Page 303 of 402
WHAT TO DO IN EMERGENCIES
CONTENTS
Hazard Warning Flasher..................302
If Your Engine Overheats.................302
Automatic Transaxle Overheating...........304
Jacking And Tire Changing................304
▫Jack Location........................305
▫Spare Tire Stowage....................305
▫Preparations For Jacking................305▫Jacking Instructions....................306
Jump-Starting Procedures Due To A Low
Battery..............................310
Freeing A Stuck Vehicle..................312
Towing A Disabled Vehicle................313
▫With Ignition Key.....................313
▫Without The Ignition Key...............314
6
Page 306 of 402

WARNING!
A hot engine cooling system is dangerous. You or
others could be badly burned by steam or boiling
coolant. You may want to call a service center if your
vehicle overheats. If you decide to look under the
hood yourself, refer to “Maintenance”, Section 7 of
this manual. Follow the warnings under the Cooling
System Pressure Cap paragraph.
AUTOMATIC TRANSAXLE OVERHEATING
During sustained high speed driving or trailer towing up
long grades on hot days, the automatic transaxle oil may
become too hot.
If this happens, the transmission overheat in-
dicator light will come on, and the vehicle will
slow slightly until the automatic transaxle
cools down enough to allow a return to therequested speed. If the high speed is maintained, the
overheating will reoccur, as before, in a cyclic fashion.
JACKING AND TIRE CHANGING
WARNING!
•Being under a jacked-up vehicle is dangerous. The
vehicle could slip off the jack and fall on you. You
could be crushed. Never put any part of your body
under a vehicle that is on a jack. Never start or run
the engine while the vehicle is on a jack. If you
need to get under a raised vehicle, take it to a
service center where it can be raised on a lift.
•The jack is designed to use as a tool for changing
tires only. The jack should not be used to lift the
vehicle for service purposes. The vehicle should
be jacked on a firm level surface only. Avoid ice or
slippery areas.
304 WHAT TO DO IN EMERGENCIES
Page 307 of 402
Jack Location
The jack and jack-handle are stowed under the load floor
in the cargo area.
Spare Tire Stowage
The compact spare tire is stowed under the rear load floor
in the cargo area.
Spare Tire Removal
Lift up the load floor cover and remove the hold down.
Preparations For Jacking
Park the vehicle on a firm level surface, avoiding ice or
slippery areas,set the parking brakeand place the shift
lever in PARK (automatic transaxle) or REVERSE
(manual transaxle). Turn OFF the ignition.
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off
the road to avoid the danger of being hit when
operating the jack or changing the wheel.
Spare Tire and Jack Stowage
WHAT TO DO IN EMERGENCIES 305
6
Page 308 of 402

•Turn on the Hazard Warning Flasher.
•Block both the front and rear
of the wheel diagonally oppo-
site the jacking position. For
example, if changing the right
front tire, block the left rear
wheel.
•Passengers should not remain in the vehicle while the
vehicle is being jacked.
Jacking Instructions
WARNING!
Carefully follow these tire changing warnings to help prevent
personal injury or damage to your vehicle:
•Always park on a firm, level surface as far from the edge of
the roadway as possible before raising the vehicle.
•Block the wheel diagonally opposite the wheel to be raised.
•Set the parking brake firmly and set an automatic transmis-
sion in park; a manual transmission in reverse.
•Never start or run the engine with the vehicle on a jack.
•Do not let anyone sit in the vehicle when it is on a jack.
•Do not get under the vehicle when it is on a jack.
•Only use the jack in the positions indicated and for lifting
this vehicle during a tire change.
•If working on or near a roadway, be extremely careful of
motor traffic.
•To assure that spare tires, flat or inflated are securely stowed,
spares must be stowed with the valve stem facing the
ground.
•Turn on the Hazard warning flasher.
Jack Warning Label
306 WHAT TO DO IN EMERGENCIES
Page 309 of 402
1. Remove the scissors jack and lug wrench from the
spare wheel as an assembly. Turn the jack screw to the left
to loosen the lug wrench and remove the wrench from
the jack assembly.
2. Loosen, but do not remove, the wheel nuts by turning
them to the left one turn while the wheel is still on the
ground.
CAUTION!
Do not attempt to raise the vehicle by jacking on
locations other than those indicated in Step 3.
Jacking Locations
WHAT TO DO IN EMERGENCIES 307
6
Page 310 of 402

3. There are two front jacking locations and two rear
jacking locations on each side of the body. The front
locations are outlined by two triangular cutouts, the rear
ones by two rectangular cutouts. For vehicles equipped
with plastic trim, the plastic has been cut away to expose
the jacking locations in the body.
Do not raise the vehicle until you are sure the jack is
securely engaged.
4. Turn the jack screw to the left until the jack can be
placed under the jacking location. Once the jack is
positioned, turn the jack screw to the right until the jack
head is properly engaged with the lift area closest to the
wheel to be changed.WARNING!
Raising the vehicle higher than necessary can make
the vehicle less stable. It could slip off the jack and
hurt someone near it. Raise the vehicle only enough
to remove the tire.
5. Using the swivel wrench raise the vehicle by turning
the jack screw to the right. Raise the vehicle only until the
tire just clears the surface and enough clearance is
obtained to install the spare tire. Minimum tire lift
provides maximum stability.
6. Remove the wheel nuts and pull the wheel and wheel
covers, where applicable, off the hub. Install the spare
wheel and wheel nuts with the cone shaped end of the
nuts toward the wheel. Lightly tighten the nuts. To avoid
the risk of forcing the vehicle off the jack, do not tighten
the nuts fully until the vehicle has been lowered.
308 WHAT TO DO IN EMERGENCIES
Page 388 of 402

Brake Assist System.................... 130
Electronic Stability Program............... 131
Traction Control System................. 131
Electronic Speed Control (Cruise Control)...... 126
Electronic Stability Program (ESP)............ 131
Electronic Vehicle Information Center (EVIC).... 175
Emergency, In Case of
Jacking............................. 304
Jump Starting......................... 310
Towing ............................. 313
Emission Control System Maintenance......320,364
Engine............................. 69,318
Break-In Recommendations................ 69
Checking Oil Level..................... 322
Cooling ............................. 335
Exhaust Gas Caution.................... 284
Fuel Requirements..................... 281
Jump Starting......................... 310
Oil ...........................322,360,361Oil Change Interval.................... 324
Oil Filler Cap......................318,324
OilFilter ............................ 361
Oil Selection.......................... 324
Oil Synthetic......................... 325
Operation............................ 69
Overheating.......................... 302
Temperature Gauge..................... 164
Enhanced Accident Response Feature.......... 56
Event Data Recorder...................... 57
Exhaust Gas Caution.............. 35,69,284,334
Exhaust System......................... 334
Fabric Care............................ 348
Filler Location Fuel...................... 164
Filters
Air Cleaner.......................... 328
Engine Fuel.......................... 328
Engine Oil........................325,361
386 INDEX
Page 391 of 402

Ignition............................... 12
Key ................................. 12
Ignition Key Removal..................... 12
Immobilizer (Sentry Key)................. 15,20
Infant Restraint.......................... 60
Information Center, Vehicle................. 175
Inside Rearview Mirror.................... 77
Instrument Cluster....................162,164
Instrument Panel and Controls.............. 161
Instrument Panel Cover................... 350
Instrument Panel Lens Cleaning............. 351
Integrated Power Module (Fuses)............ 351
Interior Appearance Care.................. 349
Intermittent Wipers (Delay Wipers)........... 124
Introduction............................. 4
Jack Location........................... 305
Jack Operation.......................304,306
Jacking Instructions...................... 306Jump Starting.......................... 310
Key, Programming........................ 17
Key, Replacement........................ 17
Key, Sentry (Immobilizer)................... 15
Key-In Reminder......................... 14
Keyless Entry System (Sedan)................ 20
Keys................................. 12
Lane Change and Turn Signals...........171,356
Lap/Shoulder Belts....................... 36
Latches
Hood............................... 115
Lead Free Gasoline...................... 281
LifeofTires ............................ 268
Liftgate (Sedan).......................... 34
Liftgate Window Wiper/Washer............. 152
LightBulbs ............................ 355
Lights .............................. 71,117
INDEX 389
10