Getting to Know Your GMC Savana/Chevrolet Express8
Reclining Front Seatbacks
To adjust the seatbacks, lift the lever
located on the inboard side of each front
seat. Move the seatback with your body
to the desired position and release the
lever. Try to move the seatback with
your body to ensure it is locked in place.
See Section 1 of your Owner Manual.
Power Front Seat Adjustment
(if equipped)
The power front seat can be adjusted
while seated using the control located
on the front of the seat cushion.
Seat Position Adjustment
To raise or lower the seat, move the
center knob (A) up or down.
To move the seat forward or rearward,
move the center knob to the right or left.
Seat Cushion Adjustment
To raise or lower the front of the seat
cushion, move the inboard lever (B) up
or down.
To raise or lower the rear of the seat
cushion, move the outboard lever (C) up
or down.
See Section 1 of your Owner Manual.
COMFORT
Manual Front Seat Adjustment
To move the front seats forward or rear-
ward, lift and hold the bar located under
the front of each seat. Slide the seat to
the desired position and release the bar.
Try to move the seat with your body to
ensure it is locked in place.
See Section 1 of your Owner Manual.
B
A
CRear Climate Control
(if equipped)
The rear heating and air conditioning
system works with the main climate
control system and regulates the
temperature, fan speed and air delivery
for the rear-seat passengers.
Using the front overhead control panel,
the driver can operate the rear climate
control, adjusting the fan speed, airflow
and temperature setting.
Turn the front fan knob to the Rear
Control position to allow rear-seat pas-
sengers to use the rear control panel.
This disables the front control panel.
Control Panel Operation
The rear climate control panel includes
the following functions:
(Fan):Turn the left knob to increase
or decrease the fan speed in the rear-
15
To install the rear seats:
1. Position the seat into the open slots in
the floor rails and push the seat for-
ward, hooking the seat onto the rails.
2. Install the locking pins into the seat
base on the inboard sides of the seat
floor latch. Move the seat to line up
with the pins in the seat base.
3. Install the pin marked “R” on the pas-
senger’s side and the pin marked “L”
on the driver’s side.
4. Push the pins down into the retaining
clips. Check that the pins are locked
in place.
5. Connect each shoulder belt by insert-
ing the latch plate into the buckle
attached at each outboard position of
the bench seat.
See Section 1 of your Owner Manual.
Rear Seat Removal and
Installation (if equipped)
To remove the rear seats:
1. Disconnect each outboard shoulder
belt on the bench seat by pressing
the tip of a key into the release hole
of the safety belt buckle while pulling
up on the safety belt.
2. Locate the two locking pins on the
inboard sides of the seat floor latch.
If there are floormats, the pins are
under a flap cut into the mat. The
driver-side pin has a gray handle
marked with an “L.” The passenger-
side pin has a black handle marked
with an “R.”
3. Pull each pin handle up to disengage
the pins. Pull out the pins.
4. Pull the seat rearward about two inch-
es and lift the seat from the floor rails.
5. Remove the seat.
