2008 DODGE NITRO radio

²You can also press the ªVoice Recognitionº button
anytime while the list is being played, and then choose
the phone you wish to delete.
Things You Should Know About Your UConnectT
System
UConnecttTutorial
To hear a brief tutorial of the system features, press the
ªPhoneº button and say ªUConnecttTutorial.º
Voice Training
For users experiencing difficulty with the system recog-
nizing their voice commands or numbers, the UConnectt
system Voice Training feature may be used. To enter this
training mode, follow one of the two procedures:
From outside the UConnecttmode (e.g. from radio
mode)
²Press and hold the ªVoice Recognitionº button for 5
seconds until the session begins, or,
²Press the ªVoice Recognitionº button and say9Setup,
Voice Training9command.
Repeat the words and phrases when prompted by the
UConnecttsystem. For best results, the Voice Training
session should be completed when the vehicle is parked,
engine running, all windows closed, and the blower fan
switched off.
This procedure may be repeated with a new user. The
system will adapt to the last trained voice only.
To restore the Voice Recognition system to factory default
settings, enter the Voice Training session via the above
procedure and follow the prompts.
Voice Recognition (VR)
²
For best performance, adjust the rear view mirror to
provide at least1¤2inch (1 cm) gap between the
overhead console (if equipped) and the mirror.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 105
3

To prevent possible damage, do not slam the hood to
close it. Use a firm downward push at the center front
edge of the hood to ensure that both latches engage.
Never drive your vehicle unless the hood is fully closed,
with both latches engaged.
NOTE:Ensure hood prop rod is fully seated into clip
before closing hood to prevent damage to grille.
WARNING!
If the hood is not fully latched, it could fly up when
the vehicle is moving and block your forward vision.
Be sure all hood latches are fully latched before
driving.
LIGHTS
Interior Lights
The overhead light comes on when a door is opened. It
may also be turned on by rotating the control for the
dimmer switch on the multi-function control lever fully
upward.
The overhead light will automatically turn off in about 20
minutes if a door is left open or the dimmer control is left
in the dome light position. Turn the ignition switch ON to
restore the overhead light operation.
Daytime Brightness Feature
Certain instrument panel components (odometer, radio
display) can be illuminated at full brightness during the
daytime. This can be helpful when driving with your
headlights on during the daytime such as in a parade or
a funeral procession. To activate this feature, rotate the
left stalk one detent lower than the dome light.
122 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!
Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run your vehicle in the garage while
training the transceiver. Exhaust gas can cause seri-
ous injury or death.
Programming HomeLinkT
Before You Begin
If you have not trained any of the HomeLinktbuttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for 20
seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed
to HomeLinktfor more efficient training and accurate
transmission of the radio-frequency signal.Your vehicle should be parked outside of the garage
when programming.
1. Turn the ignition switch to the ON/RUN position.
2. Hold the battery side of the hand-held transmitter
away from the HomeLinktbutton you wish to program.
Place the hand-held transmitter 1±3 inches (3±8 cm) away
from the HomeLinktbutton you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both the chosen
HomeLinktbutton and the hand-held transmitter button
until the HomeLinktindicator changes from a slow to a
rapidly blinking light, then release both the HomeLinkt
and hand-held transmitter buttons.
Watch for the HomeLinktindicator to change flash rates.
When it changes, it is programmed. It may take up to 30
seconds, or longer in rare cases. The garage door may
open & close while you train.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139
3

6. Firmly press and release the ªlearnº or ªtrainingº
button. The name and color of the button may vary by
manufacturer.
NOTE:There are 30 seconds in which to initiate the next
step after the ªLearnº button has been pressed.7. Return to the vehicle and press the programmed
HomeLinktbutton twice (holding the button for 2 sec-
onds each time). If the device is plugged in and activates,
programming is complete.
If the device does not activate, press the button a third
time (for 2 seconds) to complete the training.
If you are have any problems, or require assistance,
please call toll-free 1±800±355±3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLinktbuttons,
repeat each step for each remaining button. DO NOT
erase the channels.Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter sig-
nals to ªtime-outº (or quit) after several seconds of
transmission ± which may not be long enough for
HomeLinktto pick up the signal during programming.
1 Ð Garage Door Opener
2 Ð Training ButtonUNDERSTANDING THE FEATURES OF YOUR VEHICLE 141
3

INSTRUMENT PANEL AND CONTROLS
CONTENTS
mInstrument Panel And Controls.............166
mInstrument Cluster......................167
mInstrument Cluster Description.............168
mCompass And Trip Computer Ð If Equipped . . . 180
NControl Buttons......................181
NTrip Conditions.......................182
NCompass/Temperature Display...........182
mElectronic Vehicle Information Center (EVIC) Ð
If Equipped...........................184NElectronic Vehicle Information Center (EVIC)
Displays............................186
NOil Change Required...................187
NTrip Functions.......................188
NCompass Display.....................189
NTelephone Ð If Equipped...............191
NPersonal Settings (Customer Programmable
Features)...........................193
mRadio General Information................196
NRadio Broadcast Signals.................1964

NTwo Types Of Signals..................196
NElectrical Disturbances..................196
NAM Reception.......................197
NFM Reception........................197
mSales Code REQ Ð AM/FM Stereo Radio And
6±Disc CD/DVD Changer (MP3/WMA AUX
Jack)................................197
NOperating Instructions - Radio Mode.......198
NOperation Instructions - (Disc Mode For CD
And MP3/WMA Audio Play, DVD-Video)....206
NNotes On Playing MP3/WMA Files........208
NList Button (Disc Mode For MP3/WMA
Play)..............................210
NInfo Button (Disc Mode For MP3/WMA
Play)..............................210mSales Code RES Ð AM/FM Stereo Radio With
CD Player (MP3 AUX Jack)................213
NOperating Instructions - Radio Mode.......213
NOperation Instructions - CD Mode For CD
And MP3 Audio Play..................219
NNotes On Playing MP3 Files.............221
NList Button (CD Mode For MP3 Play).......224
NInfo Button (CD Mode For MP3 Play).......224
mSales Code RER Ð AM/FM/CD/DVD Radio
With Navigation System Ð If Equipped.......225
NOperating Instructions Ð Satellite Radio.....226
NClock Setting Procedure.................226
mSatellite Radio (RSC) Ð If Equipped
(RER/REQ/REN Radios Only).............227
164 INSTRUMENT PANEL AND CONTROLS

NSystem Activation.....................227
NElectronic Serial Number/Sirius Identification
Number (ENS/SID)....................228
NSelecting Satellite Mode.................228
NSatellite Antenna......................228
NReception Quality.....................228
NOperating Instructions - Satellite Mode......229
NOperating Instructions - Hands Free Phone
(If Equipped)........................231
NOperating Instructions - Video Entertainment
System (VESŸ) (If Equipped).............231mVideo Entertainment System (Sales Code XRV) Ð
If Equipped...........................231
mRemote Sound System Controls Ð If Equipped . . 233
NRadio Operation......................233
NCD Player..........................234
mCD/DVD Disc Maintenance...............234
mClimate Controls.......................235
NManual Air Conditioning And Heating
System.............................235
NOperating Tips.......................239
INSTRUMENT PANEL AND CONTROLS 165
4

INSTRUMENT PANEL AND CONTROLS
1 Ð Air Outlet 6 Ð Glove Box 11 Ð Hazard Warning Flasher
2 Ð Instrument Cluster 7 Ð Climate Control 12 Ð * Electronic Stability Control /
Traction Control Switch
3 Ð Storage Tray8 Ð * Heated Seat Switch 13 Ð Cigar Lighter / Power Outlet
4 Ð Center Air Outlet9 Ð * Rear Park Assist Switch 14 Ð Storage Bin
5 Ð Radio 10 Ð Passenger Airbag Disable Light * Ð If Equipped 166 INSTRUMENT PANEL AND CONTROLS