2008 AUDI TT Voice

Navigation (NAV) 108Navigation (NAV)General safety precautionsThe driver is completely responsible for traffic safety
even when driving with the Navigation System active.Fig. 111 Display: WarningWhen you set your vehicle in motion and you press the
button, a warning message is shown in the display.
Lesen Sie die Warnmeldung aufmerksam und beachten Sie
die wichtigen Hinweise.
– Select Accept by pressing the control knob when you
have finished reading the warning message.
Be sure that you always have complete control of your vehicle in all
traffic situations when using navigation.
WARNING


Always obey traffic laws, signs and signals, they take prece-
dence over navigation system recommendations.


Always concentrate on driving and pay attention to the road,
listen to the voice prompts and never let yourself be distracted by
the map display on the screen
page 9.


Always remember that data on the Navigation DVD can differ
from the actual situation because of insufficient data or because
the road or traffic routing has changed since the area was
mapped. Do a “reality check” and ignore the navigation system
recommendation if necessary.


Always remember that even if one-way streets, pedestrian
zones, etc. are stored on the Navigation DVD, traffic routing is
subject to constant change. Traffic signals, turning lanes or prohi-
bitions, stop and yield signs, no parking and similar zones as well
as narrow lanes are not covered by the navigation system.


Always adjust your speed to road, traffic and weather condi-
tions and visibility. Never let information about the road ahead
cause you to drive too fast for conditions, for example in fog.


The volume setting should be selected to ensure that outside
signals, such as police and fire truck sirens, are always audible -
danger of accident!
NAV

Navigation (NAV) 110

Route with stopover (Route plan)
Route without stopover (Single destination mode)
In single destination mode you can drive directly to a destination
page 119.
If you enter a direct destination and start guidance, you are given
the option of up to three different routes
page 130.
Route with stopover (Route plan)
In this mode, you can choose up to three stopovers and one final
destination
page 139.
For example, while on your way to your final destination, you could
have three stopovers, such as: the nearest gasoline station, then a
restaurant and after that a point of interest to visit
page 121.
WARNING
Follow the traffic laws for the area in which you are driving. If
driving instructions run contrary to traffic laws, the traffic laws
always take precedent.
Tips
However, the system will not provide you with any information
about the meaning of traffic signs and signals!
How does the Navigation System work?
The Navigation System works with the help of satel-
lites (GPS).To determine current vehicle position, distance sensors, gyroscopes
and satellite signals are analyzed. The signals are transmitted by
GPS satellites. The acronym GPS stands for “Global Positioning
System”.
The recorded information is transferred to the navigation system
a n d t h e n c o m p a re d w i t h t h e m a p m a t e r i a l s to re d o n t h e N a v i g a t io n
DVD. In this way, guidance to your destination can be calculated
precisely.
To c a l c u l a t e g u i d a n c e t o y o u r d e s t i n a t i o n , t h e n a v i g a t i o n D V D h a s t o
be inserted into the navigation drive. The drive for the Navigation
System is located behind the system display
page 35.
When the navigation DVD is inserted, the system starts automati-
cally and navigation destinations can be entered page 117.
Five differe nt languages (German, E nglish, French, Spanish, Italian)
are availabe on the navigation DVD for the audible navigation
prompts. You can change the language for the audible navigation
voice messages using the Menu language function in Setup
page 170.Tips


Snow and other objects on the GPS antenna or screening by
trees and large buildings can interfere with satellite reception and
m a ke i t m o re d i ffe re n t to d e t e rm i n e v e h i c l e l o c a t i o n . I f s e v e ra l s a t e l -
lites are turned off or disabled, this may result in interference with
GPS reception and make it more difficult to determine vehicle loca-
tion.

Navigation (NAV)111
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP


Your map data DVD includes the continental United States
(excluding Alaska), Hawaii and parts of Canada on a single media
allowing for seamless routing across coverage areas.


Street and city names can be changed. For this reason, there may
be exceptions where the names stored on the DVD do not match the
names that have been changed.


Navigation DVDs can be purchased from an Audi dealer. The
dealer can also provide you with information about navigation DVD
updates.


GPS positioning works in only one direction, i.e. the navigation
system receives data to determine vehicle location, but does not
broadcast data.
Navigation route guidanceFig. 113 Navigation: Example of screen in the Navigation System display
Guidance for your route navigation is provided both visually and
acoustically:

with voice messages
page 112


through a screen in the Navigation System display
fig.113
(
page 112)


through a display in the instrument cluster
fig.114
(
page 113)Tips


If the recommended route is not followed, the system will calcu-
late a new route from the current location.


It is also possible to start the navigation in demo mode
page 161 for simulation purposes.
Fig. 114 Navigation:
Example of display in
the instrument cluster

Navigation (NAV) 112Navigation voice guidanceRoute calculation is announced with the voice message “The route
is being calculated”. During this time, “The route is being calcu-
lated” is shown in the Navigation System display and “CALC” is
shown in the instrument cluster display.
When route calculation is complete, guidance is given by spoken
driving instructions and symbols. Driving recommendations are
a l w a y s m a d e w i t h e n o u g h t i m e t o m a k e a t u r n . A n a n n o u n c e m e n t i s
made in different stages in preparation for a change of direction.
Yo u c a n u s e t h e f o l l o w i n g o p t i o n s t o r e p e a t t h e l a s t n a v i g a t i o n v o i c e
message:

Press the Nav-Info control button in the navigation menu
page 150, if you are not in the Nav-Info submenu.

Press the right thumbwheel on the “multi-function steering
wheel with audio operation - version B*”
page 23.
You can choose which language you want for the voice messages
page 170.
WARNING
If driving instructions run contrary to traffic laws, the traffic laws
always take precedence.
Tips


During the announcement of a navigation prompt, you can
adjust the volume of the navigation prompt using the on/off knob
page 19 on the Navigation System or the volume buttons or the
right thumb wheel on the multi-function steering wheel*
page 21
.


If the v ehicle is in a loca tion which c annot be read b y the Naviga-
tion System (parking lot, garage, parking structure), a voice
message will inform you.
Presentation of maps in the Navigation System display
A comprehensive route will be shown graphically on a
map in the display.Fig. 115 Navigation: Example of a map in the Navigation System displayPress the SETUP function button
page 16 in the naviga-
tion menu. The route is visible on a map
fig.115.In addition to route guidance, you can display detailed information
a b o u t y o u r r o u t e o n t h e m a p . S e t t i n g s c a n b e e n t e r e d d i r e c t l y o n t h e

Navigation (NAV)117
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP The following submenus are available in navigation
Setup function:
Main navigation menuEntering a navigation destination
Destinations can be easily entered in various ways.Fig. 121 Navigation: Destination entry menu (main menu)First determined whether you would like to navigate to a final desti-
nation with or without stopovers
page 139. After you have
decided on the type of guidance (with/without stopovers), you can
enter a destination over different routes. Entering destination data
in the entry menu
fig.121 is handled in the same way in single
destination and route planning mode.
Navigation submenus
Press the
function button in
the NAV function page 151
Map scheme (day/night)
Orientation
Map type
Map contents
Voice information
Delete previous destinations
Turn list
Highway info
Intersection map
Auto intersection zoom
Compass
Version information
Demo mode
Set position/direction
SETUP

Navigation (NAV) 130
– Select Start route guidance
page 129, fig.135, the
route is calculated and the map display is shown auto-
matically.
– Select one of the routes suggested in the single destina-
tion mode
page 130 on the map display by rotating
and pressing the control knob.
– In the route plan map display, confirm the route
suggested
page 132 by rotating and pressing the
control knob.After calculating route guidance, the Navigation System switches
a ut o ma t i c a l ly to ma p d i s p l a y m o d e . The ro u t e g u id a n c e i s s h o w n in
simplified form in the instrument cluster display
page 113. You
are additionally receive navigation voice prompts page 112.
When you have entered a final destination
page 119 and started
route guidance, you are offered up to three different routes to reach
your destination
page 119.
When you have entered a route plan and started route guidance,
you are shown the route with the different stopovers and various
information in the overview
page 132.
Entered destinations can be saved
page 135 and
page 137.
Route criteria
page 141 can be changed at anytime during guid-
ance, and the route will be recalculated.
If you do not complete route guidance you started, this route guid-
a n c e wi l l b e c o n t i n u e d t he n e x t t i m e t h e v e h i c l e i s s t a r t e d . Th is a l s o
applies to destinations entered which cannot be reached because of
local conditions (e.g. lake or tourist attraction). If you would like to
terminate this route guidance, select Cancel route guidance
page 132
Tips
Calculated destinations can also be changed in the map display by
moving the crosshairs
page 149
Single destination information before route guidanceFig. 136 Navigation: Example of map display after route has been calculatedWhen you have entered the destination data
page 117
and the road network allows, you are offered up to three
different routes to choose from.
– Select one of the optional routes by rotating the control
knob.

Navigation (NAV)141
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
Route criteria
Route calculation depends on the route criteria
selected.Fig. 148 Navigation: Listing of the possible route criteria–Press the Route control button in the navigation menu.
–Select Route criteria.
– Select the desired route criteria
fig.148.The route criteria can be changed during route guidance and the
route can be recalculated.
You have the following route criteria available to you:
Route options
Using the options fast or short, an especially fast or short route is
taken as the basis for calculating the route.Highway
Comprises the options include and minimize. With Highway
minimize, an attempt is made to avoid sections of freeway when
calculating the route. If the destination is more than 300 km away,
freeways are not avoided.
Ferry
Comprises the options include and minimize. With Ferry minimize
a n a t t e mp t i s m a d e n o t to i n c l u d e a ny s t re t ch w hi ch i n c l ud e s a fe rr y
connection when calculating the route.
To l l r o a d
Comprises the options include and minimize. With To l l r o a d
minimize an attempt is made when calculating the route not to
include any stretch which includes a road which you have to pay to
drive on.
Time restrict.
Comprises the options include and minimize. With roads closed at
certain times of day avoid a n a t t e m p t i s m a d e t o e x c l u d e t h e s e r o a d s
when planning the route. But only the roads closed at certain times
of day identified on the Navigation DVD can be avoided.
Season restrict.
Comprises the options include and minimize. With seasonally
closed roads avoid a n a t t e m p t i s ma d e to e x c l u d e t h e s e ro a d s w h e n
planning the route. But only the seasonally closed roads identified
on the Navigation DVD can be avoided.
Tips
If you would like to avoid a route criterion, but this makes route
guidance impossible, this criterion is still included when calculating
the route. In this case, a voice message will inform you of this.

Navigation (NAV)143
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP the map by light grey lines
f i g .1 4 9 . Th e r e i s n o r o u t e g u i d a n c e f o r
IPD sections, instead you are guided by directional arrows
fig.149. These directional arrows point in the compass direc-
tion/a direct line to the destination.
I f y o u s h o u l d b e s t a r t i n g y o u r r o u t e g u i d a n c e i n a n I P D a r e a , y o u w i l l
initially be guided by directional arrows. As soon as you leave the
IPD area, route guidance will start . In
page 142, fig.149 an
example is shown of a directional arrow in an IPD area.
If your destination should lie in an IPD area, the Navigation System
will guid e you up to the star t of the IPD area. In the IPD area you will
be guided by directional arrows.
If your route guidance includes an IPD area, you will be advised of
this by a voice message when route guidance starts (“It is possible
that there a re un fore seen tra ffic reg ulations on the way to the des ti-
nation.”).
Tips
Route guidance is additionally shown by directional arrows in the
instrument cluster display
page 113 or
page 114. In an IPD
area, the directional arrows in the instrument cluster display point
in the compass direction/a direct line to the destination.
Map and information displayFig. 150 Navigation: Example of map display with inactive side menu
Fig. 151 Navigation: Example of map display with activated turn list
A
A1