2008 Citroen C8 warning

48 II
Note: the electric windows can also be operated for a limited time after the
ignition has been switched off (including after the front doors have been
opened). The front passenger’s electric
window is operated from the
control located on the door.
The 2nd row windows are oper
-
ated from the controls located on
the door pillars.
Electric control
The vehicle’s electric window
switches located on the door can
be operated from the driver’s posi-
tion.
Sequential control
An action on the control to the irst notch causes a window moveme nt which stops as soon as the control is re-
leased. An action on the control to the second notch causes th e window to close or open fully, a further press on
the control stops the movement.
Anti-pinch device
An anti-pinch device stops the window from rising. If it meets a n obstacle, it goes back down.
After a battery disconnection or in the event of a malfunctio n, you have to re-initialise the anti-pinch function:
- Use the control to fully lower the window, then press to ra ise it again. It will rise only a few centimetres.
- Press again on the control until the window is fully closed.
Warning: During this operation, the anti-pinch protection is not work ing.
W I N D O W S

53
II
A U T O M A T I C G E A R B O X
Starting the vehicle
To start the vehicle from position P :
- apply the brake pedal to exit position P,
- select function R, D or M, then
gradually release pressure on
the brake pedal; the vehicle
immediately starts moving. Equally you can start from position
N
:
- Release the handbrake, foot on the brake pedal,
- select function R, D or M, then
gradually release pressure on
the brake pedal; the vehicle
immediately starts moving. WARNING
With the engine idling, brakes
released, if function
R, D or M is
selected, the vehicle moves even
without any acceleration.
For this reason, never allow unsu -
pervised children inside the vehi-
cle when the engine is running.
For any maintenance operation
to be carried out with the engine
running, apply the handbrake and
select position P.

54 II
Operation in automatic mode
Automatic changing between the
4 or 6 gears.
Selector on
D.
The gearbox always selects the
gear best adapted to the following
parameters:
- style of driving,
- route proile,
- vehicle load.
The gearbox then operates in
automatic mode, without requiring
any action on your part.
Notes:
When braking, the gearbox
shifts down automatically to offer
effective engine braking.
The gearbox also enhances
your safety by not changing up
when you lift your foot from the
accelerator abruptly.
To obtain maximum acceleration
without touching the lever, press
rapidly down on the accelerator
pedal (kick down). The gearbox
will automatically change down or
maintain the selected gear up to
maximum engine speed. A U T O M A T I C G E A R B O X
Warning:
- Never select N function if the
vehicle is moving.
- Never select P or R if the vehicle
is not stationary.
- Do not change from one function to another to try to improve
braking on a slippery surface.
If, while the vehicle is moving,
function N is engaged inadvertently,
let the engine idle before engaging
a function that is appropriate. Snow programme
In addition to the automatic
programme, you have this special
programme which facilitates
starting and traction when road
grip conditions are poor.
Press button
, after you have
have started the vehicle and
selected function D;
The gearbox adapts to driving on
slippery roads.
Note:
You can return to the automatic
programme at any time:
Press button
once more to
deactivate the programme en-
gaged.
-speed gearbox (diesel engine):
when the vehicle is stationary
with the gear lever in position
D
(drive), a vibration limiting device
is activated when pressing the
brake pedal.

5
II
Operation :
-
when you engage reverse gear , a sound signal informs you that the system is active. The vehicl e outline
appears on the display. Obstacles located to the rear or in f ront of the vehicle will be detected.
- when moving forward at a speed lower than approx. 6 mph, either in neutral or in gear, the vehicle outline
appears on the display as soon as an obstacle is detected in f ront of the vehicle. Obstacles located in front of the
vehicle will be detected.
Notes :
- The proximity sensors cannot detect obstacles located just below or above the bumpers.
- A thin object such as a spike, a bollard or other similar obje ct, will only be detected at the start of the manoeuvre
but not when the vehicle is up close to it.
- In bad weather and in winter, ensure that the sensors are not covered by dirt, ice or snow.
P A R K I N G A S S I S T A N C E
When engaging reverse gear, a short sound signal foll owed by
a different sound signal accompanied by a message and the lighting
of the SERVICE warning lamp, indicates that there is a malfunc tion.

 III
A C C E S S
The warning lamp relating to the control A conirms 3 statuses :
- lt lashes if the doors are locked with the vehicle stopped an d the engine
switched off.
- It lights up as the doors are locked and when the ignitio n is switched on.
- It goes out if the doors are not locked.
Note: the control A is inactive if the vehicle has been locked by the remote
control or the key.
Anti-theft security
In all cases, as soon as the vehicle is moving at more than 10 km/ h (6 mph)
the tailgate locks automatically.
The tailgate unlocks when a door is opened or when the in terior locking/
unlocking control is actioned.
Anti-intrusion security
After you have started the vehicle, the system automatically locks th e
doors as soon as you reach approx.10 km/h (6 mph).
Note: If a door is opened at any time, it will automatically relo ck as the
vehicle attains approx.10 km/h (6 mph).
Activation / Deactivation of the anti-intrusion security
After you switch on the ignition, give a long press on the central locking but-
ton until you see the display of a message accompan ied by a sound signal.
If you decide to drive with doors locked,
be aware that this will make access more difficult for the emergency services in the event of an accident.
Locking from the inside
With the doors closed, press but -
ton A once to operate the electric
central locking and unlocking.
The doors can still be opened from
inside.
If a door is open or not properly
closed, the central locking does
not operate.
Opening from the outside
To unlock the door from the out -
side, either put the key in the lock
and turn it or unlock using the re -
mote control.
Pull the door handle towards you.
Opening from the inside
Pull the lever towards you.
Note: if a door is not properly
closed and the vehicle is moving
at over 10 km/h (approx. 6 mph),
the Service warning lamp lights up
for a few seconds, accompanied
by a sound signal and a messa -
ge.

1
23
4
6
7
5
72 III
M A N U A L A I R C O N D I T I O N I N G
1 - Air distributionAir low to the face level vents.
To the footwells.
Distribution to the face vents and to the
passenger footwells.
Air low to the windscreen and side win -
dows.
2 - Recirculation of interior air
Recycled interior air (warning lamp on).
This position serves to keep out any exterior odours or fumes that may be disagreeable. It should be can-
celled as soon as possible to permit the renewal of air insid e the cabin and to prevent misting.
3 - Heater blower control
The air blower operates only when the engine is running. T o obtain optimum comfort inside the vehicle, do
not leave the control in the OFF position. Distribution to the windscreen, side win-
dows and footwells.
Control panel

73
III
M A N U A L A I R C O N D I T I O N I N G
4 - Air conditioning (Warning lamp on = in operation)
The air conditioning can function only when the engine i s running. Press on the button located on the das-
hboard.
To obtain air conditioning, the air blower control 3 should not be in the zero position.
Conditioned air is obtained by a mixing of warm air with ref rigerated air. The “blown air temperature adjust-
ment” control 5 allows you to adjust the conditioned air provided control 4 is operational.
5 - Adjusting the air conditioning temperature
The MAX position simultaneously triggers the air conditioning and th e air recirculation in order to cool the
interior of your vehicle more rapidly.
As soon as the air recirculation is longer necessary it should be swi tched off by pressing button 6 or by
moving away from the MAX position, so as to permit air renewal in the passenger compart ment.
6 - Rear screen demisting
Can operate only when the engine is running.
A press on the control activates the electric demisting of the re ar screen and the rear view mirrors.
Goes out automatically in order to avoid excessive consumption of power.
One press stops the demisting.
Press again to restore operation.
Note: If the engine is stopped before demisting is completed, th e latter will resume as soon as the engine
is started again.
7 - Visibility programme (max. button)
To demist or deice the windows rapidly (because of humidity, n umerous passengers, frost, etc.), select the
visibility programme.
The warning lamp for this programme will come on.

A
110 IV Air ilter
Follow the recommendations
in the Maintenance Guide.
When working under the bonnet, the cooling fan could
operate if the power unit is hot (even when switched off).
The engine oil level should be checked frequently
between services (as recommended by the manufacturer), as well as before long journeys.
Engine coolant
The coolant level should
be between the
MAX and
MIN marks on the header
tank.
If the engine is hot, wait
15 minutes.
Quality: Consult the Maintenance
Guide.
Never work on the cooling
system if the engine is hot. (See
“Levels”). Engine oil
Check the oil level with the
vehicle parked on horizon-
tal ground, the engine ha-
ving been switched off for at least
15 minutes.
Level: see “Capacities”.
Quality: Consult the Maintenance
Guide. Brake luid
The luid level must be si
-
tuated within the minimum
and maximum marks visi-
ble on the reservoir
Level: See “Levels”.
Quality: Consult the Maintenance
Guide.
If the warning lamp comes on:
stop the vehicle
Power steering oil
For topping up, it is neces-
sary to go to a CITROËN
dealer.
Oil quality: Consult the Mainte-
nance Guide.
Take out the oil dipstick.
The level must be between
the
MAX and MIN marks
on the dipstick
It should never exceed the maximum mark.
L E V E L S
R e f e r t o t h e c h a p t e r U s e r P r e c a u t i o n s
Windscreen, rear screen
and headlamp washer
luid
It is recommended that you use
products approved by CITROËN.
Level: see “Capacities”.
MAX
MIN