
Opening and closing
40
Malfunction
The comfort access function may malfunction 
due to local radio waves. Then open or close the 
vehicle with the buttons on the remote control 
or with a key. To start the engine following this, 
insert the remote control in the ignition lock.
When unlocking or locking/comfort closing do 
not simultaneously grasp the door handle and 
touch the surfaces, arrow2 or 3. Otherwise, you 
may limit the function.
Replacing battery
If the battery of the remote control is dead, a 
message will appear in the Control Display.
1.Remove integrated key from remote con-
trol, refer to page28.
2.Remove cover.
3.Lay in new battery with positive side facing 
upward.
4.Press cover closed.
Return used battery to a recycling collec-
tion point or to your BMW center.<
Windows
To prevent injuries, exercise care when 
closing the windows and keep them in 
your field of vision until they are shut. 
Always take along the remote control when you 
leave the vehicle, otherwise children could, for 
example, operate the windows and injure them-
selves.<
Opening, closing
>Press switch to resistance point: 
The window continues to open as long as 
you keep the switch pressed.
>Press switch beyond resistance point: 
The window opens automatically. Pressing 
the switch again stops the opening move-
ment.
You can close the windows in the same manner 
by pulling the switch.
Separate switches for the rear windows are 
located in the rear.
For information on using the convenient opera-
tion at the door lock or with the remote control, 
refer to page30 or32.
For information on comfort closing with comfort 
access, refer to page39.
After switching off ignition
You can still operate the windows with the 
remote control removed or the ignition 
switched off for approx. 1 minute, as long as 
neither of the front doors has been opened. 

Controls
 41Reference
At a glance
Driving tips
Communications
Navigation
Entertainment
Mobility
Pinch protection system
If the closing force exceeds a specific value as a 
window closes, the closing action is interrupted 
and the window reopens slightly.
Despite the pinch protection system, 
inspect the window's travel path prior to 
closing it, as the safety system might fail to 
detect certain kinds of obstructions, such as 
thin objects, and the window would continue 
closing. 
Do not install any accessories in the range of 
movement of the windows, otherwise the pinch 
protection system will be impaired.<
Closing without pinch protection 
system
In case of danger from outside or if, for example, 
ice on the window prevents normal closing, pro-
ceed as follows:
1.Pull the switch beyond the resistance point 
and hold. The pinch protection system is 
limited and the window opens slightly if the 
closing force exceeds a certain value.
2.Pull the switch beyond the resistance point 
and hold again within approx. 4 seconds. 
The window closes without the pinch pro-
tection system.
Safety switch
With the safety switch, you can prevent the rear 
windows from being opened or closed via the 
switches in the rear passenger area, by chil-
dren, for example. The LED lights up when this 
safety feature is activated.Always press the safety switch when chil-
dren ride in the rear, otherwise uncon-
trolled closing of the windows could lead to 
injuries.<
Glass sunroof*, electric
The glass sunroof is ready for operation with 
the ignition switched on, refer to page61.
To prevent injuries, exercise care when 
closing the glass sunroof and keep it in 
your field of vision until it is closed. 
Always take along the remote control when you 
leave the vehicle, otherwise children could, for 
example, operate the roof and injure them-
selves.<
Raising
Press the switch. 
The closed glass sunroof is raised and the slid-
ing visor opens slightly.
Do not use force to close the sliding visor 
with the glass sunroof in its raised posi-
tion, otherwise the mechanism will be dam-
aged.<
Opening, closing
>Slide the switch back to the resistance 
point. 
The glass sunroof and the sliding visor open 
together for as long as you hold the switch 
in this position.
>Briefly press the switch back beyond the 
resistance point. 
The glass sunroof and the sliding visor open 
automatically. Briefly pressing the switch 
stops the motion. 

Transporting children safely
58
Sedan
There are three additional mounting points for 
child restraint systems with a tether strap, refer 
to arrows. Fold the corresponding mounting 
point upward before using.
Sports Wagon
Three additional mounting points for child 
restraint systems with a tether strap are pro-
vided under covers in the cargo bay floor, refer 
to arrows. Remove the corresponding covers 
before use.
Placement of tether strap
Make sure that the upper retaining strap 
is not routed over sharp edges and does 
not twist on its way to the upper mounting point; 
otherwise, the belt may not properly secure the 
child restraint system in the event of an acci-
dent.<
Outer rear seat, Sedan
Outer rear seats, Sports Wagon
1Direction of travel
2Head restraints
3Hook of upper retaining strap
4Mounting point
5Rear window shelf/luggage compartment 
floor
6Backrest
7Upper retaining strap of child restraint sys-
tem 

Transporting children safely
60
Safety switch for power windows
Always press the safety switch for the power 
windows, refer to page41, when children are 
riding in the rear of the vehicle. 

Controls
 69Reference
At a glance
Driving tips
Communications
Navigation
Entertainment
Mobility
Windshield washer nozzles
Both windshield washer nozzles are automati-
cally heated with the engine running or the igni-
tion switched on.
Sports Wagon: 
Rear window wiper
1Intermittent mode. When reverse gear is 
engaged, continuous operation is switched 
on automatically
2Cleaning the rear window
Do not use washing mechanisms when 
the washer fluid reservoir is empty, other-
wise you will damage the washer pump.<
Washer fluid
Washer fluid antifreeze is flammable. 
For this reason, keep it away from ignition 
sources and store only in the closed original 
container out of reach of children. Otherwise, 
there is the danger of bodily injury. Always 
observe the instructions for use provided on the 
containers.<
Filler neck for washer fluid
Only add washer fluid with the engine 
cooled down to exclude contact with hot 
engine components. Otherwise there is a dan-
ger of fire and to personal safety if the fluid is 
spilled.
Fill with water and – if required – with a washer 
antifreeze, according to manufacturer's recom-
mendations.
In order to maintain the mixture ratio, mix 
the washer fluid before filling.<
Capacity
Sedan: 
Approx. 3.2 US quarts/3 liters, with headlamp 
washer system
* approx. 5.3 US quarts/5 liters.
Sports Wagon: approx. 5.3 US quarts/5 liters.
Cruise control*
The concept
The cruise control is available for use at speeds 
of approx. 20 mph/30 km/h and higher. The 
vehicle stores and maintains the speed that you 
set using the lever mounted on the steering col-
umn. To maintain the specified speed, the sys-
tem brakes if the engine braking effect is not 
sufficient on a downhill grade. Speed can drop 
on uphill grades if the engine output is insuffi-
cient.
Do not use the cruise control under driv-
ing conditions that do not permit a con-
stant speed, e.g. when driving on winding 
roads, in heavy traffic or in poor road conditions 
such as snow, rain, ice, and loose road surface. 
Otherwise you could loose control of the vehi-
cle and cause an accident.< 

Controls
 81Reference
At a glance
Driving tips
Communications
Navigation
Entertainment
Mobility
1.Open the start menu.
2.Open "Navigation".
Without navigation system
*:
Open "Car Data".
3.Select "Car Data" and press the controller.
4.Select "Trip computer" and press the con-
troller.
>Departure time
>Driving time
>Distance traveled
>Average speed
>Average fuel consumption
Starting or stopping the trip computer, or reset-
ting all values:
1.Select "Set" and press the controller.
2.Select the desired menu item.
3.Press the controller.
Display options
You can display the computer or the trip com-
puter in the assistance window.
1.Move the controller to the right to change to 
the assistance window and press the con-
troller.
2.Select "Onboard info" or "Trip computer".3.Press the controller.
Service requirements
The remaining driving distance and the date for 
the next maintenance are displayed briefly with 
the ignition switched on.
Your BMW Service Advisor can deter-
mine your vehicle's current service 
requirements by reading out the data stored in 
the remote control.<
Additional information
You can select a display of more detailed infor-
mation on the maintenance scope on the Con-
trol Display. For operating principle refer to 
page16.
1.Open the start menu.
2.Press the controller to open the   menu.
3.Select "Info sources" and press the control-
ler.
4.Select "Service Info" and press the control-
ler. 

Technology for comfort, convenience and safety
104 Only clean the cover of the Head-Up Dis-
play with a soft, nonabrasive cloth or with 
a display cleaning cloth; otherwise, you may 
damage it.<
BMW Night Vision*
The concept
BMW Night Vision is a driver assistance system 
that is designed to provide enhanced vision for 
certain objects at night. This can be especially 
helpful for detecting people and larger animals. 
When objects are detected, the driver may be 
able to take appropriate action sooner. For 
example, the driver may identify and detect the 
presence of persons or animals in the road 
ahead or off to the sides and can be more alert, 
slow down or stop, blow the horn etc. The driver 
can decide which actions are appropriate and 
then react accordingly.
A certain area in front of the vehicle is viewed by 
an infrared camera and a generated image is 
shown on the Control Display. The resulting 
thermal image shows the relative heat radiation 
of the objects present in the camera's field of 
view. Warmer objects appear brighter and 
cooler objects appear darker. Contrast is 
dependent on the temperature difference 
between the objects and the background and 
on the amount of heat radiation of the object 
itself. As a result, it is quite possible that a per-
son is not continually recognizable as a person 
in shape, since the thermal radiation can be 
affected by different clothing which blocks heat 
loss. Objects with little temperature difference 
to the surrounding area, or little heat radiation 
are less noticeable, for example in cold weather.Any improvement in detection depends on 
many factors such as the object size and tem-
perature compared to the surroundings, or 
other nearby objects, the visual recognition 
skills of the driver, weather conditions, and 
other factors.
Driving hints
With the system active, periodically but briefly, 
glance at the thermal image on the Control Dis-
play to notice objects that could be people or 
larger animals. The glance should be similar to 
glancing at the rear view mirror. Do not stare at 
the image for long periods while driving, as this 
will remove attention from the road. If you notice 
an object of interest ahead, be prepared to slow 
down or stop, blow the horn, or take other 
appropriate action.
System limits
The system is designed to supplement but not 
replace forward vision through the windshield. 
The driver is responsible for safe driving at 
night. BMW Night Vision is not designed to be 
used as a continuous viewing window for driv-
ing at night.
No system, no matter how sophisticated, can 
operate without limitations. BMW Night Vision 
operation is subject to physical and environ-
mental limitations that will reduce the ability of 
the system to detect and display a clear thermal 
image. Some of the situations in which these 
limitations can occur are:
>on steep hilltops or depressions and in tight 
curves
>in tunnels, as the contrast is inherently low
>when the camera lens is dirty 

Climate
114
Climate
Automatic climate control
1Air directed toward the windshield and side 
windows
2Air for the upper body region, refer to 
Front ventilation on page118
3Air to footwell
4Temperature, left side of passenger 
compartment
5Manual air distribution, driver's side
6Defrosting windows and removing 
condensation
7Manual air volume, switching off automatic 
climate control, residual heat utilization8AUTO program
9Switching cooling function on and off 
manually
10Temperature, right side of passenger 
compartment
11Manual air distribution, front passenger side
12Maximum cooling
13AUC Automatic recirculated-air control/
recirculated-air mode
14LED for residual heat utilization and parked-
car ventilation system
15Rear window defroster