
         Ventilation         
  Cancelling  the  programming 
 Press this button briefly to clear  
the programmed start time.  The display lighting and the 
pre-selection number (e.g. 1) are 
switched off.  
  Good  practice 
 To avoid any risk of poisoning or  
asphyxiation, the additional heating must 
not be used, even for short periods, in 
an enclosed space such as a garage or 
workshop which is not fitted with an exhaust 
gas extraction system.  
 The additional heating is supplied by the  
vehicle's fuel tank.  
 Ensure that the fuel gauge indicator light is  
not at reserve.  
 Always switch off the additional heating  
when filling with fuel to avoid any risk of fire 
or explosion.  
 Do not park the vehicle on an inflammable  
surface (dry grass, dead leaves, paper…), 
there is a risk of fire.  
 The temperature near the heater must not  
exceed 120 °C. A temperature higher than 
this (for example in the case of painting in 
an oven) could damage the components of 
the electronic circuits.  
 The additional heating system is fitted with  
a temperature limiter which cuts off the 
combustion in the event of overheating due 
to a lack of coolant.  
 Top up the coolant, then press the  
programme selection control before 
switching the heating on again.   Have the additional heating system 
checked at least once a year at the 
 b e g i n n i n g   o f   w i n t e r .   M a i n t e n a n c e   a n d  
repairs should only be carried out by a 
CITROËN dealer.  
 Use recommended replacement parts only.  
  Recalling  one  of  the  pre-selected start  times 
 Press this button as many times  
as necessary until the number 
corresponding to the required 
pre-selected start time (e.g. 2) 
appears. 
 After ten seconds, the time is cleared but 
remains stored for as long as the number 
(e.g. 2) and the display remain lit.  
  Switching  off  the  heating 
 Press this button.  
 The heating cycle indicator light  
and the display are switched off.  
  Two  different  types  of  equipment 
 The additional heating is autonomous and  
programmable. Before you enter the vehicle, 
it gradually increases the temperature of the 
engine to make starting easier.  
 This also facilitates passenger compartment  
heating, de-icing and demisting.  
 The additional passenger compartment  
heating system supplements the 
standard equipment. Its operation may be 
independent of the engine.  
 Switching on of the heating may be  
programmable.   

kmC I T Y
 108
   Air  bags   
  Disarming  the  passenger  air  bag 
 Refer to the "MODE" section of  
chapter 4, then on the "Passenger air 
bag" menu, select   OFF .   When  
OFF  is selected, the passenger air bag 
will not be triggered in the event of an impact.  
 As soon as the child seat is removed, select  
 
ON   to re-activate the air bag and thus 
ensure the safety of your passenger in the 
event of an impact.  
  Side  air  bags  and  curtain  air  bags 
 If your vehicle is fitted with side air bags,  
these are incorporated into the front seat 
backs on the door side.  
 The curtain air bags are incorporated into  
the door pillars and the upper part of the 
passenger compartment, in the roof over the 
front cab seats.  
 They inflate between the occupant and the  
glass.  
 They are deployed independently of each  
other depending on which side the collision 
occurs. 
 The air bag warning light on 
the instrument panel comes on 
throughout the period of disarming. 
 To ensure the safety of your child, it is 
essential to disarm the passenger air bag 
when you install a rear-facing child seat on 
the front passenger seat. Otherwise, the child 
would risk being killed or seriously injured if 
 t h e   a i r   b a g   w e r e   t o   i n fl   a t e .   
   I f   y o u r   v e h i c l e   i s   n o t   fi   t t e d   w i t h   t h i s   e q u i p m e n t :   
do not install a rear-facing child seat. 
  Disarming  check 
 This is confirmed by lighting of  
this warning light each time the 
engine is started. 
 If your vehicle is fitted 
with this display, the 
check is accompanied by 
a message.  
  Operating  check 
 Confirmed by this indicator light.       

kmC I T Y
 108
   Air  bags   
  Disarming  the  passenger  air  bag 
 Refer to the "MODE" section of  
chapter 4, then on the "Passenger air 
bag" menu, select   OFF .   When  
OFF  is selected, the passenger air bag 
will not be triggered in the event of an impact.  
 As soon as the child seat is removed, select  
 
ON   to re-activate the air bag and thus 
ensure the safety of your passenger in the 
event of an impact.  
  Side  air  bags  and  curtain  air  bags 
 If your vehicle is fitted with side air bags,  
these are incorporated into the front seat 
backs on the door side.  
 The curtain air bags are incorporated into  
the door pillars and the upper part of the 
passenger compartment, in the roof over the 
front cab seats.  
 They inflate between the occupant and the  
glass.  
 They are deployed independently of each  
other depending on which side the collision 
occurs. 
 The air bag warning light on 
the instrument panel comes on 
throughout the period of disarming. 
 To ensure the safety of your child, it is 
essential to disarm the passenger air bag 
when you install a rear-facing child seat on 
the front passenger seat. Otherwise, the child 
would risk being killed or seriously injured if 
 t h e   a i r   b a g   w e r e   t o   i n fl   a t e .   
   I f   y o u r   v e h i c l e   i s   n o t   fi   t t e d   w i t h   t h i s   e q u i p m e n t :   
do not install a rear-facing child seat. 
  Disarming  check 
 This is confirmed by lighting of  
this warning light each time the 
engine is started. 
 If your vehicle is fitted 
with this display, the 
check is accompanied by 
a message.  
  Operating  check 
 Confirmed by this indicator light.       

 117
6
   Towing  a  trailer   
ACCESSORIES
  
Cooling:   towing a trailer on a slope 
increases the coolant temperature.  
 As the fan is electrically controlled, its  
cooling capacity is not dependent on the 
engine speed.  
 On the contrary, use a high gear to lower the  
engine speed and reduce your speed.  
 In all cases, pay attention to the coolant  
temperature.     
Tyres:   check the tyre pressures of the 
towing vehicle (see the "Identification 
features" section of chapter 9) and of 
the trailer, observing the recommended 
pressure. 
     We recommend the use of original  
 CITROËN  towbars and their harnesses, 
which have been tested and approved from 
the design stage of your vehicle and that 
the fitting of this equipment is entrusted to a 
 CITROËN  dealer.  
 If this equipment is not fitted by a  
 CITROËN  dealer, it is imperative that it is 
fitted using the electrical pre-equipment 
installed at the rear of the vehicle and 
in accordance with the manufacturer ’s 
instructions.  
  Good practice 
 In certain cases of particularly arduous  
use (towing the maximum load up a steep 
slope in high temperatures), the engine 
automatically limits its power. In this 
case, the automatic cutting off of the air 
conditioning allows the engine power to be 
recovered. 
 If the coolant temperature 
warning light comes on, stop the 
vehicle and switch off the engine 
as soon as possible.   
 See the "Levels" section of chapter 7.    
Brakes:   towing increases the braking 
distance. Drive at a moderate speed, 
change down early and brake gradually.  
  
Side wind:   sensitivity to side wind 
is increased. Drive smoothly and at a  
moderate speed.  
  
ABS:   the system only controls the vehicle, 
not the trailer.  
  
Rear parking assistance:   the assistance 
does not function while the vehicle is towing.   

 122
  Levels
 LEVELS 
 These regular maintenance operations  
will keep your vehicle in good running 
order. Consult the instructions at  CITROËN  
dealerships or in the servicing booklet 
enclosed in the handbook pack.   To maintain the reliability of engines and 
emission control systems, the use of 
additives in engine oil is prohibited.   
  Changing the brake fluid 
 The brake fluid must be changed at  
the intervals stated, according to the 
manufacturer's servicing schedule.  
 Use fluids recommended by the  
manufacturer, which fulfil DOT4 standards.  
 The level must be between the  
MIN  and 
 
MAX   marks on the reservoir. 
 If fluid has to be added frequently, this  
indicates a failure which must be checked by 
a  CITROËN  dealer as soon as possible.  
  If you have to remove/refit the engine 
style cover, handle it with care to avoid 
damaging the fixing clips. 
  Dipstick  
 There are two marks on  
the dipstick: 
  Oil change 
 It is imperative that this is carried out at the  
intervals specified and the viscosity grade of 
the oil selected must fulfil the requirements 
in accordance with the manufacturer's 
servicing schedule. Consult the instructions 
at  CITROËN  dealerships.  
 Remove the dipstick before filling. 
 Check the level after filling (never exceed  
the maximum mark).  
 Screw the cap back onto the sump before  
closing the bonnet.  
  Viscosity selection 
 In all cases, the oil selected must meet the  
manufacturer's requirements.  
  Warning lights 
 Checking by means of the warning  
lights on the instrument panel is 
described in chapter 2, refer to the 
"Instruments and controls" section.  
  
A   = maximum 
 If you fill past this mark, 
contact a  CITROËN  dealer.  
  
B   = minimum 
 Never allow the level to fall  
below this mark. 
  Oil level 
 Check the level regularly and top up  
between changes. The maximum 
consumption is 0.5 l per 600 miles 
(1 000 km). Check the level with the vehicle 
level, engine cold, using the dipstick.     

   Checks   
 CHECKS 
  Air filter and passenger compartment filter 
 A clogged passenger compartment filter  
may reduce the performance of the 
air conditioning system and generate 
undesirable odours. The replacement 
intervals for these components are indicated 
in the servicing booklet.  
 Depending on the environment (dusty  
atmosphere...) and the use of the vehicle 
(urban driving...), change them twice as 
often if necessary, refer to the "Under the 
bonnet" section of chapter 7.  
  Manual gearbox 
 Have the level checked in accordance with  
the manufacturer ’s servicing schedule.   To check the main levels and certain 
components, in accordance with the 
manufacturer ’s servicing schedule, 
refer to the pages of the servicing booklet 
which correspond to your vehicle’s engine.  
 Only use products recommended by  
 CITROËN  or products of equivalent quality 
and characteristics.  
 In order to optimise the operation of units as  
important as the braking circuit,  CITROËN  
selects and offers specific products.  
 In order to avoid damaging the electrical  
units, high pressure washing to clean the 
engine compartment is strictly prohibited. 
  Handbrake 
 Where the handbrake travel is too great  
or there is a reduction in the performance 
of the system, the handbrake should be 
adjusted, even between services.  
 Have the system checked by a  CITROËN   
dealer.  
  Bleeding the water contained in the diesel filter 
 If this warning light comes on,  
bleed the filter, otherwise bleed 
regularly each time the engine is 
drained.   
 To evacuate the water, unscrew the bleed 
screw or the water in diesel sensor, located 
at the base of the filter. Operate until all 
of the water has been drained out. Then 
tighten the bleed screw or the water sensor.   
 HDi engines use advanced technology. All  
work requires a special qualification which is 
guaranteed by a  CITROËN  dealer.  
  Battery 
 At the start of winter, have your battery  
checked by a  CITROËN  dealer.  
  Brake pads 
 Brake pad wear depends on the style of  
driving, in particular for vehicles which are 
used in town, over short distances. It may 
be necessary to check the thickness of the 
pads, even between services.  
 Unless there is a leak on the circuit, a drop  
in the brake fluid level indicates that the 
brake pads are worn.  
  Brake disc/drum wear status 
 For any information relating to checking  
the brake disc/drum wear status, contact a 
 CITROËN  dealer.  
  Oil filter 
 Change the filter regularly, in accordance  
with the servicing schedule.    

 126
   Fuel   
  Low fuel level 
 When the fuel tank level  E  
(Empty) is reached, this warning  
light comes on. At this moment, 
you have   enough fuel left to 
drive approximately 30 miles (50 km)  , 
depending on the driving conditions, 
the engine and the profile of the road. Fill up 
without delay to avoid running out of fuel.   The fuel tank must be filled  
with the engine 
off .  
   -   Open the fuel filler flap.  
  -   Support the cap with one hand. 
  -   With the other hand, insert the key, then  turn it anticlockwise. 
  -   Remove the cap and hook it onto the  clip located on the inside of the flap.  
 A label affixed to the inside of the flap  
reminds you of the type of fuel to be used.  
 When filling the fuel tank, do not continue  
after the 3rd cut-off of the nozzle. This could 
cause malfunctions.  
 The capacity of the fuel tank is  
approximately   90  litres. 
   -   After filling the fuel tank, lock the cap  and close the flap.  
 FUEL CIRCUIT DEACTIVATED 
 In the event of a serious collision, a device  
automatically cuts off the fuel supply to the 
engine and the vehicle’s electrical supply. 
 FILLING WITH FUEL 
 Fuel tanks of different capacities,  
60 and 125 litres, are sold.    Check that there is no smell or leak of fuel 
outside the vehicle. 
Restore the supply by pressing:
-   the first button, 
located below the steering wheel.
-   the second button,  ocated in the 
battery l compartment under the front 
passenger ’s floor.