2008 Citroen C4 PICASSO DAG child lock

A
1
212
IN BRIEF
I
13
G E T T I N G S T A R T E D
Adjusting the steering wheel
The steering wheel can be adjusted in terms of height and reach.
Unlock the steering wheel by pull-ing control A towards you.
Adjust the position of the steer-ing wheel then lock it pushing the control back fully.
Automatic photochromic interior rear view mirror
This modifi es its role automatically and progressively between day use and night use.
It can be deactivated using control 1.
Child mirror (2)
This allows you to monitor the rear passengers. It can be folded away to eliminate dazzle.
Rear view mirrors adjustment
This operates with the ignition switched on.
From the driver’s seat, select the rear view mirror by moving control 1 to the left or right, then adjust the rear view mirror as required in the 4 directions using control 2.
Demisting-deicing of the rear view mirrors is linked to that of the rear screen.
Rear view mirrors foldback
When the vehicle is parked, the rear view mirrors can be folded back either manually or automati-cally.For safety reasons, these ad-justments must not be carried out whilst driving.

AC
BA
IN BRIEF
I
21
P A S S E N G E R S A F E T Y
Deactivation of front passenger airbag
1. Insert key into (A).2. Select «OFF» position.3. Remove key.
CHILD SAFETY
Manual control
The rear doors are locked by op-erating the lever (aperture at an angle).
ISOFIX fi xing system
The 3 second-row rear seats and the front passenger seat of your vehicle are fi tted with regu-lation ISOFIX anchoring points, with 3 rings for each seat position (A B C).
This fi xing system is designed for children weighing up to 18 kg.
Electric control
Pressing on the button prohibits operation of the electric windows and opening of the rear doors from the rear of the vehicle.

A
96
III
Electrical control
From the driver’s seat position, the controls siutated on the door enable the vehicle’s electric win-dows to be actioned.
Note : The windows can also be operated for a short time after the ignition has been switched off (including after the front doors have been opened).
Sequential control
An action to the fi rst notch on the control starts a window movement which stops when the control is released. A press for about one second on the control will close or open the window fully, a further press will stop the movement.
PAY ATTENTION TO WHERE CHILDREN ARE WHEN OPERATING THE ELECTRIC WINDOWS.
Always remove the key from the ignition when leaving the vehicle, even for a short time.
When the driver is actioning the controls for the passenger win dows, he must make sure that no-one is obstructing the windows from lo sing properly.
The driver should ensure that the passengers use the windows cor-rectly.
If any person should be at risk of becoming trapped by the operation of the windows, you must reverse the movement of the glass. For t hat, reverse the position of the control concerned.
This is for deactivating operation of the electric windows and opening of the rear doors from the rear seat positions. It is activated by a press on the control A located on the window control panel or by an action on the locks of the rear doors. The warning lamp in the instrument panel comes on temporarily. Each time you switch on the ignition, the warning lamp lights up for a short time.
It is still possible to open the doors from the outside and to operate the rear windows from the front seat positions.
Anti-pinch
An anti-pinch device will stop the glass from rising. If it meet s an obstacle, it goes back down.
After a battery disconnection or following a malfunction, you have to re-initialise theanti-pinch function for each window :
- Use the control to open the window fully, then attempt to close it. It will rise only a few centimetres.
- Pull again on the control until the window closes fully. Once the window is closed, sustain the press on the control for one second.
Warning : During this operation, the anti-pinch protection is inoperat ive.
Child safety
E L E C T R I C W I N D O W S

A
B
12
114
III
LONGITUDINAL ADJUSTMENT
Lift the control A, located at the front of the seat, then adjust the seat into the position desired.
THE “COMFORT” POSITION
The 3 second-row seats are inde-pendent of each other and all the same width. They all can have a “comfort” position.
To place the seat(s) in the comfort position
- Pull on the control B.
The backrest reclines and the seat base pivots slightly.
To return the seat to the initial position
- Pull on the control B and allow the seat to come forwards.
IMPORTANT : Always supervise any movements of seats by children.
REAR HEAD RESTRAINTS
The rear head restraints have two possible positions :
1. a low position for when the seats are not occupied,
2. a high position to ensure pas-senger safety, by raising the restraints to their locking posi-tion.
To lower the head restraints
- Press on the unlocking button.
- Press on the top of the head restraint.
To raise the head restraints
- Pull the head restraint upwards as far as it will go.
- Press on the unlocking button and pull the head restraint up-wards.
S E C O N D R O W S E A T S

C
III
115
Each seat can be folded onto the fl oor to enable you to modify your vehicle’s interior space.
TO FOLD THE SEATS
- Pull fi rmly upwards on strap C, as indicated by the red arrow, to unlock the seat ; maintain the pressure until the seat is fully folded.
- Push the backrest slightly forwards so that the back-rest pivots, folding onto the seat base. The assembly then lowers onto the fl oor.
TO RETURN THE SEATS TO THE UPRIGHT
POSITION
Raise the backrests and push them rearwards so that they lock in position
PLATES BEHIND THE SECOND ROW
SEATS
Plates below the second row seats provide the bottom of the bootspace with rigidity. They automatically fol-low the seat movements (e.g. longitudinal adjustment, folding).
A storage area is available underneath the plates.
IMPORTANT : Always supervise any movements of seats by children.
S E C O N D R O W S E A T S C 4 P I C A S S O

A
B
12
114
III
LONGITUDINAL ADJUSTMENT
Lift the control A, located at the front of the seat, then adjust the seat into the position desired.
THE “COMFORT” POSITION
The 3 second-row seats are inde-pendent of each other and all the same width. They all can have a “comfort” position.
To place the seat(s) in the comfort position
- Pull on the control B.
The backrest reclines and the seat base pivots slightly.
To return the seat to the initial position
- Pull on the control B and allow the seat to come forwards.
IMPORTANT : Always supervise any movements of seats by children.
REAR HEAD RESTRAINTS
The rear head restraints have two possible positions :
1. a low position for when the seats are not occupied,
2. a high position to ensure pas-senger safety, by raising the restraints to their locking posi-tion.
To lower the head restraints
- Press on the unlocking button.
- Press on the top of the head restraint.
To raise the head restraints
- Pull the head restraint upwards as far as it will go.
- Press on the unlocking button and pull the head restraint up-wards.
S E C O N D R O W S E A T S

C
D
E
A
116
III
Each seat can be folded onto the fl oor to form a fl at surface, thus enabling you to modify your vehi-cle’s interior space.
TO FOLD THE SEATS
From the exterior
- Pull fi rmly upwards on strap C, as indicated by the red arrow, to unlock the seat ; maintain the pressure until the seat is fully folded.
- Push the backrest slightly for-wards, so that the backrest piv-ots, folding onto the seat base. The assembly will then lower onto the fl oor.
From the boot (in the loading situation, for example)
You can fold the second-row seat(s) from the boot, having fi rst folded the third-row seats.
- Pull on the control D to unlock the chosen seat, push the back-rest gently forwards.
TO RETURN THE SEATS TO
THE UPRIGHT POSITION
1. Return the second-row seat bases to their initial position and lock them in that position.
2. Raise the backrests and push them rearwards so that they lock in position.
To unlock / lock the rigid plate :
- Slide the latch A on the plate downwards, to unlock.
- Return the plate to the upright position, then slide the latch Aupwards, to lock.
Note : Before deploying the rigid plates, check that the second-row seats are slid as far as possible rearwards. 5-seater confi gurations do not have these rigid plates.
RIGID PLATE
Each second-row seat backrest has a rigid plate attached.
This plate enables you :
- to have a continuous load surface in the boot, whatever the positions of the seats,
- to avoid having objects sliding un-der the second-row seats.
Before moving the third-row seats, return the second-row rigid plates to their initial posi-tion and lock them.
Emergency exit : Should the fi rst system fail (control C), the control D is available for use by third-row passengers to accel-erate their exit.
IMPORTANT : Always super-vise any movements of seats by children.
S E C O N D R O W S E A T S G R A N D C 4 P I C A S S O

III
127
Manual control
The rear doors are locked by op-erating the lever.
When the manual safety is in use, the aperture is at an angle.
Electric operation
The electrical safety is activated by pressing the control located to the rear of the electric windows panel. This prohibits movement of the rear electric windows and opening of the rear passenger doors.
It is still possible to open the doors from the outside, provided the ve-hicle is not locked.Note : with the ignition on, if the child safety is activat-ed for the two rear doors, the warning lamp comes on then goes out again approx. 10 seconds after the engine is started.
When the ignition is switched on, the warn-ing lamp comes on then goes out again approx. 10 seconds after the en-gine is started.
Note : Activation of the function is confi rmed by the temporary light-ing of the warning lamp accompa-nied by a message.
C H I L D S A F E T Y
This system works independ-ently and in no way replaces the central locking controls.
Check the status of the child safety function each time you start the vehicle.
Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of a serious impact, the electrical child safety func-tion is automatically deactivat-ed to allow the rear passengers to exit the vehicle.