2008 FORD ECONOLINE maintenance

[x] Cancel search: maintenance

Page 255 of 285

FORD ECONOLINE 2008  Owners Manual common abbreviation or the appropriate percentage for that
region. Use of other fuels such as Fuel Methanol may cause
powertrain damage, a loss of vehicle performance, and your
warranty may be invalid

Page 256 of 285

FORD ECONOLINE 2008  Owners Manual Running out of fuel
Avoid running out of fuel because this situation may have an adverse
effect on powertrain components.
If you have run out of fuel:
•You may need to cycle the ignition from off to

Page 257 of 285

FORD ECONOLINE 2008  Owners Manual For consistent results when filling the fuel tank:
•Turn the engine/ignition switch to the off position prior to refueling,
an error in the reading will result if the engine is left running.
•Use

Page 258 of 285

FORD ECONOLINE 2008  Owners Manual Habits
•Smooth, moderate operation can yield up to 10% savings in fuel.
•Steady speeds without stopping will usually give the best fuel
economy.
•Idling for long periods of time (greater than on

Page 259 of 285

FORD ECONOLINE 2008  Owners Manual •Adding certain accessories to your vehicle (for example bug
deflectors, rollbars/light bars, running boards, ski/luggage racks) may
reduce fuel economy.
•Using fuel blended with alcohol may lower

Page 260 of 285

FORD ECONOLINE 2008  Owners Manual WARNING:Do not park, idle, or drive your vehicle in dry grass
or other dry ground cover. The emission system heats up the
engine compartment and exhaust system, which can start a fire.
Illumination of

Page 261 of 285

FORD ECONOLINE 2008  Owners Manual These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel, properly tightening the fuel cap or letting the
electrical system dry out. After three driving cycles wit

Page 262 of 285

FORD ECONOLINE 2008  Owners Manual Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature.