All vehicle wheels and tires must be the same size and
type and tires must be properly inflated to produce
accurate signals for the computer.
Anti-Lock Brake Light
The ABS light monitors the Anti-Lock Brake Sys-
tem. The light will come on when the ignition
switch is turned to the ON position and may stay on for
as long as four seconds.
If the ABS light remains on or comes on while driving, it
indicates that the Anti-Lock portion of the brake system
is not functioning and that service is required. However,
the conventional brake system will continue to operate
normally if the BRAKE warning light is not on.
If the ABS light is on, the brake system should be serviced
as soon as possible to restore the benefits of Anti-Lock
brakes. If the ABS light does not come on when the
Ignition switch is turned to the ON position, have the
bulb repaired as soon as possible.If both the Brake Warning Light and the ABS Light
remain on, the Anti-Lock brakes (ABS) and Electronic
Brake Force Distribution (EBD) systems are not function-
ing. Immediate repair to the ABS system is required.POWER STEERING
The standard power steering system will give you good
vehicle response and increased ease of maneuverability
in tight spaces. The system will provide mechanical
steering capability if power assist is lost.
If for some reason the power assist is interrupted, it will
still be possible to steer your vehicle. Under these condi-
tions, you will observe a substantial increase in steering
effort, especially at very low vehicle speeds and during
parking maneuvers.
NOTE:Increased noise levels at the end of the steering
wheel travel are considered normal and do not indicate
that there is a problem with the power steering system.
STARTING AND OPERATING 283
5
TCS (Traction Control System)
This system monitors the amount of wheel spin of each
driven wheel. If wheel spin is detected, brake pressure is
applied to the slipping wheel(s) and engine power is
reduced to provide enhanced acceleration and stability.
BAS (Brake Assist System)
This system complements the Anti-Lock Brake System
(ABS) by optimizing the vehicle braking capability dur-
ing emergency braking maneuvers. This system detects
an emergency braking situation by sensing the rate and
amount of brake application and then applies optimum
pressure to the brakes. This can help reduce braking
distances.
Applying the brakes very quickly results in the best BAS
assistance. To receive the benefits of this system, you
must apply continuous brake pedal pressure during thestopping sequence. Do not reduce brake pedal pressure
unless braking is no longer desired. Once the brake pedal
is released, the BAS is deactivated.
WARNING!
The BAS (Brake Assist System) cannot prevent the
natural laws of physics from acting on the vehicle,
nor can it increase the traction afforded by prevailing
road conditions. The BAS cannot prevent accidents,
including those resulting from excessive speed in
turns, driving on very slippery surfaces, or hydro-
planing. Only a safe, attentive, and skillful driver can
prevent accidents. The capabilities of a BAS-
equipped vehicle must never be exploited in a reck-
less or dangerous manner that could jeopardize the
user’s safety or the safety of others.
286 STARTING AND OPERATING
Figure out the weight on the front and rear of the vehicle
separately. It is important that you distribute the load
evenly over the front and rear axles.
Overloading can cause potential safety hazards and
shorten useful service life. Heavier axles or suspension
components do not necessarily increase the vehicle’s
GVWR.
Loading
To load your vehicle properly, first figure out its empty
weight, axle-by-axle and side-by-side. Store heavier items
down low and be sure you distribute their weight as
evenly as possible. Stow all loose items securely before
driving. If weighing the loaded vehicle shows that you
have exceeded either GAWR, but the total load is within
the specified GVWR, you must redistribute the weight.
Improper weight distribution can have an adverse effect
on the way your vehicle steers and handles and the way
the brakes operate.A loaded vehicle is shown in the illustration. Note that
neither the GVWR nor the GAWR capacities have been
exceeded.
STARTING AND OPERATING 329
5
Ensure nylon tubing in these areas has not melted or
collapsed.
Inspect all hose connections such as clamps and cou-
plings to make sure they are secure and no leaks are
present.
Components should be replaced immediately if there is
any evidence of wear or damage that could cause failure.
Fuel System
The Electronic Fuel Injection high-pressure fuel system’s
hoses and quick connect fittings have unique material
characteristics that provide adequate sealing and resist
attack by deteriorated gasoline.
You are urged to use only the manufacturer’s specified
hoses with quick connect fittings, or their equivalent in
material and specification, in any fuel system servicing. It
is mandatory to replace any damaged hoses or quick
connect fittings that have been removed during service.Care should be taken with installing quick connect
fittings to ensure they are properly installed and fully
connected. See your authorized dealer for service.
Brake System
In order to assure brake system performance, all brake
system components should be inspected periodically.
Suggested service intervals can be found in the Mainte-
nance Schedule in Section 8.
WARNING!
Riding the brakes can lead to brake failure and
possibly an accident. Driving with your foot resting
or riding on the brake pedal can result in abnormally
high brake temperatures, excessive lining wear, and
possible brake damage. You wouldn’t have your full
braking capacity in an emergency.
MAINTAINING YOUR VEHICLE 371
7
Master Cylinder - Brake Fluid Level Check
Check the fluid level in the master cylinder immediately
if the brake system warning light indicates system fail-
ure.
Check the fluid level in the master cylinder when per-
forming underhood services.
Clean the top of the master cylinder area before removing
the cap. Add fluid to bring the level up to the top of the
“FULL” mark on the side of the master cylinder reservoir.
Overfilling of fluid is not recommended because it may
cause leaking in the system.
Add enough fluid to bring the level up to the require-
ments described on the brake fluid reservoir. With disc
brakes, fluid level can be expected to fall as the brake
pads wear. However, low fluid level may be caused by a
leak and a checkup may be needed.Use only manufacturer’s recommended brake fluid. Re-
fer to “Fluids, Lubricants, and Genuine Parts” in this
section for the correct fluid type.
WARNING!
•Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts and the
brake fluid catching fire.
•Use of a brake fluid that may have a lower initial
boiling point, or is unidentified as to specification,
may result in sudden brake failure during hard
prolonged braking. You could have an accident.
Use only brake fluid that has been in a tightly closed
container to avoid contamination from foreign matter or
moisture.
MAINTAINING YOUR VEHICLE 373
7
About Your Brakes....................279,281
ABS (Anti-Lock Brake System)............281,285
Adding Engine Coolant (Antifreeze).......... 367
Adding Fuel........................... 324
Adding Washer Fluid..................134,364
Additives, Fuel......................... 323
Adjustable Pedals....................... 136
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 356
Air Conditioner Maintenance............... 360
Air Conditioning.....................245,247
Air Conditioning Controls................. 245
Air Conditioning Filter.................254,361
Air Conditioning, Operating Tips............ 255
Air Conditioning Refrigerant.............360,361
Air Conditioning System.............245,247,360
Air Pressure, Tires....................171,301
Airbag................................ 48
Airbag Deployment..................... 54,58
Airbag Light..................... 55,60,75,167Airbag Maintenance....................... 60
Airbag, Side.......................... 49,56
Airbag, Window (Side Curtain)............. 49,56
Alarm, Panic............................ 22
Alarm (Security Alarm)................. 18,171
Alarm System (Security Alarm)............... 18
Alignment and Balance................... 307
Alterations/Modifications, Vehicle............. 7
Antenna, Satellite Radio................... 231
Antifreeze (Engine Coolant)...........366,367,395
Disposal............................ 369
Anti-Lock Brake System (ABS)............281,285
Anti-Lock Warning Light...............173,283
Anti-Theft Security Alarm (Theft Alarm)........ 18
Anti-Theft System....................... 171
Appearance Care........................ 375
Arming Theft System (Security Alarm)......... 18
Assistance Towing........................ 98
Audio Systems (Radio).................194,213
418 INDEX
Brake System........................281,371
Anti-Lock (ABS)....................281,285
Fluid Check.......................373,397
Hoses.............................. 372
Master Cylinder....................... 373
Parking............................. 279
Warning Light.....................169,281
Brakes.............................281,371
Brake/Transmission Interlock............... 268
Break-In Recommendations, New Vehicle........ 72
Brightness, Interior Lights.................. 131
Bulb Replacement.....................388,389
Bulbs,Light .......................... 76,388
Calibration, Compass..................... 184
Capacities, Fluid........................ 395
Caps, Filler
Fuel................................ 324
Oil (Engine).......................... 354Radiator (Coolant Pressure)............... 368
Car Washes............................ 376
Carbon Monoxide Warning............... 74,324
Cargo (Vehicle Loading)................... 327
Catalytic Converter...................... 357
CD (Compact Disc) Player...............194,213
Cellular Phone..................... 85,213,214
Certification Label....................... 327
Chains, Tire............................ 307
Chart, Tire Sizing........................ 293
Check Engine Light (Malfunction Indicator
Light) ................................ 350
Checking Your Vehicle For Safety............. 73
Checks, Safety........................... 73
Child Restraint.................. 63,64,65,68,70
Child Restraint Tether Anchors............. 67,68
Child Safety Locks........................ 30
Clean Air Gasoline....................... 321
420 INDEX
Auto Unlock.......................... 29
Automatic Door........................ 28
Child Protection........................ 30
Door................................ 26
Power Door........................... 28
Low Tire Pressure System.................. 311
Lower Anchors and Tether for CHildren
(LATCH)............................ 67,68
Lubrication, Body....................... 363
Lumbar Support........................ 119
Maintenance Free Battery.................. 358
Maintenance, General..................... 352
Maintenance Procedures................... 352
Maintenance Schedule.................... 400
Maintenance, Sunroof..................... 151
Malfunction Indicator Light (Check Engine) . . 173,350
Manual, Service......................... 413
Map/Reading Lights..................130,141Master Cylinder (Brakes).................. 373
Methanol............................. 322
Mini-Trip Computer...................... 178
Mirrors ................................ 81
Automatic Dimming..................... 82
Electric Powered....................... 84
Electric Remote........................ 84
Exterior Folding........................ 83
Heated.............................. 84
Outside.............................. 82
Rearview............................. 81
Vanity ............................... 85
Modifications/Alterations, Vehicle............. 7
Monitor, Tire Pressure System............... 311
Mopar Parts.........................351,412
MP3 Player.........................194,213
MTBE/ETBE........................... 322
Multi-Function Control Lever............... 129
INDEX 429
10