2008 Acura RDX Int time

To open the tailgate, press and hold
the switch, then lift up.To close the tailgate, hold the
tailgate handle, lower the tailgate,
then press down on the back edge.
Keep the tailgate closed at all times
while driving to avoid damaging the
tailgate and to prevent exhaust gas
f rom getting into the interior. See
on page
.
The tailgate will lock when you lock
the driver’s door, and will unlock
when you unlock all doors.
You can change the ‘‘DOOR LOCK
MODE’’ setting on the multi-
inf ormation display (see page ).
56
103
Carbon Monoxide Hazard
Tailgate
Inst rument s and Cont rols
125
SWITCH TAILGATE
HANDLE
\f—\f—\f
y
\fy
() 
\fy\f
\fy
2008 RDX

µµ
µ
When you press the UNLOCK
button, the ceiling lights (if the f ront
and rear ceiling light switches are in
the door activated position) will
come on. If you do not open any door,
the lights stay on for about 30
seconds, then f ade out. If you relock
the doors with the remote
transmitter before 30 seconds have
elapsed, the lights go of f
immediately.
Press this button once to
lock all doors and the tailgate. Some
exterior lights will f lash. When you
push LOCK twice within 5 seconds,
you will hear a beep to verify that the
doors and tailgate are locked and the
security system has set. This button
does not work if any door or tailgate
is not f ully closed.
To change the ‘‘KEYLESS LOCK
ACKNOWLEDGEMENT’’ setting,
see page . Press this button once
to unlock the driver’s door. Push it
twice to unlock the other doors.
Some exterior lights will f lash twice
when you push the button. If you do
not open any door or the tailgate
within 30 seconds, they will
automatically relock.
To change the ‘‘DOOR LOCK
MODE’’ setting, see page .
To change the ‘‘SECURITY
RELOCK TIMER’’ setting, see page . To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page
.
Pressthisbuttonfor
about 1 second to attract attention;
the horn will sound, and the exterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
button on the remote transmitter, or
turn the ignition switch to the ON
(II) position.
105 103
10796
LOCK UNL OCK
PA NIC
Remote Transmitter
Inst rument s and Cont rols
127
UNLOCK
BUTTONLOCK
BUTTON
PANIC
BUTTON
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

Each f ront and rear ceiling light has
a three-position switch.
Front ceiling lights:
In the ‘‘ ’’ position, both f ront
and rear ceiling lights are on all the
time except when the rear ceiling
light switch is in the OFF position.In the ‘‘ ’’ position, both f ront
and rear ceiling lights are of f all the
time.
With the f ront ceiling lights switch in
this position, the rear ceiling light
does not work, and both f ront and
rear ceiling lights do not come on
when you open any door.
Rear ceiling light:
You can use the rear ceiling light
independently. In the OFF position,
the light does not come on even if
the f ront ceiling light switch is in the
‘‘ ’’ position. In the ON position,
the light stays on continuously
except when the f ront ceiling light
switch is in the ‘‘ ’’ position.
CONT INUED
Ceiling L ights
Interior Lights
Inst rument s and Cont rols
149
FrontDOOR ACTIVATED DOOR ACTIVATED
Rear OFF
ON
\f—\f—\f
y
\f

y
() 
\fy\f
y
2008 RDX

Open any door.
Remove the key from the ignition
switch.
Unlock the doors with the key,
locktabonthedriver’sdoor,
master door lock switch, or
remote transmitter.
After all doors are closed tightly, the
light(s) dims slightly, then f ades out
in about 30 seconds. If you do not open any door af ter
unlocking the driver’s door or
removing the key from the ignition
switch, the light(s) f ade out in about
30 seconds. If you leave any door
open without the key in the ignition
switch, the light(s) will go of f af ter 3
minutes.
You can use the f ront ceiling lights
whenever the lights are of f .
To turn a light on or of f , push its lens.
In the door activated position, both
f ront and rear ceiling lights come on
when you:
To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page.
96 Individual Map L ights
Interior Lights
150
LENSES
\f—\f—\f
y
\f
y
() 
\fy\f
y
2008 RDX

The courtesy lights in the ceiling
console come on when the light
switch is in the or theposition. You can adjust their
brightness by turning the Select/
Reset knob on the instrument panel. The cargo area light has a two
position switch. In the OFF (right)
position, the light does not come on.
In the ON (lef t) position, the light
comesonwhenyouopenthetailgate.
Your vehicle also has a courtesy light
in the ignition switch. This light
comesonwhenyou;
Unlock the driver’s door.
Remove the key from the ignition
switch.
Open any door.
The courtesy light in each f ront door
comes on when the door is opened,
and goes out when the door is closed.
After all doors are closed tightly, the
light f ades out in about 30 seconds.
To change the ‘‘INTERIOR LIGHT
DIMMING TIME’’ setting, see page
.
96
Courtesy Lights Cargo Area Light
Interior Lights
Inst rument s and Cont rols
151
COURTESY LIGHTS
ON OFF
\f—\f—\f
y
\fy
() 
\fy\f
y
2008 RDX

To load a single disc:Press and release the LOAD
button on the changer unit. You
will see ‘‘BUSY’’ on the center
display, and the disc load indicator
turns red and starts blinking.
Insert a disc into the disc slot
when the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display at the same time.
Insert the disc only about half way;
the drive will pull it in the rest of
the way. You will see the disc
indicator blinking on the center
display.
To load multiple discs in one
operation:
When the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display again, insert the
next CD in the slot.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
Repeat steps 1 through 3 until all
six positions are loaded. If you are
not loading all six positions, press
the LOAD button again after the
last CD has loaded. ‘‘DISC READ’’
appears on the center display, then
the system begins playing the last
CD loaded.
If you stop loading discs bef ore all
six positions are f illed, the system
will wait f or 10 seconds, stop the load
operation, and begin playing the last
disc loaded.
Press and hold the LOAD button
on the changer unit until you hear
a beep. You will see ‘‘BUSY’’ on
the center display, and disc load
indicator turns red and starts
blinking.
Insert the disc into the disc slot
when the disc load indicator turns
green and ‘‘LOAD’’ appears on the
center display at the same time.
Insert it only half way; the drive
will pull it in the rest of the way.
You will see ‘‘BUSY’’ on the center
display, and the disc load indicator
turns red again and blinks as the
CD is loaded.
Do not try to insert a disc until
‘‘LOAD’’ appears. You could
damage the audio unit.
1.
2.
3.
1.
2. 4.
Audio System
L oading CDs in the Changer
176
\f—\f—\f
y
y
() 
\fy\f

y
2008 RDX

To pause a disc, press the
corresponding number of the
current disc on the appropriate side
of the preset bars. To play the disc
again, press the preset bar again.
If you turn the system of f while a CD
is playing, either with the PWR/VOL
knob or by turning off the ignition
switch, the disc will stay in the drive.
When you turn the system back on,
the CD will begin playing where it
left off.Press and hold the eject button until
you hear a beep to remove all the
discs from the changer.
You can also eject discs when the
ignition switch is of f by pressing the
eject button. The disc that was last
selected is ejected f irst. You can
eject the rest of the discs one at a
time.
For inf ormation on how to handle
and protect compact discs, see page
.
For inf ormation, see page .
For inf ormation, see page .
To remove a dif f erent CD f rom the
changer, select it with the
appropriate side of the preset bar.
When that CD begins playing, press
the eject button.
To take the system out of CD mode,
press the AM or FM, CD/AUX, or
button. To return to CD
mode, press the CD/AUX button.
The system will continue at the same
point that it left off. To remove the disc that is currently
playing, press and release the eject
( ) button. You will see
‘‘EJECT’’ on the center display.
When you remove the disc f rom the
slot, the system begins the load
sequence so you can load another
disc in that position. If you do not
load another CD within 10 seconds,
the system selects the previous
mode (AM, FM1, FM2, or XM
Radio).
If you do not remove the CD f rom
the slot, the system will reload the
CD af ter 10 seconds and put the CD
changer in pause mode. To begin
playing the CD, press the CD/AUX
button.
223
226186
To Pause a Disc
To Stop Playing a Disc
Removing CDs f rom the Changer
Protecting Discs
CD Changer Error Messages
Adjusting the Sound
Audio System
182
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX

µTo tune with the interf ace dial, press
the AUDIO button to view the audio
control display, then push the
selector down, and turn the dial to
TUNE. Then press ENTER on the
selector, and turn the dial to the
desired f requency. To exit the
TUNE mode, press ENTER again.
XM satellite radio inf ormation is
available on page .
You can use any of f ive methods to
f ind radio stations on the selected
band: TUNE, SEEK, SCAN, the
preset buttons or icons, and AUTO
SELECT.
Use the TUNE/FOLDER
bar to tune the radio to a desired
f requency. Press the side of the
bar to tune to a higher f requency,
and the side of the bar to tune
to a lower f requency.
If youpressandholdthe or
side of the bar, the f requency
will begin to change rapidly. It will
stop when you release it.
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the PWR/
VOL knob or the AM/FM button.
Adjust the volume by turning the
PWR/VOL knob.
The band and f requency the radio
waslasttunedtoareshownonthe
upper display. To change bands,
press the AM/FM button. You can
also change bands with the interf ace
dial. Press the AUDIO button to view
the audio control display and the
band changes to FM1, FM2, or AM
each time you push the selector up.
On the FM bands, ‘‘STEREO’’ will be
shown on the audio control display.
‘‘ST’’ will also appear on the upper
display if the station is broadcasting
in stereo. Stereo reproduction on AM
is not available. 211
Audio System
To Select a Station
TUNE
192
TUNE ICON
\f—\f—\f
y
y
() 
\fy\f
y
2008 RDX