2008 HONDA CR-V ECU

[x] Cancel search: ECU

Page 109 of 373

HONDA CR-V 2008 RD1-RD5, RE7 / 3.G Owners Manual Unlock the seat f rom the f loor by 
pulling the lock release strap
under the seat cushion’s back 
edge, then lif t the rear of the seat. 
You cannot fold up the rear seat if
it is not latched secur

Page 110 of 373

HONDA CR-V 2008 RD1-RD5, RE7 / 3.G Owners Manual Make sure that the f olded up right 
rear seat does not interf ere with the
f ront passenger’s seat-back. This will 
cause the f ront passenger’s weight 
sensors and the f ront passenger’s
seat

Page 111 of 373

HONDA CR-V 2008 RD1-RD5, RE7 / 3.G Owners Manual Pull out the small latch plate and the 
latch plate f rom each holding slot in
the ceiling, and pull out the seat belt 
to extend it.Line up the triangle marks on the 
small latch plate and anchor buc

Page 118 of 373

HONDA CR-V 2008 RD1-RD5, RE7 / 3.G Owners Manual The dual deck cargo shelf will 
separate the storage area into two
storage areas. On the upper area, 
you can store small and light items. 
Youshouldplaceheavyitemsinthe
lower storage area. You can re

Page 119 of 373

HONDA CR-V 2008 RD1-RD5, RE7 / 3.G Owners Manual The dual deck cargo shelf can be 
placed on the f loor as shown above. 
Reverse this procedure to return the 
dual deck cargo shelf to the upper
position. Make sure the dual deck
cargo shelf is latche

Page 129 of 373

HONDA CR-V 2008 RD1-RD5, RE7 / 3.G Owners Manual The heating and air conditioning 
system in your vehicle provides a
comf ortable driving environment in 
all weather conditions. 
The standard audio system has 
many f eatures. This section
describes

Page 224 of 373

HONDA CR-V 2008 RD1-RD5, RE7 / 3.G Owners Manual If equipped
Once the security system is set, 
opening any door without using the
key or the remote transmitter, the 
hood, or the tailgate will cause the 
system to alarm.The security system will not

Page 233 of 373

HONDA CR-V 2008 RD1-RD5, RE7 / 3.G Owners Manual To close the hood, lif t it up slightly to 
remove the support rod f rom the
hole. Put the support rod back into 
its holding clip. Lower the hood to 
about a f oot (30 cm) above the
f ender, then let