
Notes
6 to the vehicle, compromise its safety, interfere 
with the vehicle's electrical system or affect the 
validity of the BMW Limited Warranty. See your 
BMW center for additional information.<
Maintenance, replacement, or repair of 
the emission control devices and sys-
tems may be performed by any automotive 
repair establishment or individual using any cer-
tified automotive part.<
California Proposition 65 warning
California law requires us to issue the following 
warning:
Engine exhaust and a wide variety of 
automobile components and parts, 
including components found in the interior fur-
nishings in a vehicle, contain or emit chemicals 
known to the State of California to cause cancer 
and birth defects and reproductive harm. In 
addition, certain fluids contained in vehicles and 
certain products of component wear contain or 
emit chemicals known to the State of California 
to cause cancer and birth defects or other 
reproductive harm.
Battery posts, terminals and related accesso-
ries contain lead and lead compounds. Wash 
your hands after handling.
Used engine oil contains chemicals that have 
caused cancer in laboratory animals. Always 
protect your skin by washing thoroughly with 
soap and water.<
Service and warranty
We recommend that you read this publication 
thoroughly.
Your BMW is covered by the following warran-
ties:
>New Vehicle Limited Warranty
>Rust Perforation Limited Warranty
>Federal Emissions System Defect Warranty
>Federal Emissions Performance Warranty
>California Emission Control System Limited 
Warranty
Detailed information about these warranties is 
listed in the Service and Warranty Information 
Booklet for US models or in the Warranty and 
Service Guide Booklet for Canadian models.
Reporting safety defects
For US customers
The following only applies to vehicles owned 
and operated in the US.
If you believe that your vehicle has a defect 
which could cause a crash or could cause injury 
or death, you should immediately inform the 
National Highway Traffic Safety Administration, 
NHTSA, in addition to notifying BMW of North 
America, LLC, P.O. Box 1227, Westwood, New 
Jersey 07675-1227, Telephone 1-800-831-
1117.
If NHTSA receives similar complaints, it may 
open an investigation, and if it finds that a safety 
defect exists in a group of vehicles, it may order 
a recall and remedy campaign. However, 
NHTSA cannot become involved in individual 
problems between you, your dealer, or BMW of 
North America, LLC.
To contact NHTSA, you may call the Vehicle 
Safety Hotline toll-free at 1-888-327-4236 
(TTY: 1-800-424-9153); go to 
http://www.safercar.gov; or write to: Adminis-
trator, NHTSA, 400 Seventh Street, SW., 
Washington, DC 20590. You can also obtain 
other information about motor vehicle safety 
from http://www.safercar.gov 

At a glance
 11Reference
Controls
Driving tips
Communications
Navigation
Entertainment
Mobility
9Instrument cluster12
12Ignition lock59
13Buttons
* on the steering wheel14Horn: the entire surface
15Adjusting the steering wheel53
17Releasing the hood224
18Opening the luggage compartment lid
*
8
Turn signals63
High beams, headlamp 
flasher102
Roadside parking lamps
*102
Computer75
Settings and information about the 
vehicle78
Instrument lighting103
10
Windshield wipers64
Rain sensor
*64
11Switching the ignition on/off and 
starting/stopping the engine59
Telephone
*:
>Press: accepting and ending a 
call, starting dialing
* selected 
phone numbers. Redialing if 
no phone number is selected
>Press longer: redialing
Volume
Changing radio station
Selecting music track
Scrolling through phone book and 
lists with stored phone numbers
Individually programmable54 
Individually programmable54 
16
Cruise control*66
Active cruise control
*67 

Cockpit
12
Instrument cluster
1Speedometer
2Indicator lamps for turn signals
3Indicator and warning lamps13
4Displays for active cruise control
*67
5Tachometer74
6Engine oil temperature75
7Display for
>Clock74
>Outside temperature74
>Indicator and warning lamps838Display for
>Position of automatic transmission
*61
>Computer75
>Date of next scheduled service, and 
remaining distance to be driven79
>Odometer and trip odometer74
>Checking engine oil level
*225
>Settings and information78
> There is a Check Control 
message83
9Fuel gauge75
10Resetting the trip odometer74 

At a glance
 13Reference
Controls
Driving tips
Communications
Navigation
Entertainment
Mobility
Indicator and warning lamps
The concept
Indicator and warning lamps can light up in a 
variety of combinations and colors.
Some lamps are checked for proper functioning 
and thus come on briefly when the engine is 
started or the ignition is switched on.
Explanatory text messages
Text messages at the lower edge of the Control 
Display explain the meaning of the displayed 
indicator and warning lamps.
You can call up more information, e.g. on the 
cause of a malfunction and on how to respond, 
via Check Control, refer to page83.
In urgent cases, this information will be shown 
as soon as the corresponding lamp comes on.
Indicator lamps without text messages
The following indicator lamps notify you that 
certain functions are active:
High beams/headlamp flasher102
Fog lamps
*102
Lamp flashes:
DSC or DTC is regulating the propul-
sive forces in order to maintain driving 
stability90
Parking brake applied60
Canada: parking brake applied60
Engine malfunction with adverse 
effect on exhaust emissions230
Canada: engine malfunction with 
adverse effect on exhaust 
emissions230 

Opening and closing
36 >The indicator lamp goes out after unlocking: 
your vehicle has not been disturbed while 
you were away.
>If the indicator lamp flashes after unlocking 
until the remote control is inserted in the 
ignition, but for no longer than approx. 
5 minutes: your vehicle has been disturbed 
while you were away.
Tilt alarm sensor
The tilt of the vehicle is monitored. The alarm 
system reacts, e.g. to attempts to steal a wheel 
or tow the vehicle.
Interior motion sensor
Coupe
In order for the interior motion sensor to func-
tion properly, the windows and glass roof must 
be completely closed
*.
Convertible
The interior of the car is monitored up to the 
height of the seat cushions. Thus the alarm sys-
tem is activated together with the interior 
motion sensor even if the hardtop is open. The 
alarm can be triggered unintentionally by falling 
objects such as leaves, refer to Avoiding unin-
tentional alarms.
Avoiding unintentional alarms
The tilt alarm sensor and interior motion sensor 
may be switched off at the same time. This pre-
vents unintentional alarms, e.g. in the following 
situations:
>In duplex garages
>During transport on car-carrying trains, 
boats/ships or on a trailer
>When animals are to remain in the vehicle
Switching off tilt alarm sensor and 
interior motion sensor
Press the   button on the remote control 
again as soon as the vehicle is locked.
The indicator lamp lights up briefly and then 
flashes continuously. The tilt alarm sensor and the interior motion sensor are switched off until 
the next time the vehicle is unlocked and subse-
quently locked again.
Convenient access*
Convenient access enables you to enter your 
vehicle without needing to hold the remote con-
trol in your hand. All you need to do is wear the 
remote control close to your body, e.g. in your 
jacket pocket. The vehicle detects the corre-
sponding remote control within the immediate 
vicinity or in the passenger compartment.
Convenient access supports the following 
functions:
>Unlocking/locking the vehicle
>Unlocking the luggage compartment lid 
separately
>Engine starting
>Convenient closure
Functional requirement
>The vehicle or the luggage compartment lid 
can only be locked when the vehicle detects 
that the remote control currently in use is 
outside of the vehicle.
>The vehicle cannot be locked or unlocked 
again until after approx. 2 seconds.
>The engine can only be started when the 
vehicle detects that the remote control cur-
rently in use is inside the vehicle.
Comparison to the standard remote 
control
In general, there is no difference between using 
convenient access or pressing the buttons on 
the remote control to carry out the functions 
mentioned above. You should therefore first 
familiarize yourself with the instructions on 
opening and closing starting on page28.
Special features regarding the use of conve-
nient access are described below.
If you notice a brief delay while opening or 
closing windows, the glass roof or retract-
able hardtop, the system is checking whether a  

Controls
 37Reference
At a glance
Driving tips
Communications
Navigation
Entertainment
Mobility
remote control is inside the vehicle. Please 
repeat the opening or closing procedure, if nec-
essary.<
Unlocking
Grasp the handle on the driver's or front pas-
senger's door completely, arrow 1. This corre-
sponds to pressing the  button.
Locking
Touch the surface, arrow 2, with your finger for 
approx. 1 second. This corresponds to pressing 
the button.
To preserve the battery, please make 
sure that the ignition and all electrical 
consumers are switched off before locking the 
vehicle.<
Coupe: convenient closure
For convenient closure, keep your finger on the 
surface, arrow 2.
Unlocking the luggage compartment 
lid separately
Press the button on the outside of the luggage 
compartment lid. This corresponds to pressing 
the button.
If the vehicle detects that a remote con-
trol has been accidentally left inside the 
locked vehicle's cargo bay after the luggage 
compartment lid is closed, the lid will reopen. 
The hazard warning flashers flash and an 
acoustic signal
* sounds.<
Switching on radio readiness
Radio readiness is switched on by pressing the 
start/stop button, refer to page59.Do not depress the brake or the clutch, 
otherwise the engine will start.<
Starting the engine
You can start the engine or switch on the igni-
tion when a remote control is inside the vehicle. 
It is not necessary to insert a remote control into 
the ignition switch, refer to page59.
Switching off the engine in cars with 
automatic transmission
The engine can only be switched off when the 
selector lever is in position P, refer to page60.
T o  s w i t c h  t h e  e n g i n e  o f f  w h e n  t h e  s e l e c t o r  l e v e r  
is in position N, the remote control must be in 
the ignition switch.
Before driving a vehicle with automatic 
transmission into a car wash
1.Insert remote control into ignition switch.
2.Depress the brake.
3.Move the selector lever to position N.
4.Switch off the engine.
The vehicle can roll.
Malfunction
Convenient access may malfunction due to 
local radio waves. If this happens, open or close 
the vehicle via the buttons on the remote con-
trol or using the integrated key. To start the 
engine afterward, insert the remote control into 
the ignition switch.
Warning lamps
The warning lamp in the instrument 
cluster lights up when you attempt to 
start the engine: the engine cannot 
be started. The remote control is not inside the 
vehicle or is malfunctioning. Take the remote 
control with you inside the vehicle or have it 
checked. If necessary, insert another remote 
control into the ignition switch.
The warning lamp in the instrument 
cluster lights up while the engine is 
running: the remote control is no 
longer inside the vehicle. After the engine is  

Opening and closing
38 switched off, the engine can only be restarted 
within approx. 10 seconds.
The indicator lamp in the instrument 
cluster comes on and a message 
appears on the Control Display: 
replace the battery in the remote control.
Replacing the battery
The remote control for convenient access con-
tains a battery that will need to be replaced from 
time to time.
1.Take the integrated key out of the remote 
control, refer to page28.
2.Remove the cover.
3.Insert the new battery with the plus side fac-
ing up.
4.Press the cover on to close.
Take the old battery to a battery collec-
tion point or to your BMW center.<
Windows
To prevent injuries, watch the windows 
while closing them. 
Take the remote control with you when you 
leave the car, otherwise children could operate 
the electric windows and possibly injure them-
selves.<
Opening, closing
Coupe
>Press the switch to the resistance point:
The window opens as long as you press the 
switch.
>Press the switch beyond the resistance 
point:
The window opens automatically. Press the 
switch again to stop the opening move-
ment.
You can close the windows in the same manner 
by pulling the switch.
Convertible: individually
>Press the switch to the resistance point:
The window opens as long as you press the 
switch.
>Press the switch beyond the resistance 
point:
The window opens automatically. Press the 
switch again to stop the opening move-
ment.
You can close the windows in the same manner 
by pulling the switch. The rear windows do not 
close automatically. 

Opening and closing
42
Opening and closing
When the vehicle is stationary and at radio 
readiness or beyond, refer to page59:
If possible, conserve the battery by only 
operating the retractable hardtop when 
the engine is running.
Before closing the retractable hardtop, remove 
all foreign objects from the windshield frame as 
these could prevent the hardtop from closing 
properly.<
1Pull button: open the retractable hardtop.
Push button: close the retractable hardtop.
2LEDs
The side windows move down slightly 
when the switch for hardtop operation is 
pulled or pushed.<
If you push or pull the switch for a longer period 
after the LED2 goes out, the windows move up 
again.<
LEDs
In the following situations, a message appears 
on the Control Display or an acoustic signal 
sounds in addition to the LED lighting up:
>While the hardtop is being operated, the left 
LED lights up green. It goes out as soon as 
the top is fully opened or closed.
>If the right-hand LED flashes red when you 
release the switch, the opening or closing 
action has not yet finished.
>If the right LED lights up red when the 
switch is pressed, the cargo bay partition is 
folded up, the luggage compartment lid is 
not closed, the vehicle is standing on a 
strong incline or there is a malfunction. The 
retractable hardtop cannot be moved.
Interruption
The automatic sequence of movements is 
interrupted if the switch for hardtop operation is 
released. The sequence can be continued in 
the desired direction by pushing or pulling the 
switch.
A hardtop that is not fully opened or 
closed is a safety hazard.
Do not interrupt and resume the closing proce-
dure several times in close succession as this 
could damage the mechanism.<
If the hardtop is not fully opened or 
closed, the luggage compartment lid can-
not be opened and the windows cannot be 
moved.<
Convenient operation with remote 
control or via door lock
Refer to pages30 and32.
Wind deflector*
The wind deflector keeps air movements in the 
passenger compartment to a minimum when 
the hardtop is open and provides an even more 
comfortable ride, particularly at high speeds.
Installation
The wind deflector is stored in a protective 
cover in the cargo bay. Brief instructions for 
operation can be found on the protective cover.
1.Remove the wind deflector from the protec-
tive cover and unfold it, arrows 1.