9
FIAT PUNTO LPG
SOLENOID VALVES
AND SAFETY DEVICES
The system has a solenoid valve located
on the pressure reduction unit and a so-
lenoid valve fitted inside the multivalve as-
sembly on the tank.
The main function of these solenoid valves
is to interrupt/allow the flow of LPG to
the supply circuit.
The solenoid valves are open when:
– a request to run on LPG has been made;
– the optimum engine conditions are sat-
isfied (engine coolant temperature, mini-
mum revs level) for running on LPG;– there is enough LGP in the tank for op-
eration;
The multivalve assembly fitted on the tank
includes:
– a valve that automatically stops the sup-
ply of LPG when the maximum permitted
filling level is reached (80% of the total
tank capacity);
– a flow limiter which, if a pipe is broken,
prevents the complete and sudden escape
of LPG;
– a one-way valve, located on the gas re-
turn pipe in the tank, which prevents LPG
reflux;
– a safety solenoid valve on the LPG sup-
ply, which either gives the go ahead or
prevents the escape of gas to the pressure
reduction unit; – a manual tap, upstream of the solenoid
valve, that separates the tank from the LPG
system to allow maintenance operations;
– a fuse pad which, in the case of over-
heating (temperature above 120°C), to-
tally eliminates the danger of excess pres-
sure making the LPG in the tank flow out
as quickly as possible in a controlled man-
ner;
– an analogue gauge showing the level of
LPG in the tank.
604.39.942 Grande Punto GPL GB.qxp:603.39.944 Grande Punto GPL IT 15-12-2008 9:00 Pagina 9
10
FIAT PUNTO LPG
REGULATION UNIT
The regulation unit fig. 4includes:
– cut out solenoid valve with gauze filter;
– pressure regulator.
The cut out solenoid valveopens or
closes together with the solenoid valve on
the tank. It closes each flow of LPG when
the engine is not running on gas.
It also acts as a safety device that prevents
the flow of LPG if the inertia switch is ac-
tivated.
fig. 4F0M0475m
The pressure regulatorallows the
change of the LPG from a liquid state to a
gaseous state via a dilation chamber and
maintains the pressure required for the op-
eration of the system at a preset value.
PIPING
The piping for the LPG in a liquid state
(from the filler to the tank and from the
tank to the pressure regulator) is made
from copper and coated in plastic.
The piping for the LPG in a gaseous state
(from the pressure regulator to the LPG
injectors) is made from rubber.
604.39.942 Grande Punto GPL GB.qxp:603.39.944 Grande Punto GPL IT 15-12-2008 9:01 Pagina 10
