28
Instruments and controls
ing lightWarning l is indicates Solution - action
Coolant
temperature
on with the
needle in the red
zone.
an abnormal increase. Park and switch off the ignition, allow the circuit to cool.
Visually check the level.
on H in the red
zone. a coolant temperature. Refer to the "Levels" section of chapter 7. Consu lt a
CITROËN dealer.
Engine oil
pressure
on while driving. that the pressure is too low.
Park and switch off the ignition, allow the lubrication
circuit to cool in order to check its level. Refer to the
"Levels" section of chapter 7.
continuously on, even though the level is correct. a major fault. Consult a CITROËN dealer.
flashing, for a few seconds, with a message on the display.
that a service will soon be due. Refer to the list of checks in the servicing booklet then
carry out the CITROËN service.
Battery charge
on. a fault in the charging circuit. Check the battery terminals… Refer to the "Battery "
section of chapter 8.
continuously on, in spite of the checks.
a circuit fault, an ignition or
injection malfunction. Consult a CITROËN dealer.
Door or bonnet
open detection
on. that a door or the bonnet is not
closed correctly.
Check that the cab doors, the rear and side doors and
the bonnet are closed. accompanied by a message on the display.
127
Battery
TROUBLESHOOTING
8
A. Positive metal point on your vehicle
B. Slave battery
C. Earth on your vehicle CHARGING THE BATTERY USING
A CHARGER
- disconnect the battery,
- follow the instructions for use given by
the battery charger manufacturer,
- reconnect starting with the negative (-) terminal,
- check that the terminals and connectors are clean. If they are covered with
sulphate (white or greenish deposit),
disconnect them and clean them. The charging operation must be carried
out in a ventilated area away from naked
flames or any possible sources of sparks to
eliminate the risk of explosion and fire.
Do not attempt to charge a frozen battery: it
must first be thawed to eliminate the risks of
explosion. If the battery has frozen, before
charging it have it checked by a specialist
who will check that the internal components
have not been damaged and that the
container is not cracked, which could mean
that there is a risk of a leak of toxic and
corrosive acid.
BATTERY
STARTING FROM ANOTHER BATTERY
- connect the red cable to the metal
point A then to the positive (+) terminal
of the slave battery B ,
- connect one end of the green or black cable to the negative (-) terminal of the
slave battery B ,
- connect the other end of the green or black cable to the earth point C on your
vehicle,
- operate the starter, let the engine run,
- wait for the engine to return to idle, then disconnect the cables.
