ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine in
your vehicle.
Drive moderately during the first 300 mi (500 km). After
the initial 60 mi (100 km), speeds up to 50 or 55 mph (80
or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration, within the
limits of local traffic laws, contributes to a good break-in.
Wide-open throttle acceleration in low gear can be detri-
mental and should be avoided.
The engine oil installed in the engine at the factory is a
high-quality energy-conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur. For
the recommended viscosity and quality grades, refer to
ªMaintenance Proceduresº in Section 7. NON-
DETERGENT OR STRAIGHT MINERAL OILS MUST
NEVER BE USED.A new engine may consume some oil during its first few
thousand miles (kilometers) of operation. This should be
considered as a normal part of the break-in and not
interpreted as an indication of difficulty.
SAFETY TIPS
SAFETY CHECKS YOU SHOULD MAKE INSIDE
THE VEHICLE
Seat Belts
Inspect the belt system periodically checking for cuts,
frays, and loose parts. Damaged parts must be replaced
immediately. Do not disassemble or modify the system.
Front seat belt assemblies must be replaced after a
collision. Rear seat belt assemblies must be replaced after
a collision if they have been damaged (bent retractor, torn
webbing, etc.). If there is any question regarding belt or
retractor condition, replace the belt.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 93
2
recommends engine oils that are API certified and meet
the requirements of DaimlerChrysler Material Standard
MS-6395.
American Petroleum Institute (API) Engine Oil
Identification Symbol
This symbol means that the oil has
been certified by the American
Petroleum Institute (API). The
manufacturer only recommends
API Certified engine oils.
Engine Oil Viscosity (SAE Grade) Ð 3.3L & 3.8L
Gasoline Engines
SAE 5W-20 engine oil is recommended for all operating
temperatures. This engine oil improves low temperaturestarting and vehicle fuel economy. Your engine oil filler
cap also shows the recommended engine oil viscosity for
your vehicle.
For information on engine oil filler cap location, refer to
the Engine Compartment illustration in this section.
Lubricants which do not have both, the engine oil certi-
fication mark and the correct SAE viscosity grade num-
ber should not be used.
Engine Oil Viscosity (SAE Grade) Ð 4.0 Liter
Engines
SAE 10W-30engine oil is preferred for all operating
temperatures. The engine oil filler cap also shows the
recommended engine oil viscosity for your vehicle.
Lubricants which DO NOT have both, the engine oil
certification mark and the correct SAE viscosity grade
number should not be used.
MAINTAINING YOUR VEHICLE 443
7
Memory Seat........................104,155
Mini-Trip Computer...................238,244
Mirrors............................... 100
Automatic Dimming.................... 100
Electric Remote.....................102,103
Exterior Folding....................... 102
Memory............................. 155
Outside............................. 102
Rearview............................ 100
Vanity.............................. 101
Modifications/Alterations, Vehicle............. 7
Monitor, Tire Pressure System............... 369
Mopar Parts.........................440,503
MP3 Player.........................280,283
Multi-Function Control Lever............... 166
Navigation Radio........................ 283
Navigation System....................... 283
New Vehicle Break-In Period................ 93Occupant Restraints...................55,72,75
Occupant Restraints (Sedan)...........68,70,72,74
Odometer............................. 229
Oil Change Indicator................230,237,243
Oil Change Indicator, Reset...........230,237,243
Oil, Engine.........................441,487
Capacity............................ 486
Change Interval....................... 442
Checking............................ 441
Disposal............................ 444
Filter............................444,487
Filter Disposal........................ 444
Identification Logo..................... 443
Materials Added to..................... 444
Recommendation...................442,486
Synthetic............................ 444
Viscosity..........................443,486
Onboard Diagnostic System..............437,438
Opener, Garage Door (HomeLinkt) ........... 185
INDEX 519
10
