2008 HONDA CIVIC SEDAN automatic transmission

[x] Cancel search: automatic transmission

Page 233 of 324

HONDA CIVIC SEDAN 2008  Owners Manual (in English) 
Î
Î
Fluid Locations
Except Si model
230
RADIATOR CAPAUTOMATIC
TRANSMISSION
FLUID DIPSTICK
(Yellow loop)
ENGINE COOLANT
RESERVOIR CLUTCH FLUID
(Manual
Transmission only)
(Light gray cap)
WASHER FL

Page 243 of 324

HONDA CIVIC SEDAN 2008  Owners Manual (in English) 
Check the f luid level with the engine
at normal operating temperature.If the level is below the lower
mark, add f luid into the dipstick
hole to bring it to the level
between the upper and lower
mar

Page 244 of 324

HONDA CIVIC SEDAN 2008  Owners Manual (in English) 
If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,

Page 258 of 324

HONDA CIVIC SEDAN 2008  Owners Manual (in English) 
If you check air pressures when the
tires are hot [driven f or several miles
(kilometers)], you will see readings 4
to6psi(30to40kPa,0.3to0.4
kgf /cm ) higher than the cold
readings.Thisisnormal.Dono

Page 263 of 324

HONDA CIVIC SEDAN 2008  Owners Manual (in English) 
Wheels:
Tires:See page f or inf ormation about
DOT Tire Quality Grading, and page
f or tire size and labeling
inf ormation.
(DX, Canadian DX-G)
(summer tire)
(LX, EX, EX-L)
(Si)
(LX, EX, EX-L)
(Si) (

Page 267 of 324

HONDA CIVIC SEDAN 2008  Owners Manual (in English) 
Fill the f uel tank.Block the rear wheels.
If the vehicle is to be stored f or a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
If you need to park your vehicle

Page 270 of 324

HONDA CIVIC SEDAN 2008  Owners Manual (in English) Turn on the hazard warning lights, 
and turn the ignition switch to the
LOCK (0) position. Have all 
passengers get out of the vehicle 
while you change the tire. 
Park the vehicle on f irm, level, an

Page 274 of 324

HONDA CIVIC SEDAN 2008  Owners Manual (in English) 
When you turn the ignition switch to
the START (III) position, you do not
hear the normal noise of the engine
trying to start. You may hear a
clicking sound, a series of clicks, or
nothing at all.
Ch
Page:   < prev 1-8 9-16 17-24 25-32 33-40 next >