To program the new key:
1. Verify that the new key has a
1stamped on it.
2. Insert the already programmed key in the ignition
and start the engine. If the engine will not start, see
your dealer/retailer for service.
3. After the engine has started, turn the key to
LOCK/OFF, and remove the key.
4. Insert the key to be programmed and turn it to the
ON/RUN position within ve seconds of the original
key being turned to the LOCK/OFF position.
The security light will turn off once the key has
been programmed.
5. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you lose or damage your PASS-Key
®III+ key, see
your dealer/retailer or a locksmith who can service
PASS-Key
®III+ to have a new key made.
Do not leave the key or device that disarms or
deactivates the theft deterrent system in the vehicle.
Starting and Operating Your
Vehicle
New Vehicle Break-In
Notice:Your vehicle does not need an elaborate
break-in. But it will perform better in the long run if
you follow these guidelines:
Do not drive at any one constant speed, fast or
slow, for the rst 500 miles (805 km). Do not
make full-throttle starts. Avoid downshifting to
brake or slow the vehicle.
Avoid making hard stops for the rst 200 miles
(322 km) or so. During this time the new brake
linings are not yet broken in. Hard stops
with new linings can mean premature wear and
earlier replacement. Follow this breaking-in
guideline every time you get new brake linings.
Do not tow a trailer during break-in. SeeTowing
a Trailer on page 4-26for the trailer towing
capabilities of your vehicle and more
information.
Following break-in, engine speed and load can be
gradually increased.
2-20
F
Filter
Engine Air Cleaner......................................5-20
Finish Damage.............................................5-102
Flashers, Hazard Warning.................................. 3-6
Flash-to-Pass................................................... 3-9
Flat Tire........................................................5-83
Flat Tire, Changing.........................................5-84
Flat Tire, Storing.............................................5-92
Floor Mats.....................................................2-57
Fluid.............................................................5-21
Power Steering...........................................5-40
Windshield Washer......................................5-41
Fog Lamp
Fog ...........................................................3-17
Fog Lamp Light..............................................3-47
Front Reading Lamps......................................3-18
Front Storage Area.........................................2-56
Fuel............................................................... 5-5
Additives...................................................... 5-7
California Fuel.............................................. 5-6
Filling a Portable Fuel Container....................5-10
Filling the Tank............................................. 5-8
Fuels in Foreign Countries.............................. 5-7Fuel (cont.)
Gage.........................................................3-48
Gasoline Octane........................................... 5-6
Gasoline Speci cations.................................. 5-6
Fuses
Fuses and Circuit Breakers.........................5-105
Rear Underseat Fuse Block.........................5-108
Underhood Fuse Block...............................5-106
G
Gage
Engine Coolant Temperature.........................3-43
Fuel..........................................................3-48
Speedometer..............................................3-34
Tachometer.................................................3-34
Garage Door Opener.......................................2-49
Gasoline
Octane........................................................ 5-6
Speci cations............................................... 5-6
Glove Box.....................................................2-56
GM Mobility Reimbursement Program.................. 7-7
5
