Page 21 of 257
24
I
D A S H B O A R D
WARNING LAMPS
LH direction indicator
RH direction indicator
Dipped beam
I f t h i s w a r n i n g l a m p fl a s h e s , it is indicating a malfunctio-ning of the directional hea-dlamps.
Contact a CITROËN dealer.
Sidelamps
Foglamps (rear)
Main beam
Foglamps (front)
The direction indicator lamps all operate simultaneously when the hazard warning is on.
Lighting and signalling lamps
See "Visibility".
Alert warning lamps
Imperative stop warning lamp
When the warning lamp comes on, it is imperative to stop the vehicle and switch off the engine.
Contact a CITROËN dealer.
Warning lamp for handbrake, brake fl u i d l e v e l a n d b r a k i n g distribution fault
When the engine is running, this warning lamp indicates that the handbrake is applied or incomple- t e l y r e l e a s e d , t h a t t h e b r a k e fl u i d l e - v e l i s i n s u f fi c i e n t , o r t h a t t h e b r a k i n g system is malfunctioning.
If the warning lamp remains lit when the handbrake is released, stop immediately and contact a CITROËN the handbrake is released, stop released, stop
Dealer (See "Safety").
Page 104 of 257
97
IX
D R I V I N G
The parking brake is applied, with the vehicle stationary, by pulling on the lever with a force that is proportionate to the steepness of the slope.
To facilitate the action on the lever, you are recommended to press the brake pedal at the same time.
In all circumstances, as a p r e c a u t i o n a r y m e a s u r e , e n g a g e fi r s t gear. For vehicles equipped with an automatic gearbox, ensure that the parking position (P) is selected.
On steep slopes, turn the steering wheel towards the kerb.
To release the handbrake, press on the end of the lever, pull the lever up then lower it fully.
HANDBRAKE
Before leaving the vehicle, make s u r e t h a t t h e p a r k i n g b r a k e i s s u f fi -ciently applied to prevent the vehicle f r o m m o v i n g i f o n a s l o p e , o r i f a c c i -dentally or deliberately pushed.
As an additional precaution on steep slopes:Apply the parking brake.
Engage a gear.Turn the steering wheel towards the kerb (if there is one).
Page 112 of 257
1 0 2
IX
D R I V I N G
Starting the vehicle
- T o s t a r t t h e e n g i n e , t h e g e a r l e v e r has to be in position N.
- F u l l y d e p r e s s t h e b r a k e p e d a l .
- A c t i o n t h e s t a r t e r .
- W i t h t h e e n g i n e r u n n i n g , d e p e n d i n g on your preference place the lever on R, A or M.
- C h e c k t h e p o s i t i o n e n g a g e d o n t h e rev counter.
- R e l e a s e t h e h a n d b r a k e .
- R e l e a s e t h e b r a k e p e d a l a n d accelerate.
If the lever is not in position N, the warning lamp "N" fl a s h e s o n t h e r e v counter.
If the brake pedal is not pressed down, the warning lamp "Foot on brake" fl a s h e s i n t h e i n s t r u m e n t panel.
In both cases, the engine does not start; recommence the above procedure.
Note: If the vehicle has been stationary for a long time, or if you have pressed the brake pedal a number of times while stationary, it will be necessary to press the brake pedal hard down in order to authorise the engine to start.
Stopping the engine
Before switching the engine off, you can choose:
- t o l e a v e t h e v e h i c l e i n n e u t r a l ; f o r that, place the lever in position N,
- t o l e a v e t h e v e h i c l e w i t h a g e a r engaged (R, A or M); for that, place the lever in the position chosen. In this case, the vehicle cannot be moved.
In all cases, it is essential to apply the handbrake.
Before undertaking any operation in the engine compartment, make absolutely sure that the gearbox is in neutral and that the handbrake is on.
Do not hold the vehicle stationary using only the accelerator.
If you are stopped on an incline, use the handbrake to hold the vehicle.
Acceleration
To obtain optimum acceleration (for example to overtake another vehicle), you have only to press the pedal hard down to go beyond the e n d - o f - t r a v e l s w i t c h .