2008 Alfa Romeo 166 engine

24
3 flashes: right rear door
4 flashes: left rear door
5 flashes: volumetric sensors
6 flashes: bonnet
7 flashes: boot
8 flashes: tampering with car starting
cables
9 flashes: tampering with battery cables
or cutting emergency key cables
10 flashes: at least three causes of alarm.WHEN THE ALARM IS
TRIGGERED
When the alarm is engaged it will sound
when:
– One of the doors, the bonnet or the
boot is opened.
– The battery is disconnected or the
electric cables are cut, or the emergency
key cables are cut.
– Intrusion into the passenger compart-
ment, e.g. window being broken (volu-
metric protection).
– Attempt to start the engine (key at
MAR).
Depending on the markets, the trigger-
ing of the alarm will activate the siren
and the hazard warning lights (for about
26 seconds). The methods of operation
and the number of cycles may vary de-
pending on the versions/markets. How-
ever a maximum number of cycles is fore-
seen. Once the alarm cycle has come to
an end the system will return to its nor-
mal monitoring state.
SWITCHING OFF THE ALARM
To switch off the alarm, press the re-
mote control button on the key. If the
alarm does not turn off due to a flat re-
mote control battery or system fault,
open the door after unlocking with the
lock key, then place the key in the igni-
tion switch and turn it to MAR.
To turn on the alarm again, turn the key
toSTOPand remove it, then press the
remote control button after leaving the
car and shutting the doors. If the alarm
does not turn on and the led on the re-
mote control gives only one brief flash
while the led on the dashboard stays on
glowing steadily for about 2 minutes, the
key battery should be replaced by a new
one of the equivalent type on sale c/o
normal retailers. To change the battery
follow the instructions given at paragraph
“Key battery change” on previous pages.
If it is not possible to switch on the
alarm with a new remote control battery,
contact Alfa Romeo Authorised Services
to have the system checked.

26
MINISTERIAL
HOMOLOGATIONS
In keeping with the laws in force in
each country on the subject of radio fre-
quency, we point out that:
– the separate homologation numbers
for each market are given on the last
pages of this handbook before the alpha-
betical index (for some countries also ho-
mologation document);
– for markets in which the transmitter
needs to be marked with the homologa-
tion number, this has been stated on the
component.
(Depending on the versions/markets,
the code may also be marked on the
transmitter and/or on the receiver).
REMOTE CONTROL
DOOR LOCKING
SYSTEM
The system comprises a receiver and a
transmitter (remote control) incorporated
in the key (B-fig. 14). To lock/unlock
the locks, point the transmitter towards
the car, press and release the button
(C). If, when pressing the remote control
push-button (C), the led (A) (where re-
quired) issues just a short flash, replace
the batteries as described in the “The Al-
fa Romeo CODE system” paragraph.
IMPORTANT Should it be necessary
to programme additional remote controls,
contact Alfa Romeo Authorized Services.
IGNITION DEVICE
THE SWITCH (fig. 15)
The switch has four positions:
–STOP: engine switched off, key can
be removed, engine lock engaged, steer-
ing lock engaged, all services excluded a-
part from those powered directly (e.g.
hazard warning light I.C.S. system (ex-
cept climate control).
–ACC: position for using the cigar
lighter and of the I.C.S. system (except
climate control).
–MAR: drive position. The engine
lock is deactivated and all electrical de-
vices are powered.
fig. 14
1015PGSm
fig. 15
1004PGSm

27
IMPORTANTNever leave the key in
this position when the engine is station-
ary.
–AV V: starting the engine.
IMPORTANT If the engine does not
start return the ignition key to the STOP
position and repeat the sequence.
The ignition block is fitted with a safety
device preventing it from being moved to
theAVV position when the engine is al-
ready running.If the ignition device is
tampered with (for ex-
ample during an at-
tempted break-in) have it checked
over by Alfa Romeo Authorized
Services, before travelling again.
STEERING LOCK
Engaging lock:
– move the key to the STOPposition
and remove the key lightly turning the
steering wheel to facilitate the locking ac-
tion.
Releasing the lock:
– turn the key to the MARposition
and gently rock the steering wheel in
both directions.
When leaving the vehicle
always remove the key
from the ignition to prevent any
passenger in the car from inadver-
tently activating the controls.
Never leave children unattended in
a car. Remember to engage the
handbrake and if the vehicle is fac-
ing uphill, first gear and if the ve-
hicle is facing downhill, reverse.
WARNING
Never remove the key
with the car on the
move. The steering wheel would
lock automatically the first time
the steering wheel is turned. This
also occurs if the car is towed.
WARNING
It is absolutely forbidden
to carry out whatever af-
ter-market operation involving
steering system or steering column
modifications (e.g.: installation of
anti-theft Device) that could badly
affect performance and safety,
cause the lapse of warranty and
also result in non-compliance of the
car with homologation require-
ments.
WARNING

53
Deactivation/reactivation takes place
with ignition key at STOPand operating
it in the special key switch on the right-
hand side of the dashboard (fig. 65).
You can reach the switch only if the
door is opened.The key switch (fig. 65) has two posi-
tions:
1)Passenger’s front Air bag active
(ONposition
P) warning light on clus-
ter off; it is absolutely prohibited to carry
children on the front seat.
2)Passenger’s front Air bag deactivat-
ed (OFFposition
F) warning light on
cluster on; it is possible to carry children
protected by special restraint systems on
the front seat.
The
Fwarning light on the instru-
ment cluster glows steadily until the pas-
senger’s Air bag is reactivated.
Deactivation of the front passenger’s Air
bag does not inhibit operation of the side
Air bag.
With the door open the key can be in-
serted and removed in both positions.Operate the switch only
when the engine is not
running and the ignition key is re-
moved.
WARNING
Warning light Findi-
cates also warning light
¬failure. This is indicated by in-
termittent flashing, over 4 sec-
onds, of warning light
F. In this
event, warning light
¬could be
not up to indicate restraint system
failures, if any. Stop the car and
contact Alfa Romeo Authorized
Services to have the system
checked.
WARNING

60
RIGHT-HAND LEVER (fig. 72)
The right-hand lever is used to operate
the windscreen wiper and the windscreen
washer.
The control used to activate the wind-
screen washer also activates the head-
light washers (optional for versions/mar-
kets where applicable). “Follow me home” device
(fig. 71)
This function allows the illumination of the
space in front of the car for the length of
time set, and is activated with the ignition
key at STOPor removed, pulling the left-
hand lever towards the steering wheel.This function is activated pulling the lever
within 2 minutes from when the engine is
turned off. At each single movement of the
lever, the staying on of the dipped beams
and sidelights is extended by 30 seconds up
to a maximum of 3.5 minutes; the lights
switch off automatically after the time set.
Each time the lever is operated, the
1
warning light on the cluster turns on.
This function can be interrupted by keep-
ing the lever pulled towards the steering
wheel for more than 2 seconds.
fig. 72
A0D0015m
A0D0018m
fig. 71

63
STR SYSTEM
(SPORT THROTTLE
RESPONSE)
(optional for versions/markets where
applicable)
The STR system offers the driver the
possibility of brilliant, sporty driving with-
out forsaking relaxing driving in other cir-
cumstances with smoother, more gradual
engine response.
In fact, according to preference, the dri-
ver can choose between sporty fast accel-
eration control and smoother more grad-
ual control, for example in city driving.To engage the sporty response (also
when travelling), press the switch (A-
fig. 76) on the centre console. To pre-
vent this function from being engaged un-
intentionally, the system requires the ac-
celerator pedal to be completely released
for engagement. When the sporty re-
sponse is enabled warning light (B) on
the switch lights up.
To restore the most comfortable re-
sponse press the button again (A) and
completely release the accelerator: the
warning light (B) on the switch goes out.
Whenever the engine is switched on,
the control unit positions on the most
comfortable response. If before switching
off the sporty response was stored, it will
automatically be retrieved releasing the
accelerator pedal after the first accelera-
tion.Automatic engagement
The system allows passing from the s-
tandard map to the sporty one with a
quick press on the accelerator. This func-
tion is useful in all situations, such as for
example overtaking or emergency ma-
noeuvres, where maximum acceleration
is needed.
When the need for maximum power
ceases, the system automatically resumes
the standard map.
A0D0022m
fig. 76

64 CRUISE CONTROL
(fig. 77)(optional for versions/markets
where applicable)
GENERAL DESCRIPTION
The electronic cruise control makes it
possible to drive the car at the required
speed without pressing the accelerator
pedal. This reduces driving fatigue on mo-
torways, especially during long journeys
because the speed memorised is auto-
matically maintained.
IMPORTANT The Cruise Control can
only be engaged with speed over 30
km/h and, just for certain versions up to
180 km/h.
CONTROLS(fig. 78)
The cruise control is controlled by switch
(A), knurled ring (B) and by button (C).Switch (A) has two positions:
–OFFin this position the device is de-
activated;
–ONis the device’s normal operating
position. When the device starts to act on
the engine, the corresponding warning
light on the instrument cluster turns on.
The knurled ring (B) serves to memo-
rise and maintain the car speed or to in-
crease or reduce the speed memorised.
Turn the knurled ring (B) to the (+) po-
sition to memorise the speed reached or
to increase the speed memorised.
Turn the knurled ring (B) to the (–) to
reduce the speed memorised.
The cruise control must
only be activated when
the traffic and the road make it
possible to travel safely at a con-
stant speed for a sufficiently long
time.
WARNING
On vehicles with auto-
matic transmission, nev-
er move the lever to N when the
car is on the move.
WARNING
The device is automatically disengaged
in any one of the following cases:
– pressing the brake pedal;
– pressing the clutch pedal;
– inadvertently moving the automatic
gearshift lever to N.
A0D0024m
fig. 78
A0D0023m
fig. 77

66
Resetting the speed memorised
The memorised speed is automatically
reset:
– turning off the engine;
or
– moving the switch (A) to the OFF
position.
When travelling with the
cruise control engaged,
never move the gearshift lever to
neutral and do not move the au-
tomatic gearshift lever to N.
You are advised to engage the
cruise control only when the traf-
fic and road conditions permit un-
der completely safe conditions, i.e.:
straight, dry road, dual carriage-
way or motorway, flowing traffic
and smooth tarmac. Do not engage
the device in town or in heavy traf-
fic conditions.
WARNING
The Cruise Control can
only be engaged with
speed over 30 km/h and, just for
certain versions up to 180 km/h.
The device must only be engaged
in 4
th, 5thor 6thgear, depending on
the vehicle speed. On cars with
electronic automatic gearbox it
must be engaged only with the
lever at position D in the automatic
mode without then moving the
gearshift lever by hand or with 3
nd
or 4thgear engaged inthe sequen-
tial manual mode.
Moving downhill with the device
engaged, the car speed might be
slightly higher than the speed
memorised due to the change in en-
gine load.
WARNING
Should the device not be
working properly or fail
to operate, move the switch (A-fig.
78) to the OFF Position and contact
Authorized Alfa Romeo Services
after checking that the protection
fuse is intact.
The switch (A-fig. 78) may be left
constantly at ON without damag-
ing the device. You are however
advised to deactivate the device
when not in use, moving the switch
(A) to OFF, to avoid accidentally
memorising the speed.
WARNING