2008 FORD RANGER clock

will not affect function or durability of the transmission. Over time the
adaptive learning process will fully update transmission operation to its
optimum shift feel.
If the battery has been disconnected or a new battery has been installed,
the clock and the preset radio stations must be reset once the battery is
reconnected.
•Always dispose of automotive
batteries in a responsible manner.
Follow your local authorized
standards for disposal. Call your
local authorized recycling center
to find out more about recycling
automotive batteries.
ENGINE COOLANT
Checking engine coolant
The concentration and level of engine coolant should be checked at the
intervals listed in thescheduled maintenance information.The coolant
concentration should be maintained at 50/50 coolant and distilled water,
which equates to a freeze point of -34°F (-36°C). Coolant concentration
testing is possible with a hydrometer or antifreeze tester (such as the
Rotunda Battery and Antifreeze Tester, 014–R1060). The level of coolant
should be maintained at the “FULL COLD” level or within the “COLD
FILL RANGE” in the coolant reservoir. If the level falls below, add
coolant per the instructions in theAdding engine coolantsection.
Your vehicle was factory-filled with a 50/50 engine coolant and water
concentration. If the concentration of coolant falls below 40% or above
60%, the engine parts could become damaged or not work properly.A
50–50 mixture of coolant and water provides the following:
•Freeze protection down to -34°F (-36°C).
•Boiling protection up to 265°F (129°C).
•Protection against rust and other forms of corrosion.
•Enables calibrated gauges to work properly.
LEAD
RETURN
RECYCLE
2008 Ranger(ran)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
229

•Do not add/mix an orange-colored, extended life coolant such
as Motorcraft Specialty Orange Engine Coolant, meeting Ford
specification WSS-M97B44-D, or DEX-COOLbrand with the
factory-filled coolant.Mixing Motorcraft Specialty Orange Engine
Coolant or any orange-colored extended life product such as
DEX-COOLbrand with your factory filled coolant can result in
degraded corrosion protection.
•A large amount of water without engine coolant may be added, in case
of emergency, to reach a vehicle service location. In this instance, the
cooling system must be drained and refilled with a 50/50 mixture of
engine coolant and distilled water as soon as possible. Water alone
(without engine coolant) can cause engine damage from corrosion,
overheating or freezing.
•Do not use alcohol, methanol, brine or any engine coolants
mixed with alcohol or methanol antifreeze (coolant).Alcohol
and other liquids can cause engine damage from overheating or
freezing.
•Do not add extra inhibitors or additives to the coolant.These
can be harmful and compromise the corrosion protection of the engine
coolant.
For vehicles with overflow coolant systems with a non-pressurized cap
on the coolant recovery system, add coolant to the coolant recovery
reservoir when the engine is cool. Add the proper mixture of coolant and
water to the “FULL COLD” level. For all other vehicles, which have a
coolant degas system with a pressurized cap, or if it is necessary to
remove the coolant pressure relief cap on the radiator of a vehicle with
an overflow system, follow these steps to add engine coolant.
Note:The 3.0L and 4.0L V6 engines use the overflow system, and the
2.3L I4 engines use the degas system.
To reduce the risk of personal injury, make sure the engine is
cool before unscrewing the coolant pressure relief cap. The
cooling system is under pressure; steam and hot liquid can come out
forcefully when the cap is loosened slightly.
1. Before you begin, turn the engine off and let it cool.
2. When the engine is cool, wrap a thick cloth around the coolant
pressure relief cap on the coolant reservoir (a translucent plastic bottle).
Slowly turn cap counterclockwise (left) until pressure begins to release.
3. Step back while the pressure releases.
2008 Ranger(ran)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
232

4. When you are sure that all the pressure has been released, use the
cloth to turn it counterclockwise and remove the cap.
5. Fill the coolant reservoir slowly with the proper coolant mixture (see
above), to within the “COLD FILL RANGE” or the “FULL COLD” level on
the reservoir. If you removed the radiator cap in an overflow system, fill
the radiator until the coolant is visible and radiator is almost full.
6. Replace the cap. Turn until tightly installed. Cap must be tightly
installed to prevent coolant loss.
After any coolant has been added, check the coolant concentration, refer
toChecking engine coolant. If the concentration is not 50/50
(protection to –34° F/–36° C), drain some coolant and adjust the
concentration. It may take several drains and additions to obtain a 50/50
coolant concentration.
Whenever coolant has been added, the coolant level in the coolant
reservoir should be checked the next few times you drive the vehicle. If
necessary, add enough 50/50 concentration of engine coolant and
distilled water to bring the liquid level to the proper level.
If you have to add more than 1.0 quart (1.0 liter) of engine coolant per
month, have your authorized dealer check the engine cooling system.
Your cooling system may have a leak. Operating an engine with a low
level of coolant can result in engine overheating and possible engine
damage.
Recycled engine coolant
Ford Motor Company does NOT recommend the use of recycled engine
coolant in vehicles originally equipped with Motorcraft Premium Gold
Engine Coolant since a Ford-approved recycling process is not yet
available.
Used engine coolant should be disposed of in an appropriate
manner. Follow your community’s regulations and standards for recycling
and disposing of automotive fluids.
Coolant refill capacity
To find out how much fluid your vehicle’s cooling system can hold, refer
toMaintenance product specifications and capacitiesin this chapter.
Fill your engine coolant reservoir as outlined inAdding engine coolant
in this section.
2008 Ranger(ran)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
233

Use the following guidelines to avoid electrostatic charge build-up when
filling an ungrounded fuel container:
•Place approved fuel container on the ground.
•DO NOT fill a fuel container while it is in the vehicle (including the
cargo area).
•Keep the fuel pump nozzle in contact with the fuel container while
filling.
•DO NOT use a device that would hold the fuel pump handle in the fill
position.
Fuel Filler Cap
Your vehicle is equipped with a 1/4 turn fuel filler cap, which requires
the handle to be rotated 1/4 of a turn for removal or installation.
When fueling your vehicle:
1. Turn the engine off.
2. Carefully turn the fuel filler cap counterclockwise 1/4 of a turn until it
releases from the fuel filler pipe.
3. Carefully hang the cap from the tether.
4. To install the cap, place the cap into the filler pipe and rotate until
you hear at least one click.
If the check fuel cap lamp
or a “check fuel cap” message comes on,
the fuel filler cap may not be properly installed. The lamp or message
can come on after several driving events after you’ve refueled your
vehicle.
At the next opportunity, safely pull off of the road, remove the fuel filler
cap, align the cap properly and reinstall it. The check fuel cap
lamp
or “check fuel cap” message may not reset immediately; it may
take several driving cycles for the check fuel cap lamp
or “check fuel
cap” message to turn off. A driving cycle consists of an engine start-up
(after four or more hours with the engine off) followed by city and
highway driving.
Continuing to drive with the check fuel cap lamp
or “check fuel cap”
message on may cause the
lamp to turn on as well.
If you must replace the fuel filler cap, replace it with a fuel filler
cap that is designed for your vehicle. The customer warranty may
be void for any damage to the fuel tank or fuel system if the
correct genuine Ford or Motorcraft fuel filler cap is not used.
2008 Ranger(ran)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
237

waxing .....................................208
wheels ......................................208
wiper blades ............................211
Clock adjust
AM/FM Stereo ...........................20
AM/FM stereo CD .....................22
Premium AM/FM stereo
CD6/MP3 ...................................28
Clutch
fluid ..........................................248
operation while driving ..........159
recommended shift speeds ....160
Console ........................................54
Coolant
checking and adding ..............229
refill capacities ................233, 254
specifications ..........................254
Cruise control
(see Speed control) ....................57
Customer Assistance ................170
Ford Extended Service
Plan ..........................................203
Getting assistance outside the
U.S. and Canada .....................204
Getting roadside assistance ...170
Getting the service you
need .........................................199
Ordering additional owner’s
literature .................................205
Utilizing the
Mediation/Arbitration
Program ...................................203
D
Daytime running lamps
(see Lamps) ................................44
Dipstick
engine oil .................................221Driveline universal joint and
slip yoke ....................................251
Driving under special
conditions ..................161, 164, 167
sand .........................................166
snow and ice ...........................168
through water .................166, 169
E
Emergencies, roadside
jump-starting ..........................192
Emergency Flashers .................172
Emission control system ..........243
Engine ........................................259
cleaning ...................................209
coolant .....................................229
idle speed control ...................227
lubrication specifications .......254
refill capacities ........................254
service points ..................217–219
starting after a collision .........172
Engine block heater .................150
Engine oil ..................................221
checking and adding ..............221
dipstick ....................................221
filter, specifications ........225, 253
recommendations ...................225
refill capacities ........................254
specifications ..........................254
Event data recording ....................7
Exhaust fumes ..........................149
F
Fluid capacities .........................254
Foglamps .....................................43
Four-Wheel Drive vehicles .......161
driving off road .......................163
2008 Ranger(ran)
Owners Guide (post-2002-fmt)
USA(fus)
Index
266

Occupant Classification
Sensor ........................................73
safety belt maintenance ...........80
warning light and chime ..........81
Safety seats for children ............98
Safety Compliance
Certification Label ....................261
Satellite Radio Information ........36
Seats ............................................68
child safety seats ......................98
SecuriLock passive anti-theft
system ..........................................65
Servicing your vehicle ..............215
Setting the clock
AM/FM stereo ...........................20
AM/FM stereo CD .....................22
Premium AM/FM stereo
CD6/MP3 ...................................28
Snowplowing .................................8
Spark plugs,
specifications .....................253, 259
Special notice
ambulance conversions ..............8
utility-type vehicles ....................7
Specification chart,
lubricants ...................................254
Speed control ..............................57
Starting your
vehicle ........................146–147, 149
jump starting ..........................192
Steering wheel
tilting .........................................54
T
Tilt steering wheel ......................54Tire Pressure Monitoring
System (TPMS)
Roadside Emergencies ...........183
Tires, Wheels and Loading ....122
Tires ...........................107–109, 183
alignment ................................116
care ..........................................112
changing ..........................183, 189
checking the pressure ............112
inflating ...................................110
label .........................................121
replacing ..................................113
rotating
....................................116
safety practices
.......................115
sidewall information
...............117
snow tires and chains
............126
spare tire
.................................184
terminology
.............................109
tire grades
...............................108
treadwear
........................108, 112
Towing
.......................................133
recreational towing
.................144
trailer towing
..........................133
wrecker
....................................198
Traction-lok rear axle
...............155
Transfer case
fluid checking
.........................251
Transmission
automatic operation
...............155
brake-shift interlock (BSI)
....155
fluid, checking and adding
(manual)
.................................250
fluid, refill capacities
..............254
lubricant specifications
..........254
manual operation
....................159
Turn signal
..................................47
2008 Ranger(ran)
Owners Guide (post-2002-fmt)
USA(fus)
Index
269