
Size
Pressure P175/65R14 81S
P195/55R15 84H
T115/70D14 88M
T125/70D14 93M
32 psi (220 kPa , 2.2 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm)
60 psi (420 kPa , 4.2 kgf/cm)
Toe-in
Camber
Caster
12 V 40 AH/20 HR 34 AH/5 HR
12 V 12 V 32 AH/5 HR See page236or the fuse label
attached to the back of the driver’s
coin tray.
See page237or the fuse box
cover.
Front
Rear
Front
Rear
Front
High/Low
(Amber)
1:
2:
(HB2)
(Amber) (H11)
Front/Rear
Spare
Front
Rear
Spare
All models except Sport
Sport model
(Amber)
1
2
2
1
\f—\f—y\fy
(
\fy\f\fy
2008 Fit

The emissions control systems are
designed and certif ied to work to-
gether in reducing emissions to
levels that comply with the Clean Air
Act. To make sure the emissions
remain low, you should use only new
Honda replacement parts or their
equivalent f or repairs. Using lower
quality parts may increase the
emissions f rom your vehicle.
The emissions control systems are
covered by warranties separate from
the rest of your vehicle. Read your
warranty manual for more informa-
tion.
The exhaust emissions controls
include f our systems: PGM-FI,
ignition timing control, exhaust gas
recirculation, and three way catalytic
converter. These f our systems work
together to control the engine’s
combustion and minimize the
amount of HC, CO, and NOx that
come out the tailpipe. The exhaust
emissions control systems are
separate f rom the crankcase and
evaporative emissions control
systems.
The PGM-FI system uses sequential
multiport f uel injection. It has three
subsystems: air intake, engine
control, and f uel control. The
powertrain control module (PCM) in
automatic transmission vehicles or
the engine control module (ECM) in
manual transmission vehicles uses
various sensors to determine how
much air is going into the engine. It then controls how much f uel to inject
under all operating conditions.
This system constantly adjusts the
ignition timing, reducing the amount
of HC, CO, and NOx produced.
The exhaust gas recirculation (EGR)
system takes some of the exhaust
gas and routes it back into the intake
manif old. Adding exhaust gas to the
air/f uel mixture reduces the amount
of NOx produced when the f uel is
burned.
The three way catalytic converter is
in the exhaust system. Through
chemical reactions, it converts HC,
CO, and NOx in the engine’s exhaust
to carbon dioxide (CO ), nitrogen
(N ), and water vapor.
2
2
Exhaust Emissions Controls Replacement Parts
Emissions Cont rols
PGM-FI System Ignit ion T iming Cont rol Syst em
Exhaust Gas Recirculat ion (EGR)Syst em
Three Way Catalytic Converter
252
\f—\f—y\fy
(
\fy\fy
2008 Fit

The three way catalytic converter
contains precious metals that serve
as catalysts, promoting chemical
reactions to convert the exhaust
gasses without af f ecting the metals.
The catalytic converter is ref erred to
as a three-way catalyst, since it acts
on HC, CO, and NOx. A replacement
unit must be an original Honda part
or its equivalent.Always use unleaded gasoline.
Even a small amount of leaded
gasoline can contaminate the
catalyst metals, making the three
way catalytic converter inef f ective.Keep the engine well maintained.
The three way catalytic converter
must operate at a high temperature
for the chemical reactions to take
place. It can set on f ire any
combustible materials that come
near it. Park your vehicle away from
high grass, dry leaves, or other
f lammables. A defective three way catalytic
converter contributes to air pollution,
and can impair your engine’s per-
f ormance. Follow these guidelines to
protect your vehicle’s three way
catalytic converter. Have your vehicle diagnosed and
repaired if it is misf iring, back-
f iring, stalling, or otherwise not
running properly.
Three Way Catalytic Converter
Technical Inf ormation
253
THREE WAY CATALYTIC CONVERTER
\f—\f—y\fy
(
\fy\fy
2008 Fit

CONT INUED
....................................
Accessories .144
ACCESSORY (Ignition Key
.......................................
Position) .78
...............
Accessory Power Socket .99
....................
Additives, Engine Oil .188
.......
Adjusting the Steering Wheel .75
...........................
Advanced Airbags .27
...............................
Airbag (SRS) .9,22
..............
Air Conditioning System .102
.........................................
Usage .103
.......................
Air Pressure, Tires .210
.......................
Alcohol in Gasoline .136
......................................
Antif reeze .190
Anti-lock Brakes (ABS)
...............................
Indicator .62,168
...................................
Operation .168
..............
Anti-thef t, Audio System .128
.
Anti-thef t Steering Column Lock .78
................................
Audio System .107
...
Automatic Seat Belt Tensioners .20
.............
Automatic Speed Control .131
..............
Automatic Transmission .157
..........................
Capacity, Fluid .244
...............
Checking Fluid Level .193 ..........................
Paddle Shif ters .162
.......................................
Shif ting .157
Shif t Lever Position
...............................
Indicators .157
................
Shif t Lever Positions .158
....................
Shif t Lock Release .161
......................
Auxiliary Input Jack .127
............................
Capacities Chart .244
.............
Carbon Monoxide Hazard .53
Battery
Charging System ...........................
Indicator .60,230
............................
Jump Starting .226
..............................
Maintenance .214
............................
Specif ications .245
..............................
Bef ore Driving .135
....................................
Belts,Seat.8,18
...........................
Beverage Holders .98
..................................
Booster Seats .50
Brakes
...........
Anti-lock System (ABS) .168
.............
Break-in, New Linings .136
....................
Bulb Replacement .201
...........................................
Fluid .195
.........................................
Parking .96 .................
System Indicator .60,232
..........................
System Design .167
........................
Wear Indicators .167
.............................
Braking System .167
.................
Break-in, New Vehicle .136
..
Brightness Control, Instruments .74
..................
Brights, Headlights .72,73
Bulb Replacement
..........................
Back-up Lights .201
..............................
Brake Lights .201
Front Parking Lights/
...
Front Side Marker Lights .198
.................................
Fog Lights .199
.................................
Headlights .196
.........
High-mount Brake Light .202
............................
Specif ications .245
....................................
Taillights .201
............
Turn Signal Lights .198,201
..............................
Bulbs, Halogen .196
Index
A
B
C
INDEX
I
\f—\f—y\f\fy
(
\fy\fy
2008 Fit