Filter ............................384,430
Filter Disposal........................ 384
Identification Logo..................... 382
Materials Added to..................... 384
Recommendation...................382,429
Synthetic............................ 383
Viscosity..........................383,429
Oil Filter, Change........................ 384
Oil Filter, Selection....................... 384
Oil Pressure Light....................... 173
Onboard Diagnostic System..............377,378
Opener, Garage Door (HomeLink) ........... 144
Operator Manual (Owner’s Manual)............ 4
Overdrive............................. 274
Overheating, Engine...................... 353
Owner’s Manual (Operator Manual)......... 4,447
PaintCare ............................. 406
Panic Alarm............................ 25Parking Brake.......................... 277
Parking On Hill......................... 278
Passing Light........................... 134
Personal Settings........................ 190
Pets.................................. 77
Phone, Cellular.................... 89,225,227
Phone, Hands-Free (UConnect™)........ 89,225,227
Placard, Tire and Loading Information......... 299
Port
Universal Serial Bus (USB).............222,225
USB .............................222,225
Power
Accessory Delay........................ 13
Deck Lid Release....................... 38
Distribution Center (Fuses)............... 412
Door Locks........................... 31
Mirrors .............................. 87
Outlet (Auxiliary Electrical Outlet).......... 154
Seats............................... 124
INDEX 483
10
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle's electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle's electronic systems.
