2008 Alfa Romeo 8C maintenance

INTRODUCTION
3
IT IS ESSENTIAL THAT
YOU READ THIS MANUAL!
Refuelling
Fuel-powered engines: use only
unleaded fuel with an octane rating
(RON) of not less than 95.
Starting the Engine
Make sure that the electronic parking
brake (EPB) is engaged. Shift the
gearshift lever to neutral (N). Insert
the electronic key in the ignition block
and turn it to MAR. Fully depress the
brake pedal without pressing the
accelerator. Press the START button and
release it as soon as the engine starts.Parking on fl ammable material
During operation, the catalytic muffl er
develops high temperatures. For this
reason, do not park the vehicle on
grass, dry leaves, pine needles or other
fl ammable materials: risk of fi re!
Respecting the environment
The vehicle is equipped with a system
that continuosly monitors the emission-
related components to help ensure
enhanced respect for the environment.
Accessory electrical devices
If you wish to install accessories that
require electric power (which may
gradually discharge the battery),
please contact an Authorised Service
Centre of the Manufacturer’s
Network, where the overall electrical
absorption of the accessories will be
estimated and the vehicle system
checked to verify whether it is capable
of supporting the required load. Code Card
Keep it in a safe place, not in the
vehicle.
Scheduled Maintenance
Proper maintenance will allow you
to preserve the vehicle performance
and safety features over time, ensure
respect for the environment and low
operating costs.
The owner’s manual …
… contains important information,
advice and warnings on proper use and
safe driving, as well as tips to keep
your vehicle in good condition over
time. Pay particular attention to the
following symbols:
- personal safety
- protection of the environment
- proper vehicle condition.

00 800 2532 8200Alfa8Care
INTRODUCTION
5
SERVICE
The information contained in this manual is
limited to those instructions and indications
that are strictly required for the use and good
preservation of the vehicle.
The Owner will certainly obtain greater
satisfaction and the best results from the vehicle
by following these instructions carefully.
We also advise you to have all the maintenance
services and inspections carried out by
the Authorised Service Centres of the
Manufacturer’s Network, where you will fi nd
specialised staff and suitable equipment.
Contact the dedicated Alfa8Care Customer
Number for the location of the Authorised
Service Centres of the Manufacturer’s
Network.“Q-SELECT”
The vehicle may come equipped with a
mechanical gearbox system with dry double-
plate clutch, controlled by an electro-hydraulic
system by means of the paddles on the steering
wheel.
Although the system can be used in “automatic”
mode, “Q-select” should not be considered as an
automatic gearbox. Therefore, for correct use,
carefully follow the instructions in the relative
section of this manual.AUDIO AND IT SYSTEMS
The vehicle is equipped with the following
systems:
- Becker car stereo and CD player with
Bluetooth voice controls and MP3 reader.
- Bose HI-FI system with 8 high-performance
speakers (optional).
- iPod connection (optional).
- 3D pictogram navigation system with route
display (optional).
TOWING THE VEHICLE
The vehicle has not been designed, developed
and homologated to be used as a towing vehicle
for other means (e.g. trailers, caravans, etc.)
and nothing can be loaded on the roof; fi tting
structures such as bars or roof-racks may damage
the vehicle.

1
2
3
4
5
6
7
8
9
VEHICLE IDENTIFICATION DATA
ACTIVE AND PASSIVE SAFETY
INSTRUMENTS AND CONTROLS
BEFORE YOU DRIVE
USING THE VEHICLE
IN AN EMERGENCY
CAPACITIES AND TECHNICAL SPECIFICATIONS
MAINTENANCE
TABLE OF CONTENTS

1VEHICLE IDENTIFICATION DATA
ACTIVE AND PASSIVE SAFETY
INSTRUMENTS AND CONTROLS
BEFORE YOU DRIVE
USING THE VEHICLE
IN AN EMERGENCY
CAPACITIES AND TECHNICAL SPECIFICATIONS
MAINTENANCE
TABLE OF CONTENTS

2VEHICLE IDENTIFICATION DATA
ACTIVE AND PASSIVE SAFETY
INSTRUMENTS AND CONTROLS
BEFORE YOU DRIVE
USING THE VEHICLE
IN AN EMERGENCY
CAPACITIES AND TECHNICAL SPECIFICATIONS
MAINTENANCE
TABLE OF CONTENTS

19
2
ACTIVE AND PASSIVE SAFETY
PRETENSIONERS
To further enhance the seat belt efficiency,
the vehicle seat belts are equipped with ETD
(Emergency Tensioning Device) pretensioners.
These devices “detect”, by means of a sensor,
that a severe collision is occurring and retract the
seat belts by a few centimetres. This way, they
help ensure that the seat belt properly adheres to
the occupant’s body before its restraining action
starts.
The seat belt locking indicates that the device
has activated; a small amount of smoke may be
visible.
This smoke is not toxic and is not indicative of
fire.
The pretensioners activate in the following cases:
- Head-on and rear collisions of a suffi cient
severity
- In certain roll-overs
The pretensioner only activates when the seat
belt is fastened.
After a pretensioner activation, the seat belt can
be unfastened as usual, by pressing the button
on the buckle.The pretensioner does not require any
maintenance or lubrication. Do not tamper with
or modify the pretensioner, as this will affect its
efficiency. If exceptional natural events (floods,
heavy storms, etc.) have caused the device to be
wet in water and mud, you must replace it.
To help ensure optimal protection from the
pretensioners, wear the seat belt in such a way
that it fits snugly against your chest and pelvis.
CAUTION
The pretensioners can be used
only once and activate only when
the seat belts are fastened. If the
pretensioners have been activated,
go to an Authorised Service Centre of
the Manufacturer’s Network to have
them replaced and disposed of. The
units have a 14 year service life from
the date of manufacture; they must be
replaced when their service life is near
to expiry. WARNING: Operations on the vehicle which
involve blows, vibrations or localised heating
(over 100°C for 6 hours max.) in the area of
the pretensioners may damage or activate them:
vibrations due to uneven road surfaces or small
obstacles, such as impacts with kerbs, do not
affect the units. Contact an Authorised Service
Centre of the Manufacturer’s Network if
service operations must be carried out.
CAUTION
Do not tamper with the
pretensioner components. Any
intervention must be carried out only
by qualified and authorised personnel.
Always contact an Authorised Service
Centre of the Manufacturer’s Network.

3VEHICLE IDENTIFICATION DATA
ACTIVE AND PASSIVE SAFETY
INSTRUMENTS AND CONTROLS
BEFORE YOU DRIVE
USING THE VEHICLE
IN AN EMERGENCY
CAPACITIES AND TECHNICAL SPECIFICATIONS
MAINTENANCE
TABLE OF CONTENTS

56
3
Scheduled maintenance (Service)
This function allows you to view when service is
due according to the mileage done.
To view this information, proceed as follows:
- briefl y press the MENU button: the display
shows when service is due in kilometres
or miles depending on the unit that was
previously set (see the chapter “Unit of
measure”);
- press the MENU button briefl y to return to
the menu page or hold it down to return to
the standard screen page.
WARNING: According to the Scheduled
Maintenance Plan, the vehicle must be
serviced every 10,000 km (or 6,000 mi). This
information is automatically displayed when the
electronic key is inserted in the ignition block,
starting from 2,000 km (or 1,200 mi) following
the service due date. The information will be
displayed in kilometres or miles depending on
the unit of measure set. When approaching the
scheduled maintenance (“Service”) due date,
inserting the electronic key in the ignition block,
a message will appear on the display followed
by the kilometres/miles left until the service due
date. Contact an Authorised Service Centre of
the Manufacturer’s Network where the staff
will perform the service operations according to
the Scheduled Maintenance or Annual Inspection
Plan and reset the mileage counter (Reset).
Buzzer reactivation for SBR (Seat Belt
Reminder) signalling (Seat belt beep)(where
provided)
This function is displayed only after the system
has been deactivated by an Authorised Service
Centre of the Manufacturer’s Network.
Automatic activation of the Day Running
Lights (where provided)
If this function is active, when the low-beams go
off, the DRLs come on, and vice versa, when the
low-beams come on the DRLs go off.
Exit menu
Select this item to return to the standard screen
page.