Page 21 of 140

24
 Instruments and controls 
  
Warning light     is     
indicates       Solution - action  
 Water in diesel filter   on, accompanied by  
a message on the 
display.    that there is water in the 
diesel fuel filter. 
 Have the filter bled by a  CITROËN dealer . 
Refer to the "Checks" section of chapter 7. 
 Low fuel level   on with the gauge 
needle in zone E.  that the fuel reserve is 
being used.   Fill up with fuel without delay. The evaluation 
of the fuel reserve is a parameter which is 
sensitive to the style of driving, the profile of t
he 
road, the time elapsed and the distance travelled 
since the warning light first came on. 
 Diesel pre-heating   on.   that the weather 
conditions impose 
pre-heating.  Wait for the warning light to switch off before 
operating the starter. 
 Side lights   on.   manual selection.   
Turn the ring on the lights stalk to the first 
position. 
Dipped headlamps
 on. 
 manual selection.  Turn the ring on the lights stalk to the second 
position. 
 Main beam headlamps   pulling of the stalk towards 
you.  Pull the stalk to return to dipped headlamps.  
         
        
        
     
        
        Page 38 of 140

33
1
READY TO SET OFF
Accesses
 OPENING FROM THE OUTSIDE 
 Driver’s door 
  Use the remote control to unlock from the  
outside. 
 Pull the handle towards you. 
   If the remote control does not work, insert 
the metal part of the key in the lock on the 
driver ’s side.  
 Sliding side door 
  Pull the handle towards you then towards  
the rear. 
 
Slide the door fully to secure it in the open 
position (Van) or to trigger the door open 
retaining device (Combi).    
 W h e n   t h e   f u e l   fi   l l e r   fl   a p   i s   o p e n ,   a   s a f e t y   
system checks the sliding of the side door. 
If your vehicle is positioned on a slope, 
guide the sliding side door. The door may 
open or close more quickly when on a slope, 
which could result in injuries.
 As a safety precaution and to guarantee 
correct operation, do not drive with the sliding 
side door open.    Opening to 180° 
   Press the catch while opening the door.   
 Hinged rear doors 
 The 60/40 type asymmetrical hinged rear  
doors have four closing points, including a 
central closing point.    Pull the handle towards you. 
 Start by opening the large hinged door, then 
unlock by pulling the lever to release and 
open the small hinged door. 
 The two hinged doors open to 90°. 
 Driving with the small hinged door open is 
permitted to make the transportation of long 
loads easier. Observe the customary safety 
indications, to attract the attention of other 
drivers.       
         
        
        
     
        
        Page 39 of 140

34
Accesses
Good practice
 When opening, take care not to obstruct the  
guide space on the floor to allow the door to 
slide correctly. 
   Do not block traffic.   
  Load space 
 OPENING FROM THE INSIDE  Sliding side door 
  Pull the handle A towards the rear, slide the 
door fully to secure it in the open position 
(Van) or to trigger the door open retaining 
device (Combi).   
Driver’s door 
 Pull the interior handle to unlock.  
  
Active locking:   When the vehicle 
speed approaches 12 mph (20 km/h), a 
characteristic locking noise indicates that 
your vehicle has been locked automatically. 
   This "AUTOCLOSE" function is activated or 
deactivated via the "MENU". 
   This function is deactivated when the vehicle 
is delivered.  
Hinged rear doors
 To open, slide the control B to the right.  
  If your vehicle is positioned on a  
slope, guide the sliding side door. The 
door may open or close more quickly 
when on a slope, which could result in 
injuries. 
 
For safety and practical reasons, do not 
drive with the sliding side door open.  
Press once to unlock the sliding 
side doors and the rear doors 
(Van) from the cab.      
         
        
        
     
        
        Page 41 of 140
36
Accesses
  Sliding side door (Combi) 
 Press on the control to release the door and 
pull the handle towards yourself to reclose 
the door.  
   Child lock  
 This prevents the opening from inside of 
each of the rear doors.   
F   Turn the control for each rear door by a 
quarter turn using the ignition key.    
 CLOSING FROM THE OUTSIDE  
  Sliding side door 
 Pull the handle towards you, then towards 
the front to secure it in the open position 
(Van) or to trigger the door open retaining 
device (Combi).
Slide the door fully until it locks in.    
  Hinged rear doors 
 Start by closing the small sliding door, this 
locks automatically when it is closed.
Close the large door with its handle.        
         
        
        
     
        
        Page 42 of 140
36
Accesses
  Sliding side door (Combi) 
 Press on the control to release the door and 
pull the handle towards yourself to reclose 
the door.  
   Child lock  
 This prevents the opening from inside of 
each of the rear doors.   
F   Turn the control for each rear door by a 
quarter turn using the ignition key.    
 CLOSING FROM THE OUTSIDE  
  Sliding side door 
 Pull the handle towards you, then towards 
the front to secure it in the open position 
(Van) or to trigger the door open retaining 
device (Combi).
Slide the door fully until it locks in.    
  Hinged rear doors 
 Start by closing the small sliding door, this 
locks automatically when it is closed.
Close the large door with its handle.        
         
        
        
     
        
        Page 43 of 140
37
1
READY TO SET OFF
Steering wheel controls 
 LIGHTING CONTROL 
 Selection is by rotation of the white mark  
on the ring, when the ignition key is in the 
"RUNNING" position. 
  All lights off  
  Side lights on 
 This is indicated on the  
instrument panel by lighting of the 
warning light.  
  Dipped headlamps/main beam headlamps on 
  Dipped headlamps/main beam headlamps change 
 Pull the control fully towards you.  
  Headlamp flash 
  Direction indicators (green flashing) 
  "Motorway" function 
 System which indicates a change of lane on  
a motorway. 
 Press up or down once, without passing 
the point of resistance; the corresponding 
direction indicators will flash three times.     Pull the control towards you 
gently, regardless of the position 
of the ring.  
 Left: downwards. The direction 
arrow warning light flashes on the 
instrument panel. 
 Right: upwards. The direction arrow warning 
light flashes on the instrument panel.  
 Turn the ring into position.    
         
        
        
     
        
        Page 44 of 140

38
Steering wheel controls 
  Headlamp beam 
 You are advised to adjust the height of the  
headlamp beams in accordance with the 
load in your vehicle.   
 This function can only be accessed in 
the main beam headlamps and dipped 
headlamps position.  Press these controls, located 
on the fascia panel, several 
times in succession to adjust the 
headlamps.   
  Fog lamps 
   The controls are located on the fascia panel  
control pad.  
  Front and rear fog lamps 
   The fog lamps should only be used in  
fog or when snow is falling. 
 In clear weather or in rain, both day and 
night, lit rear fog lamps dazzle and are 
prohibited. 
 Do not forget to switch them off when they 
are no longer necessary.  
  "Follow me home" lighting 
 The temporary maintaining of the dipped 
headlamps, after switching off the vehicle’s 
ignition, makes the driver ’s exit easier when 
the light is poor and lights the space in front 
of the vehicle.  
  
Activation   
 With the ignition key in the STOP position  
or removed, pull the lighting control towards 
the steering wheel within 2 minutes after 
switching off the engine. 
 Each time the control is operated, the 
duration for which the lights will remain on is 
extended by 30 seconds, up to a maximum 
of 210 seconds. Once this period of time has 
elapsed, the lights switch off automatically.  
  
Deactivation   
 Pull the lighting control towards the steering  
wheel for more than 2 seconds.  
 The front fog lamps operate with 
the side lights and the dipped 
headlamps.  
 The rear fog lamps operate with  
the dipped headlamps. 
 Press one of these controls to switch on the 
lights.   The warning light comes on, 
accompanied by a message 
on the display, the first time 
the control is operated and 
remains on until the function is deactivated 
automatically.   An indicator light on the display 
indicates the adjustment position 
selected (0, 1, 2, 3).     
         
        
        
     
        
        Page 45 of 140

38
Steering wheel controls 
  Headlamp beam 
 You are advised to adjust the height of the  
headlamp beams in accordance with the 
load in your vehicle.   
 This function can only be accessed in 
the main beam headlamps and dipped 
headlamps position.  Press these controls, located 
on the fascia panel, several 
times in succession to adjust the 
headlamps.   
  Fog lamps 
   The controls are located on the fascia panel  
control pad.  
  Front and rear fog lamps 
   The fog lamps should only be used in  
fog or when snow is falling. 
 In clear weather or in rain, both day and 
night, lit rear fog lamps dazzle and are 
prohibited. 
 Do not forget to switch them off when they 
are no longer necessary.  
  "Follow me home" lighting 
 The temporary maintaining of the dipped 
headlamps, after switching off the vehicle’s 
ignition, makes the driver ’s exit easier when 
the light is poor and lights the space in front 
of the vehicle.  
  
Activation   
 With the ignition key in the STOP position  
or removed, pull the lighting control towards 
the steering wheel within 2 minutes after 
switching off the engine. 
 Each time the control is operated, the 
duration for which the lights will remain on is 
extended by 30 seconds, up to a maximum 
of 210 seconds. Once this period of time has 
elapsed, the lights switch off automatically.  
  
Deactivation   
 Pull the lighting control towards the steering  
wheel for more than 2 seconds.  
 The front fog lamps operate with 
the side lights and the dipped 
headlamps.  
 The rear fog lamps operate with  
the dipped headlamps. 
 Press one of these controls to switch on the 
lights.   The warning light comes on, 
accompanied by a message 
on the display, the first time 
the control is operated and 
remains on until the function is deactivated 
automatically.   An indicator light on the display 
indicates the adjustment position 
selected (0, 1, 2, 3).