sells, leases, trades vehicles, or supervises a fleet of vehicles are not
permitted to intentionally remove an emission control device or prevent
it from working. Information about your vehicle’s emission system is on
the Vehicle Emission Control Information Decal located on or near the
engine. This decal identifies engine displacement and gives some tune up
specifications.
Please consult yourWarranty Guidefor complete emission warranty
information.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if theService engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If theService engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer to the On board
diagnostics (OBD-II) description in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the ON position
for 15 seconds without cranking the engine. If theService engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if theService engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by 20
minutes of stop-and-go driving with at least four 30-second idle periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
2008 Motorhome(mot)
Supplement
USA(fus)
Maintenance and Specifications
110
cleaning .....................................88
coolant .......................................95
fail-safe cooling .......................100
idle speed control .....................93
lubrication specifications .......121
refill capacities ........................121
service points ............................90
Engine oil ....................................91
checking and adding ................91
dipstick ......................................91
filter, specifications ..........92, 120
recommendations .....................92
refill capacities ........................121
specifications ..........................121
Event data recording ....................5
Exhaust fumes ............................50
F
Fail safe cooling ........................100
Fluid capacities .........................121
Fuel ............................................101
calculating fuel economy .......105
capacity ...................................121
choosing the right fuel ...........104
comparisons with EPA fuel
economy estimates .................108
detergent in fuel .....................105
filling your vehicle with
fuel ...................................101, 106
filter, specifications ........101, 120
improving fuel economy ........105
octane rating ...................104, 124
quality ......................................104
running out of fuel .................105
safety information relating to
automotive fuels .....................101
Fuses ............................................62G
Gas mileage (see Fuel
economy) ...................................105
Gauges .........................................13
transmission fluid
temperature gauge ...................16
H
Hazard flashers ...........................61
Headlamps ...................................16
daytime running lights .............16
flash to pass ..............................17
high beam .................................16
turning on and off ....................16
I
Ignition .................................48, 124
Inspection/maintenance (I/M)
testing ........................................110
Instrument panel
cluster ..........................................8
lighting up panel and
interior .......................................17
J
Jump-starting your vehicle ........75
K
Keys
positions of the ignition ...........48
L
Lamps
daytime running light ...............16
headlamps .................................16
2008 Motorhome(mot)
Supplement
USA(fus)
Index
127
