2008 DODGE VIPER service interval

Transmission
Transmission Fluid Level Check
Check the fluid in the transmission when performing
other underhood services.
Check the fluid level by removing the fill plug located on
the left side of the transmission. The fluid level should be
at the bottom of the fill hole. Add fluid, if necessary, to
maintain the proper level. Refer to the ªFluids, Lubri-
cants, and Genuine Partsº for the correct fluid type.
CAUTION!
Using a transmission fluid other than the manufac-
turer's recommended fluid may cause deterioration
in transmission shift quality and/or damage to the
transmission. Refer to the ªFluids, Lubricants, and
Genuine Partsº for the correct fluid type.
Change Transmission Fluid
Change the fluid at the intervals specified in the Main-
tenance Schedules in this manual. If contaminated with
water, change the fluid immediately. See your authorized
dealer for service.
Hydraulic Clutch
Master Cylinder Ð Clutch Fluid Level Check
Check the fluid in the clutch master cylinder when
performing underhood services.
Clean the top of the master cylinder area before removing
the cap. If necessary, add fluid to the reservoir.
Do Not Overfill. Overfilling can cause clutch release
problems as the clutch wears. A low fluid level may
indicate a leak, in which case, hydraulic clutch linkage
replacement may be required. The fluid level in the
reservoir will rise as the clutch wears - Do Not Remove
Fluid.
228 MAINTAINING YOUR VEHICLE

Use only the manufacturer's recommended clutch fluid.
Refer to ªFluids, Lubricants, and Genuine Partsº for the
correct fluid type.
WARNING!
Overfilling the clutch fluid reservoir can result in
spilling clutch fluid on hot engine parts and the
clutch fluid catching fire.
Use only clutch fluid that has been in a tightly closed
container to avoid contamination from foreign matter.
CAUTION!
²Do not allow petroleum base fluid to contaminate
the clutch fluid, all clutch seal components could
be damaged causing partial or complete clutch
failure.
²Clutch fluid can damage the finish of your vehicle.
Do not allow clutch fluid to contact any painted
surface.
Change Clutch Fluid
Clutch fluid will tend to absorb moisture from the
atmosphere over time. If the fluid becomes contaminated
with water, clutch performance will deteriorate. There-
fore, the clutch fluid must be changed at the intervals
specified in the ªMaintenance Schedulesº in this manu-
al.See your authorized dealer for service.
MAINTAINING YOUR VEHICLE 229
7

Rear Axle
Axle Lubricant Level Check
Check the exterior of the axle for evidence of gear oil
leakage every 12 months or 6,000 miles (10 000 km). This
check should be made with the vehicle level and sup-
ported by the suspension, with the vehicle on the ground
or raised on an axle and wheel type hoist. The axle
lubricant level should be between the bottom of the filler
plug and a point approximately 3/8 inch (9.5 mm) below
the filler plug. If adding axle lubricant, use only the
manufacturer's recommended axle lubricant. Refer to the
ªFluids, Lubricants, and Genuine Partsº for the correct
fluid type.
NOTE:The Limited Slip Differential requires that a
friction control additive be added when draining and
refilling the axle lubricant.
Change Axle Lubricant
Drain and fill the axle at the intervals specified in the
ªMaintenance Schedulesº in this manual. Change the
lubricant immediately if contaminated with water. See
your authorized dealer for service.
Wheel Bearings
The wheel bearings are permanently sealed. No regular
maintenance is required for these components.
Appearance Care and Protection from Corrosion
Your manufacturer's dealer offers a complete line of
products for cleaning your vehicle. Follow the instruc-
tions on each container.
Commercial Car Washes
We do not recommend taking this vehicle through a
commercial car wash.
230 MAINTAINING YOUR VEHICLE