2008 Alfa Romeo 159 tailgate

203
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
Direction indicators/
Taillights/Brake lights
To replace the bulbs proceed as follows:
❒open the tailgate;
❒loosen screw A-fig. 37and remove
the protection cover B;
❒remove the bulb holder unit C-
fig. 38by pressing the retaining
tabsD.
A0E0170mfig. 37
Taillight bulb on tailgate
To replace the bulbs proceed as follows:
❒open the tailgate;
❒turn deviceA-fig. 33 to open lid
B;
❒lower the lid and remove the bulb
holder unit by pressing the retaining
tabsC-fig. 34;
A0E0229mfig. 36
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwisefig. 36:
D: taillight bulb on right/left headlight
❒refit the bulb holder unit securing it
properly using the retaining tabs C-
fig. 34;
❒close lidB-fig. 33.
A0E0040mfig. 38

208
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
IN AN
EMERGENCY
BOOT LIGHT
To change the bulb, proceed as follows:
❒open the tailgate;
❒remove the light unit A-fig. 50lev-
ering in the point shown by the ar-
row;
❒open the protection cover B-fig. 51
and replace the bulb releasing it from
the side contacts making sure that
the new bulb is correctly clamped be-
tween the contacts;
❒re-close the protective cover B;
❒refit the light unit inserting first one
side and then the other one until
hearing the locking click.
❒close protection B-fig. 53on light
unitA-fig. 52;
❒refit the light unit inserting first one
side and then the other one until
hearing the locking click.
A0E0205mfig. 50A0E0075mfig. 52A0E0204mfig. 51
PUDDLE LIGHT
To change the bulb, proceed as follows:
❒open the door and remove lens A-
fig. 52levering in the point shown
by the arrow;
❒raise protectionB-fig. 53and re-
place the snap-fitted bulb;
A0E0235mfig. 53

239
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
CAR
MAINTENANCE
If the car is left inactive
for long periods at cold,
remove the battery and store
it in a warm place to prevent
freezing.
WARNING
When working on the
battery or near it, al-
ways wear the proper gog-
gles.
WARNING
USEFUL ADVICE FOR
LENGTHENING THE LIFE
OF YOUR BATTERY
To avoid draining your battery and
lengthen its life, observe the following
indications:
❒ when you park the car, ensure the
doors, tailgate and bonnet are closed
properly;
❒ the ceiling lights must be off. The car
is however provided with an auto-
matic system for switching off inter-
nal lights;
❒do not keep accessories (e.g.: sound
system, hazard lights, etc.) switched
on for a long time when the engine
is not running;
❒before performing any operation on
the electrical system, disconnect the
battery negative terminal cable;
❒battery terminals shall always be per-
fectly tightened.
IMPORTANTA battery which is kept
at a charge of less than 50% (optical in-
dicator with dark colour without green
area in the middle) for any length of time
will be damaged by sulphation leading to
a reduction in cranking power.

BODYWORK PAINT
IDENTIFICATION LABEL
This is located in the inner side of the
tailgatefig. 4and it includes:
A.Paint manufacturer
B.Name of colour
C.Colour code.
D.Colour code for touching up and re-
spraying.
ENGINE MARKING
Engine marking is stamped on the gear-
box side, on the rear left side.
BODYWORK LABEL
This is located on the passenger com-
partment floor near the front passen-
ger’s seat.
It can be reached by raising cover A-
fig. 3and it includes:
❒type of vehicle (ZAR 939000);
❒Manufacturer’s serial number (chas-
sis number).
251
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
CORRECT USE
OF THE CAR
DASHBOARD
AND
CONTROLS
TECHNICALSPECIFICATIONS
A0A0222mfig. 4A0A0175mfig. 3

SPRAY NOZZLE
If the jet of fluid is inadequate, firstly
check that there is fluid in the reservoir
(see "Checking fluid levels" in section
"Car maintenance").
Then check that the nozzle holes A-
fig. 3are not clogged, if necessary use
a needle to clean them.
277
ALFA 159 SPORTWAGON
A0E0269mfig. 4
A0E0263mfig. 5
A0E0268mfig. 3
BOOT
TAILGATE EMERGENCY
OPENING FROM THE INSIDE
To open the tailgate from the inside if
the battery is flat or the electric tailgate
lock is failing, proceed as follows:
❒tilt the rear seats completely (see
paragraph "Extending the boot" in
section "Dashboard and controls");
❒remove the rear head restraints;
❒take the screwdriver from the tool
container and working inside the
boot (on the rear part), fit it into seat
A-fig. 4and then operate lever B-
fig. 5.

❒remove the bulb holder unit by press-
ing the retaining tabs B-fig. 32;
286
ALFA 159 SPORTWAGON
IF AN EXTERIOR
LIGHT BURNS OUT
For the type of bulb and power rating,
see paragraph “When needing to
change a bulb" in section "In an emer-
gency".
IMPORTANTBefore changing a bulb,
read carefully the instructions given in
section "In an emergency".
REAR LIGHT UNITS
Reversing light/
rear fog lights
To replace the bulbs proceed as follows:
❒open the tailgate;
❒remove cover A-fig. 31working
with a screwdriver in the point indi-
cated by the arrow;
IMPORTANTTo release the inspec-
tion lid, protect the screwdriver tip with
a cloth to prevent scratching.
Mount the child re-
straint system only
with the car stationary. The
Universal Isofix child restraint
system is properly anchored to
the mounting brackets when
clicks are heard. In any case,
keep to the installation in-
structions that must be pro-
vided by the child restraint
system's Manufacturer.
WARNING
At Lineaccessori Alfa Romeo you can
find the "Universal Isofix" "Duo Plus"
child's seat.
For any further detail on installation
and/or use, refer to the “Instructions
Manual” that must be provided by the
child restraint system's Manufacturer.
A0E0292mfig. 31
A0E0293mfig. 32

287
ALFA 159 SPORTWAGON
Taillight bulb on tailgate
To replace the bulbs proceed as follows:
❒open the tailgate;
❒remove the cover A-fig. 31work-
ing in the point shown by the arrow;
❒remove the bulb holder unit by press-
ing the retaining tabs B-fig. 32;
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwise fig. 33:
C: reversing light bulb on passenger
side or right side;
C: rear fog light bulb on driver side or
left side;
❒refit the bulb holder unit securing it
properly using the retaining tabs B-
fig. 32;
❒close cover A-fig. 31.
A0E0294mfig. 33
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwise fig. 33:
D: taillight bulb on right/left headlight
❒refit the bulb holder unit securing it
properly using the retaining tabs B-
fig. 32;
❒close cover A-fig. 31.

288
ALFA 159 SPORTWAGON
Direction indicators/
Taillights/Brake lights
To replace the bulbs proceed as follows:
❒open the tailgate;
❒on certain versions, open the side lid;
❒remove the protection cover by op-
erating device A-fig. 34;
❒remove the bulb holder unit by press-
ing the retaining tabs B-fig. 35;
A0E0296mfig. 35A0E0297mfig. 36
A0E0298mfig. 37
❒remove and replace the burnt-out
bulb by pressing it slightly and turn-
ing it counterclockwise fig. 36:
E: taillight/brake light bulb;
F: direction indicator bulb
❒refit the bulb holder unit securing it
properly using the retaining tabs B-
fig. 35;
❒refit the protection cover.
A0E0295mfig. 34
ADDITIONAL BRAKE LIGHT
(THIRD STOP)
The additional brake light is made up of
LEDs and it is built into the rear spoiler
fig. 37.
Contact Alfa Romeo Authorized Services
to have the third brake light replaced.