2008 CHRYSLER SEBRING SEDAN key

WARNING!
Fast spinning tires can be dangerous. Forces gener-
ated by excessive wheel speeds may cause axle and
tire damage or failure. A tire could explode and
injure someone. Do not spin your vehicle’s wheels
faster than 30 mph (48 km/h) or for longer than 30
seconds continuously without stopping when you
are stuck, and don’t let anyone near a spinning
wheel, no matter what the speed.
CAUTION!
Racing the engine or spinning the wheels too fast
may lead to transaxle overheating and failure. It can
also damage the tires. Do not spin the wheels above
30 mph (48 km/h). Do not spin the wheels continu-
ously for more than 30 seconds.
TOWING A DISABLED VEHICLE
With The Ignition Key
Front Wheel Drive
Your vehicle may be towed (with all 4 wheels flat on the
ground), under the following conditions: The gear selec-
tor must be in NEUTRAL, the distance to be traveled
must not exceed 15 miles (25 km), and the towing speed
must not exceed 25 mph (40 km/h). Exceeding these
towing limits may cause a transaxle failure. If the trans-
axle is not operative, or if the vehicle is to be towed more
than 15 miles (25 km), the vehicle must be transported
either with a flat bed truck or with the front wheels off
the ground.
All Wheel Drive
Your All Wheel Drive vehicle must be transported on a
flat bed truck.
368 WHAT TO DO IN EMERGENCIES

CAUTION!
•If the vehicle being towed requires steering, the
ignition switch must be in the ON position, not in
the LOCK or ACC position.
•Do not attempt to tow this vehicle from the front
with sling type towing equipment. Damage to the
front fascia will result.
•Do not push or tow this vehicle with another
vehicle as damage to the bumper fascia and trans-
axle may result.
If you must use the accessories (wipers, defrosters, etc.)
while being towed, the key must be in the ON position,
not the ACC position. Make certain the transaxle remains
in NEUTRAL.
WITHOUT THE IGNITION KEY
Special care must be taken when the vehicle is towed
with the ignition in the LOCK position. Flat bed towing
is the preferred towing method. However, if a flat bed
towing vehicle is not available, a wheel lift towing
vehicle may be used. Furthermore, rear towing is not
recommended with the front wheels on the ground, as
transaxle damage can result. If rear towing is the only
alternative, a front end dolly must be used. Proper
towing equipment is necessary to prevent damage to the
vehicle.
TOWING THIS VEHICLE BEHIND ANOTHER
VEHICLE (Flat towing with all four wheels on the
ground)
Flat towing of vehicles equipped with an automatic
transmission, is only permitted within the limitations
described in this section.
WHAT TO DO IN EMERGENCIES 369
6

TOWING THIS VEHICLE BEHIND ANOTHER
VEHICLE WITH A TOW DOLLY
Rear towing is not recommended with the front wheels
on the ground, as transaxle damage can result. If rear
towing is the only alternative, a front end dolly must be
used. Proper towing equipment is necessary to prevent
damage to the vehicle.
Without Power — Override Transaxle Interlock
System
Special care must be taken when the vehicle is towed
with the ignition in the LOCK position. A dolly should be
used under the front wheels if the rear wheels are raised.
Proper towing equipment is necessary to prevent dam-
age to the vehicle.
Battery power is required to release the brake/transaxle
interlock system. There is an override system that allows
you to shift out of PARK in case of loss of power. To
activate the override system:
•Firmly apply the parking brake.
•Insert the ignition key and rotate it to the ON position.
•Remove the cup holder liner.
•Insert a key, screwdriver, or finger into the front hole
then push and hold the manual override release lever
forward.
•While holding the release lever forward, move the
shift lever from Park to Neutral.
•Release the override.
370 WHAT TO DO IN EMERGENCIES

RESET button to turn off the message. If the problem
persists, the message will appear the next time the
vehicle is started. This might indicate a damaged cap. If
the problem is detected twice in a row, the system will
turn on the MIL. Resolving the problem will turn the MIL
light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require an Inspection and Mainte-
nance (I/M), this check verifies the Malfunction
Indicator Light (MIL) is functioning and is not on
when the engine is running, and that the OBD II system
is ready for testing.Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if your vehicle was recently
serviced, recently had a dead battery, or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key-actuated test,
which you can use prior to going to the test station. To
check if your vehicle’s OBD II system is ready, you must
do the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see the MIL symbol come on as part of a normal bulb
check.
378 MAINTAINING YOUR VEHICLE

5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition key or start the engine. This means that
your vehicle’s OBD II system isnot readyand you
shouldnotproceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn OFF the ignition key or start
the engine. This means that your vehicle’s OBD II
system isready, and you can proceed to the I/M
station.
If your OBD II system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD IIsystem to update. A recheck with the above test routine
may then indicate that the system is now ready.
Regardless of whether your vehicle’s OBD II system is
ready or not ready, if the MIL is illuminated during
normal vehicle operation, you should have your vehicle
serviced before going to the I/M station. The I/M station
can fail your vehicle because the MIL is on with the
engine running.
REPLACEMENT PARTS
Use of genuine Moparparts for normal/scheduled
maintenance and repairs is highly recommended to en-
sure the designed performance. Damage or failures
caused by the use of non-Moparparts for maintenance
and repairs will not be covered by the manufacturer’s
warranty.
MAINTAINING YOUR VEHICLE 379
7

Automatic Dimming Mirror................. 86
Automatic Door Locks................... 31,32
Automatic Oil Change Indicator........175,185,434
Automatic Temperature Control (ATC)......... 248
Automatic Transaxle.............. 13,264,270,403
Adding Fluid...................403,404,432
Filter ............................... 405
Fluid and Filter Changes................. 405
Fluid Level Check...................403,404
Interlock System....................... 272
Reset Mode.......................... 275
Selection Of Lubricant................... 432
Shifting ............................. 273
Special Additives...................... 405
Autostick............................. 275
Back-Up Lights......................... 424
BallJoints ............................. 391
Battery............................... 387Gas Caution.......................... 387
Jump Starting......................... 29
Keyless Transmitter Replacement (RKE)....... 25
Location............................ 387
Bearings.............................. 406
Belts,Drive ............................ 384
Body Mechanism Lubrication............... 392
B-Pillar Location........................ 299
Brake Assist System...................... 286
Brake, Parking.......................... 277
Brake System........................281,400
Anti-Lock (ABS)....................... 282
Fluid Check.......................402,432
Hoses.............................. 401
Master Cylinder....................... 402
Parking............................. 277
Warning Light........................ 178
Brakes.............................281,400
Brake/Transmission Interlock............... 272
INDEX 453
10

Heated Seats........................... 126
Heater............................... 243
Heater, Engine Block..................... 269
Hitches
TrailerTowing ........................ 340
HomeLink(Garage Door Opener) Transmitter . . . 144
Hood Prop............................ 131
Hood Release.......................... 130
Hoses................................ 400
Ignition............................... 13
Key ............................... 12,13
Lock................................ 13
Ignition Key Removal..................... 13
Illuminated Entry........................ 20
Immobilizer (Sentry Key)................... 15
Infant Restraint...................... 67,68,69
Information Center, Vehicle................. 183
Inside Rearview Mirror.................... 85Instrument Cluster.................170,171,172
Instrument Panel and Controls.............. 169
Instrument Panel Cover................... 408
Instrument Panel Lens Cleaning............. 410
Integrated Power Module (Fuses)............ 412
Interior Appearance Care.................. 408
Interior Lights.......................... 131
Intermittent Wipers (Delay Wipers)........... 138
Introduction............................. 4
Jack Location........................... 356
Jack Operation.......................356,358
Jacking Instructions...................... 358
Jump Starting.......................... 364
Key, Programming........................ 17
Key, Replacement........................ 16
Key, Sentry (Immobilizer)................... 15
Key-In Reminder......................... 14
460 INDEX

Keyless Entry System...................... 21
Keyless Entry System (Sedan)................ 21
Keys................................. 12
Knee Bolster.......................... 52,53
Lane Change and Turn Signals.............. 179
Lap/Shoulder Belts....................... 42
LATCH (Lower Anchors and Tether for CHildren) . 73
Latches
Hood............................... 130
Lead Free Gasoline...................... 323
LifeofTires ............................ 309
LightBulbs ............................ 417
Lights.............................. 80,131
Airbag........................ 53,65,79,173
Back-Up............................. 424
Brake Warning........................ 178
Bulb Replacement...................... 418
Center Mounted Stop................... 428Daytime Running...................... 134
Electronic Stability Program (ESP) Indicator . . . 287
Engine Temperature Warning.............. 174
Fog ..........................134,179,422
Headlight Switch...................... 132
Headlights........................... 132
Headlights On With Wipers............... 139
High Beam Indicator.................... 182
Illuminated Entry....................... 20
Instrument Cluster..................... 132
Interior............................. 131
License............................. 427
Lights On Reminder.................... 134
Low Fuel............................ 173
Malfunction Indicator (Check Engine)........ 182
Map Reading......................... 131
Oil Pressure.......................... 173
Passing............................. 134
Rear Tail............................ 424
INDEX 461
10