2008 CHRYSLER CROSSFIRE ECU

NOTE:Do not raise the vehicle until you are sure the
jack is securely engaged, as shown.
3. Holding the jack, insert the cradle under the lifting
points. Crank the handle clockwise until the jack base
meets the ground. Place the jack on firm ground. Position
the jack so that it is always level, even if the vehicle is
240 WHAT TO DO IN EMERGENCIES

vehicle is immediately lowered. To cancel the alarm,
insert the key in the ignition switch or press the TRANS-
MIT button on the key fob.
To prevent triggering the tow-away alarm feature, press
the tow-away alarm switch to turn off the tow-away
alarm before towing the vehicle, or when parking on a
surface subject to movement, such as a ferry or auto train.To do so, turn the key in the ignition switch to the
OFF/LOCK or ACC positions, or remove key from the
ignition switch. Press the upper half of the tow-away
alarm switch. The indicator light will illuminate briefly.
Then, exit the vehicle and lock with a key or the remote
control. The tow-away alarm remains switched off until
the vehicle is locked again with a key or the remote
control, at which time it is automatically reactivated.
CONVERTIBLE TOP EMERGENCY OPERATION
If the convertible top cannot be closed using the convert-
ible top switch, check the following:
²Is the decklid closed properly?
²Is there sufficient battery voltage? Start the engine if
necessary.
²Is the rear cargo compartment divider secured in the
vertical position?
WHAT TO DO IN EMERGENCIES 249
6

3. Unlock the storage compartment by placing the tool
on the bolt between the backrest and the tonneau cover.
Turn the wrench in the direction of the arrow to its stop
and remove the tool.
4. Open the tonneau cover and secure it in the upright
position.5. Pull up hard on the upper section of the convertible
top to move it out of its storage compartment.
NOTE:Do not let go of the convertible top as it may fall
back into the convertible top storage compartment.
6. Move the convertible top toward the windshield
header.
252 WHAT TO DO IN EMERGENCIES

²Maintain a coolant concentration of a minimum of 50%
ethylene glycol Extended Life Coolant and high qual-
ity water with recommended antifreeze for proper
corrosion protection of your engine cooling system
that contains aluminum components.
²Make sure that the radiator and coolant bottle hoses
are not kinked or obstructed.
²Keep the front of the radiator clean. If your vehicle has
air conditioning, keep the front of the condenser clean,
also.
²Do not change the thermostat for Summer or Winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs may
result in unsatisfactory coolant performance, poor fuel
economy, and increased emissions.
Hoses And Vacuum/Vapor Harnesses
Inspect surfaces of hoses and nylon tubing for evidence
of heat and mechanical damage. Hard or soft spots,
brittle rubber, cracking, checking, tears, cuts, abrasions,
and excessive swelling indicate deterioration of the rub-
ber.
Pay particular attention to the hoses nearest to high heat
sources such as the exhaust manifold. Inspect hose rout-
ing to be sure hoses do not touch any heat source or
moving component that may cause heat damage or
mechanical wear.
Ensure the nylon tubing in these areas has not melted or
collapsed. Inspect all hose connections such as clamps
and couplings to make sure they are secure and no leaks
are present. Components should be replaced immedi-
ately if there is any evidence of degradation that could
cause failure.
284 MAINTAINING YOUR VEHICLE

Brakes
In order to assure brake system performance, all brake
system components should be inspected periodically.
Suggested service intervals can be found in the Mainte-
nance section.
WARNING!
Riding the brakes can lead to brake failure and
possibly an accident. Driving with your foot resting
or riding on the brake pedal can result in abnormally
high brake temperatures, excessive lining wear, and
possible brake damage. You wouldn't have your full
braking capacity in an emergency.
Brake and Power Steering System Hoses
When servicing the vehicle for scheduled maintenance,
inspect surface of hoses and nylon tubing for evidence of
heat and mechanical damage. Hard and brittle rubber,cracking, checking, tears, cuts, abrasions, and excessive
swelling suggest deterioration of the rubber. Particular
attention should be made to examining those hose sur-
faces nearest to high heat sources, such as the exhaust
manifold.
Inspect all hose clamps and couplings to make sure they
are secure and no leaks are present.
Ensure the nylon tubing in these areas has not melted or
collapsed.
NOTE:Often, fluids such as oil, power steering fluid,
and brake fluid are used during assembly plant opera-
tions to ease the assembly of hoses to couplings. There-
fore, oil wetness at the hose-coupling area is not neces-
sarily an indication of leakage. Actual dripping of hot
fluid when systems are under pressure (during vehicle
operation) should be noted before a hose is replaced
based on leakage.
MAINTAINING YOUR VEHICLE 285
7

License Plate Light
1. Remove the two lens assembly mounting screws.
2. Pull the bulb out of the socket.
3. Replace the bulb and reattach the lens assembly.
4. Align and resecure the two lens assembly mounting
screws.
NOTE:Be sure not to over-torque the mounting screws
or permanent damage to the lens may occur.
MAINTAINING YOUR VEHICLE 309
7

Service Contract......................... 335
Service Manuals........................ 338
Shift Speeds.........................171,172
Slippery Surfaces, Driving On............... 182
Snow Chains (Tire Chains)................. 219
Snow Tires............................ 220
Soft Top............................... 68
Spark Plugs............................ 268
Specifications........................... 313
Standing Lights.......................... 98
Starting............................... 168
Cold Weather......................... 169
Emergency (Jump Starting)............... 241
Engine Fails to Start.................... 169
Steering
Linkage............................. 275
Power.............................. 196
Storage............................... 311
Storage Bin............................. 80Stuck, Freeing.......................... 244
Sulfur in Gasoline....................... 224
Supplemental Restraint System - Airbag........ 33
Telescoping Steering Column............... 104
Temperature Gauge, Engine Coolant.......... 233
Theft Alarm (Security Alarm)................ 21
Theft System (Security Alarm)............... 21
Tire and Loading Information Placard......... 203
Tire Identification Number (TIN)............. 201
Tire Markings.......................... 198
Tire Safety Information.................... 198
TIREFIT.............................. 234
Tires ..............................207,339
Air Pressure.......................... 208
Alignment and Balance.................. 214
Chains.............................. 219
Changing.........................234,239
General Information.................... 207
350 INDEX

Vehicle Storage......................... 311
Vehicle Theft Alarm (Security Alarm).......... 21
Warnings and Cautions..................... 6
Warranty Information..................... 336
Washer, Adding Fluid..................... 278
Washing Vehicle......................... 291
Water
Driving Through...................... 183
Wheel Alignment and Balance............... 214Wheel and Wheel Trim Care................ 292
Windows
Power............................... 24
Windshield Defroster...................... 62
Windshield Washers...................... 101
Windshield Wiper Blades.................. 276
Windshield Wipers....................... 101
Wiper Blade Replacement.................. 277
Wiring, Ignition (Spark Plug Wires)........... 271
352 INDEX