2008 FORD ESCAPE parking brake

To replace the wiper blade:
1. Grab the wiper arm just below
the blade attachment and pull it as
far away from the glass as possible.
Do not use excessive force because
it can break the wiper arm at the
heel. Hold it there until the next
step.
2. Grab the wiper blade with your
other hand and use your fingers to
push the wiper arm tip through the
wiper blade center to separate the
blade from the arm.
3. Attach the new wiper to the
wiper arm and press it into place
until a click is heard.
If you find this procedure too
difficult, please see your dealer.
ENGINE OIL
Checking the engine oil
Refer toscheduled maintenance informationfor the appropriate
intervals for checking the engine oil.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait a few minutes for the oil to drain into the
oil pan.
3. Set the parking brake and ensure the gearshift is securely latched in P
(Park) (automatic transmissions) or 1 (First) (manual transmissions).
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully remove the engine oil level indicator (dipstick).
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
255

Keep batteries out of reach of children. Batteries contain sulfuric
acid. Avoid contact with skin, eyes or clothing. Shield your eyes
when working near the battery to protect against possible splashing of
acid solution. In case of acid contact with skin or eyes, flush
immediately with water for a minimum of 15 minutes and get prompt
medical attention. If acid is swallowed, call a physician immediately.
Battery posts, terminals and related accessories contain lead and
lead compounds.Wash hands after handling.
Because your vehicle’s engine is electronically controlled by a computer,
some control conditions are maintained by power from the battery. When
the battery is disconnected or a new battery is installed, the engine must
relearn its idle and fuel trim strategy for optimum driveability and
performance. To begin this process:
1. With the vehicle at a complete stop, set the parking brake.
2. Put the gearshift in P (Park), turn off all accessories and start the
engine.
3. Run the engine until it reaches normal operating temperature.
4. Allow the engine to idle for at least one minute.
5. Turn the A/C on and allow the engine to idle for at least one minute.
6. Drive the vehicle to complete the relearning process.
•The vehicle may need to be driven 10 miles (16 km) or more to
relearn the idle and fuel trim strategy.
•If you do not allow the engine to relearn its idle trim, the idle
quality of your vehicle may be adversely affected until the idle
trim is eventually relearned.
When the battery is disconnected or a new battery installed, the
transmission must relearn its adaptive strategy. As a result of this, the
transmission may shift firmly. This operation is considered normal and
will not affect function or durability of the transmission. Over time the
adaptive learning process will fully update transmission operation to its
optimum shift feel.
If the battery has been disconnected or a new battery has been installed,
the clock and the preset radio stations must be reset once the battery is
reconnected.
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
260

2. Park the vehicle on a level surface and engage the parking brake.
3. With the parking brake engaged and your foot on the brake pedal,
start the engine and move the gearshift lever through all of the gear
ranges. Allow sufficient time for each gear to engage.
4. Latch the gearshift lever in P (Park) and leave the engine running.
5. Remove the dipstick, wiping it clean with a clean, dry lint free rag. If
necessary, refer toIdentifying components in the engine compartment
in this chapter for the location of the dipstick.
6. Install the dipstick making sure it is fully seated in the filler tube.
7. Remove the dipstick and inspect the fluid level. The fluid should be in
the crosshatch zone for normal operating temperature.
Low fluid level
Do not drive the vehicle if the fluid
level is at the bottom of the dipstick
and the outside temperatures are
above 50°F (10°C).
Correct fluid level
The transmission fluid should be checked at normal operating
temperatures 150°F-170°F (66°C-77°C) on a level surface. The normal
operating temperature can be reached after approximately 20 miles
(30 km) of driving.
The transmission fluid should be in
the crosshatch zone if at normal
operating temperature (150°F-170°F
[66°C-77°C]).
High fluid level
Fluid levels above the crosshatch
zone may result in transaxle failure.
An overfill condition of transmission
fluid may cause shift and/or
engagement concerns and/or
possible damage.
High fluid levels can be caused by an overheating condition.
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
279

Adjusting automatic transmission fluid levels
Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick blade. Refer to
Maintenance product specifications and capacitiesin this chapter.
Use of a non-approved automatic transmission fluid may cause
internal transaxle component damage.
If necessary, add fluid in 1/2 pint (250 ml) increments through the filler
tube until the level is correct.
If an overfill occurs, excess fluid
should be removed by an authorized
dealer.
An overfill condition of
transmission fluid may cause
shift and/or engagement concerns and/or possible damage.
Do not use supplemental transmission fluid additives, treatments or
cleaning agents. The use of these materials may affect transmission
operation and result in damage to internal transmission components.
Checking and adding manual transmission fluid (if equipped)
1. Park the vehicle on a level
surface.
2. Engage the parking brake fully –
put in first gear.
3. Ensure the vehicle cannot move.
4. Clean the filler plug.
5. Remove the filler plug and
inspect the fluid level.
6. Fluid level should be at bottom of
the opening.
7. Add enough fluid through the filler opening so that the fluid level is at
the bottom of the opening.
8. Install and tighten the fill plug securely.
Use only fluid that meets Ford specifications. Refer to theMaintenance
product specifications and capacitiessection in this chapter.
AIR FILTER
Refer toscheduled maintenance informationfor the appropriate
intervals for changing the air filter element.
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Maintenance and Specifications
280

A
Accessory delay ..........................57
AdvanceTrac ..............................184
Air cleaner filter ...............280, 282
Air conditioning
automatic temperature
control system ..........................37
manual heating and air
conditioning system .................34
Airbag supplemental restraint
system ................116–117, 125, 128
and child safety seats ............118
description ..............117, 125, 128
disposal ....................................131
driver airbag ............119, 126, 129
indicator light .........125, 127, 130
operation .................119, 126, 129
passenger airbag .....119, 126, 129
side airbag ...............................125
All Wheel Drive (AWD),
driving off road .........................199
Ambulance packages ....................8
Antifreeze
(see Engine coolant) ................261
Anti-lock brake system
(see Brakes) ..............................182
Anti-theft system ........................91
Audio system (see Radio) .........20
Automatic transaxle
fluid, adding ............................278
fluid, checking ........................278
Automatic transmission ............190
driving an automatic
overdrive .................................192
fluid, refill capacities ..............283
fluid, specification ..................283
Auxiliary Input Jack ...................27Auxiliary power point .................55
Axle
lubricant specifications ..........283
refill capacities ........................283
B
Battery .......................................259
acid, treating emergencies .....259
jumping a disabled battery ....227
maintenance-free ....................259
replacement, specifications ...282
servicing ..................................259
Belt-Minder
.............................112
Booster seats .............................132
Brakes ........................................182
anti-lock ...................................182
anti-lock brake system (ABS)
warning light ...........................183
fluid, checking and adding ....278
fluid, refill capacities ..............283
fluid, specifications .................283
lubricant specifications ..........283
parking ....................................183
shift interlock ..........................190
Bulbs ............................................47
C
Capacities for refilling fluids ....283
Cargo area shade ........................73
Cargo management system ........74
Cell phone use ..............................9
Child safety restraints ..............131
child safety belts ....................131
Child safety seats ......................135
attaching with tether straps ..139
in front seat ............................136
in rear seat ..............................136
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Index
291

K
Keyless entry system .................89
autolock ...............................80, 82
keypad .......................................90
locking and unlocking doors ....91
programming entry code .........90
Keys .......................................78, 92
positions of the ignition .........178
L
Lamps
bulb replacement
specifications chart ..................47
daytime running light ...............43
fog lamps ...................................42
headlamps .................................41
headlamps, flash to pass ..........43
instrument panel, dimming .....44
interior lamps .....................45–47
replacing bulbs .........................48
Lane change indicator
(see Turn signal) ........................45
Liftgate ..................................73, 86
Lights, warning and indicator ....12
anti-lock brakes (ABS) ..........183
Load limits .................................166
Loading instructions .................172
Locks
autolock ...............................80, 82
childproof ..................................84
doors ..........................................80
Lubricant specifications ...........283
Lug nuts ....................................226
Luggage rack ...............................75M
Manual transaxle
fluid, checking and adding ....280
Manual transmission .................195
fluid capacities ........................283
lubricant specifications ..........283
reverse .....................................196
Message center ...........................66
english/metric button ...............69
system check button ................68
warning messages .....................71
Mirrors ...................................57, 60
automatic dimming rearview
mirror ........................................58
fold away ...................................61
heated ........................................61
side view mirrors (power) .......60
Moon roof ....................................65
Motorcraft parts ........247, 267, 282
N
Navigation system .......................33
O
Octane rating ............................271
Oil (see Engine oil) ..................255
Overdrive ...................................191
P
Parking brake ............................183
Parts (see Motorcraft parts) ....282
Passenger Occupant
Classification Sensor .................105
Power distribution box
(see Fuses) ...............................213
2008 Escape(204)
Owners Guide (post-2002-fmt)
USA(fus)
Index
294