2008 Citroen C CROSSER tyre pressure

S A F E T Y
100
BRAKING ASSISTANCE
SYSTEMS
Group of supplementary systems which
help you to obtain optimum braking
in complete safety in emergency
situations:
- the anti-lock braking system (ABS),
- the electronic brake force distribution (EBFD).
When braking in an emergen-
cy, press very fi rmly without re-
leasing the pressure. The two warning lights comes on at
the same time and the two warnings
are displayed alternately on the
instrument panel display.
When replacing wheels (tyres and
rims), ensure that they conform to the
manufacturer’s recommendations.
Operating fault
If this warning light comes on,
accompanied by the indication on the
instrument panel display, it indicates
a malfunction of the anti-lock braking
system which could result in a loss of
control of the vehicle when braking.
Consult a CITROËN dealer.
If these two warning lights come
on, linked with the warnings on the
instrument panel display, they indicate a
malfunction of the electronic brake force
distribution which could result in a loss of
control of the vehicle on braking.

You MUST stop as soon as it is safe
to do so.
Consult a CITROËN dealer.
Anti-lock braking system
and electronic brake force
distribution
Linked systems which improve the sta-
bility and manoeuvrability of your vehi-
cle when braking, in particular on poor
or slippery surfaces. The warning light comes on for a few
seconds when the ignition is switched
on (ON position). If it does not switch
off or does not come on, contact a
CITROËN dealer.
When the vehicle is stationary
When the vehicle is moving
If this warning light comes
on continuously it indicates
a malfunction of the anti-lock
braking system which could
result in a loss of control of the vehicle
on braking.

You MUST stop as soon as it is safe
to do so.
Consult a CITROËN dealer.
Activation
The anti-lock braking system is active if
the vehicle speed is higher than 6 mph
(10 km/h). It is deactivated when the ve-
hicle speed falls below 3 mph (5 km/h).
The anti-lock braking system comes
into operation automatically when there
is a risk of wheel lock.
Normal operation of the ABS may make
itself felt by slight vibration of the brake
pedal.

D R I V I N G
VII
113
Operating faults
If the selected transmission mode
display fl ashes, the vehicle switches
automatically to front “2WD”

transmission mode.
It is then no longer possible to select the
transmission mode using the control A . Do not subject the vehicle to
excessive conditions while driving.
As the engine torque is applied to
all four wheels, the condition of the
tyres has a considerable impact on
the performance of the vehicle.
Ensure that all four tyres are in good
condition.
Avoid driving the vehicle in sandy
or muddy areas or in other areas in
which the wheels could spin.
Spinning the wheels places the
transmission components under
pressure and could cause a serious
malfunction.
Do not drive the vehicle through
deep water.
Avoid driving over excessively
uneven terrain (risk of scraping
under the body or of grounding on
crossing a bridge).
Have your vehicle towed on
a fl atbed.
The vehicle must not be towed
with the front or rear wheels on the
ground even if it is in front “2WD”
(2 wheel drive) mode.
If the message “SLOW DOWN” is
displayed on the instrument panel, let
the transmission cool down then wait
for the display to clear before setting off
again.
If “4WD” and “LOCK” are displayed al-
ternately and if “MAINTENANCE RE-
QUIRED” is displayed on the instru-
ment panel, the system has failed and
the safety system has been activated.
Contact a CITROËN dealer without
delay.

P R A C T I C A L I N F O R M A T I O N
IX
128
After changing a wheel
When using the “space-saving”
spare wheel, do not exceed a speed
of 50 mph (80 km/h).
Have the tightening of the bolts and
the pressure of the spare wheel
checked by a CITROËN dealer
without delay.
Have the punctured wheel repaired
and replace it on the vehicle as soon
as possible.
Fitting the wheel
List of operations

 Lower the vehicle fully.

 Fold the jack 2 and detach it.
 Lock the anti-theft bolt using the
wheelbrace 1 fi tted with the anti-
theft socket 5 .

 Lock the other bolts using the
wheelbrace 1 only.

 Store the tools (refer to the
paragraph “Access to the tools”).
Fitting snow tyres
If you equip your vehicle with snow
tyres fi tted on steel wheel rims, it
is imperative that special bolts
available from your CITROËN dealer
are used.

 Put the wheel in place on the hub.

 Screw in the bolts by hand to the
stop.

 Pre-tighten the anti-theft bolt using
the wheelbrace 1 fi tted with the anti-
theft socket 5.

 Pre-tighten the other bolts using the
wheelbrace 1 only.

P R A C T I C A L I N F O R M A T I O N
IX
147
TOWING A TRAILER,
CARAVAN, ETC.
Your vehicle is primarily designed for
transporting people and luggage, but it
may also be used for towing a trailer. Driving advice
The maximum towing load on a long
slope depends on the gradient and the
outside temperature.
In all cases, pay attention to the coolant
temperature.
Side wind

 Take into account the increased
sensitivity to side wind.
Cooling
Towing a trailer on a slope increases
the temperature of the coolant.
As the fan is electrically controlled, its
cooling capacity is not dependent on
the engine speed.

 To lower the engine speed, reduce
your speed. Braking
Towing a trailer increases the braking
distance.
Tyres

 Check the tyre pressures of the
towing vehicle and of the trailer,
observing the recommended
pressures.
Lights

 Check the electrical signalling on
the trailer.

If this message is
displayed, stop your
vehicle as soon as it
is safe to do so.
If the message fl ashes
slowly, wait for the engine to cool before
topping up the level, if necessary.
If the message fl ashes rapidly, contact
a CITROËN dealer without delay.
Opening of the lower tailgate
is prohibited if a towbar is
being used.
Driving with a trailer subjects the towing
vehicle to more signifi cant stress and
its driver must be particularly careful.
We recommend the use of
original CITROËN towbars
and their harnesses that have
been tested and approved from the
design stage of your vehicle and that
the fi tting of the towbar is entrusted
to a CITROËN dealer.
If the towbar is not fi tted by a
CITROËN dealer, it is imperative
that it is fi tted using the electrical pre-
equipment located at the rear of the
vehicle and in accordance with the
manufacturer’s instructions.
Towbar suited to the attachment of
a trailer or caravan with additional
signalling and lighting.
Distribution of loads

 Distribute the load in the trailer so
that the heaviest items are as close
as possible to the axle and the nose
weight approaches the maximum
permitted without exceeding it.
Air density decreases with altitude, thus
reducing engine performance. Above
1 000 metres, the maximum towing
load must be reduced by 10 % of the
GTW and so on for every 1 000 metres
of altitude.
Refer to the “Technical Data” section for
details of the weights and towing loads
which apply to your vehicle.

T E C H N I C A L D A T A
X
153

A.
Manufacturer’s plate.
This number is indicated on a plate riveted on the centre pillar, on the
driver’s side.

B.
Serial number under the bonnet.
This number is engraved on the bodywork near the windscreen.

C.
After Sales plate.
This plate is riveted on the inside of the bonnet.

D.
Front number plate.
E.
Tyres / paint label.
This label is affi xed to the passen- ger’s door centre pillar.

It indicates the following information:
- the tyres pressures without load and with load,
- the rim and tyre sizes,
- the pressure of the spare wheel,
- the paint colour reference.

F. Serial number behind the wind-
screen.
This number is engraved on the fas- cia, behind the windscreen.
IDENTIFICATION FEATURES
The tyre pressures must be checked
when cold at least once a month.
Low tyre pressures increase fuel
consumption.