2008 CHRYSLER 300 warning

[x] Cancel search: warning

Page 123 of 519

CHRYSLER 300 2008 1.G Owners Manual Folding Rear Seat
The rear seatbacks can be folded forward to provide an
additional storage area. Pull on the loops shown in the
illustration to fold down either or both seatbacks. These
loops can be

Page 129 of 519

CHRYSLER 300 2008 1.G Owners Manual Use the hood prop rod (if equipped) to secure the hood in
the open position.To prevent possible damage, do not slam the hood to
close it. Lower the hood, until it is open approximately 6
inches (15 cm

Page 139 of 519

CHRYSLER 300 2008 1.G Owners Manual the wipe interval from a minimum of one cycle every
second to a maximum of approximately 30 seconds
between cycles.
WARNING!
Sudden loss of visibility through the windshield
could lead to an accident.

Page 142 of 519

CHRYSLER 300 2008 1.G Owners Manual The fluid reservoir will hold nearly 1 gallon (4 liters) of
washer fluid when the message “Low Washer Fluid”
appears in the Electronic Vehicle Information Center
(EVIC) — if equipped.
WARNING!
C

Page 144 of 519

CHRYSLER 300 2008 1.G Owners Manual WARNING!
Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around
the washer solution.
TILT/TELESCOPING ST

Page 145 of 519

CHRYSLER 300 2008 1.G Owners Manual To unlock the steering column, pull the control handle
outward. To tilt the steering column, move the steering
wheel upward or downward as desired. To lengthen or
shorten the steering column, pull the

Page 146 of 519

CHRYSLER 300 2008 1.G Owners Manual To tilt the steering column, move the lever up or down as
desired. To lengthen or shorten the steering column, pull
the lever toward you or push the lever away from you as
desired.NOTE:For vehicles eq

Page 149 of 519

CHRYSLER 300 2008 1.G Owners Manual Electronic Speed Control Operation
The speed control lever (located on the right side of the
steering wheel) operated the system.
To Activate:
Push and release the (“ON/OFF”) button lo-
cated on t