2008 Acura RDX lock

When the vehicle speed reaches
about 9 mph (about 15 km/h) or
more, all the doors lock
automatically.With the driver’s door open and the
key in the ignition, both master door
lock switches are disabled. They are
not disabled if the driver’s door is
closed. Pushing the switch down on
the open f ront passenger’s door will
lock all doors and the tailgate.
To lock any passenger’s door when
getting out of the vehicle, pull
backward on the lock tab and close
the door. To lock the driver’s door,
remove the key from the ignition
switch and pull backward on the lock
tab. Then close the door.
The childproof door locks are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK position (lever is
down), the door cannot be opened
fromtheinsideregardlessof the
position of the lock tab. To open the
door, push the lock tab f orward and
use the outside door handle.
You can change the ‘‘AUTO DOOR
LOCK ’’ setting in the multi-
inf ormation display (see page ).
When you shif t to P af ter driving, the
driver’s door unlocks.
You can change the ‘‘AUTO DOOR
UNLOCK’’ setting in the multi-
inf ormation display (see page ).
109101 Childproof Door L ocks
Door L ocks
L ockout Prevent ion
124
LEVER
Lock
\f—\f—\f
y
\f
y
() 
\fy\f
y
2008 RDX

To open the tailgate, press and hold
the switch, then lift up.To close the tailgate, hold the
tailgate handle, lower the tailgate,
then press down on the back edge.
Keep the tailgate closed at all times
while driving to avoid damaging the
tailgate and to prevent exhaust gas
f rom getting into the interior. See
on page
.
The tailgate will lock when you lock
the driver’s door, and will unlock
when you unlock all doors.
You can change the ‘‘DOOR LOCK
MODE’’ setting on the multi-
inf ormation display (see page ).
56
103
Carbon Monoxide Hazard
Tailgate
Inst rument s and Cont rols
125
SWITCH TAILGATE
HANDLE
\f—\f—\f
y
\fy
() 
\fy\f
\fy
2008 RDX

If the power door lock system cannot
unlock the tailgate, unlock it
manually.
Use a small flat-tip screwdriver to
remove the cover on the back of the
tailgate.Pushandholdthereleaseleverto
the right as shown, then push the
tailgate to open it.If you need to unlock the tailgate
manually, it means there is a
problem with the tailgate. Have the
vehicle checked by your dealer.
Unlocking the T ailgate
Tailgate
126
COVER
LEVER
\f—\f—\f
y

y
() 
\fy\f

y
2008 RDX

µµ
µ
When you press the UNLOCK
button, the ceiling lights (if the f ront
and rear ceiling light switches are in
the door activated position) will
come on. If you do not open any door,
the lights stay on for about 30
seconds, then f ade out. If you relock
the doors with the remote
transmitter before 30 seconds have
elapsed, the lights go of f
immediately.
Press this button once to
lock all doors and the tailgate. Some
exterior lights will f lash. When you
push LOCK twice within 5 seconds,
you will hear a beep to verify that the
doors and tailgate are locked and the
security system has set. This button
does not work if any door or tailgate
is not f ully closed.
To change the ‘‘KEYLESS LOCK
ACKNOWLEDGEMENT’’ setting,
see page . Press this button once
to unlock the driver’s door. Push it
twice to unlock the other doors.
Some exterior lights will f lash twice
when you push the button. If you do
not open any door or the tailgate
within 30 seconds, they will
automatically relock.
To change the ‘‘DOOR LOCK
MODE’’ setting, see page .
To change the ‘‘SECURITY
RELOCK TIMER’’ setting, see page . To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page
.
Pressthisbuttonfor
about 1 second to attract attention;
the horn will sound, and the exterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
button on the remote transmitter, or
turn the ignition switch to the ON
(II) position.
105 103
10796
LOCK UNL OCK
PA NIC
Remote Transmitter
Inst rument s and Cont rols
127
UNLOCK
BUTTONLOCK
BUTTON
PANIC
BUTTON
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

To replace the battery:Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
Separate the keypad from the
transmitter by pushing any button
f rom outside.
If it takes several pushes on the
button to lock or unlock the doors
and the tailgate, replace the battery
as soon as possible.
Battery type: CR1616
Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.
1.
2.
Remote Transmitter
Replacing the Transmitter
Battery
Remote Transmitter Care
128
SCREW KEYPAD
\f—\f—\f
y

y
() 
\fy\f
y
2008 RDX

Here are the settings activated with
the remote;
When you unlock the driver’s door
with your remote, each remote
activates the keyless memory
settings related to that remote. The
driver’s ID (MEMORY 1 or
MEMORY 2) is shown on the back
of each remote. To turn of f this f eature, press and
hold the LOCK and UNLOCK
buttonsatthesametime.TheLED
in the remote will blink twice. Then
release the buttons. Doing this
cancels the keyless memory settings
f or that remote.
Driving position memory
(see page ).
To turn the keyless memory settings
back on, repeat this procedure. The
LED will blink once to indicate the
f eature has been turned on.
When you unlock and open the
driver’s door with the remote
transmitter, the driver’s seat (except
the power lumbar feature) and
outside mirrors start to move to the
positions stored in memory. The
indicator in the related memory
button to the remote comes on. 146
K eyless Memory Settings
Remote Transmitter
130
TM
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

µ
To adjust the seat f orward or
backward, pull up on the bar under
the seat cushion’s f ront edge. Move
the seat to the desired position, and
releasethebar.Trytomovetheseat
to make sure it is locked in position.To change the seat-back angle, pull
up on the lever on the outside of the
seat bottom.
Make all seat adjustments bef ore
you start driving.
Once your seat is adjusted correctly,
rock it back and f orth to make sure
the seat is locked in position.
See pages f or important saf etyinf ormation and warnings about how toproperly position the seats and seat-backs. 1213
Front Passenger’s Seat
Adjustments
Seats
132
BAR
LEVER
\f—\f—\f
y
\fy
() 
\fy\f
y
2008 RDX

Move the front seats as far
f orward as possible. Make sure
the front seat-backs are in the
upright positions.
Store the center seat belt buckle
into the pocket in the rear seat-
back.
Lower the head restraints to their
lowest positions.Pull up the release lever on the
outside of the seat-back.
Push the armrest back in place.
Fold the seat-back forward.
Move the front seats backward to
the desired position. Make sure
the f ront passenger’s seat is
locked in place.
Lif t the f ront edge of the rear seat
cushion, then pull up on the rear
of the seat cushion, then f old the
cushion f orward.
1.
2.
3. 4.
5.
6.
7.
CONT INUED
Seats
Inst rument s and Cont rols
137
RELEASE LEVER
BUCKLE
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX