Page 3 of 207
FAMILIARISATION OPEN
Boot M o v a b l e b o o t fl o o r
T h i s m o v a b l e b o o t fl o o r w i t h t w o p o s i -
t i o n s a l l o w s y o u t o :
- m a x i m i s e t h e v o l u m e o f t h e b o o t ,
- p a r t i t i o n t h e b o o t ( s t o r i n g o f t h e r e a r
shelf...),
- o b t a i n a fl a t fl o o r f r o m t h e b o o t opening to the front seats, when the
rear bench seat is in the retracted
position.
1. U n l o c k i n g o f t h e v e h i c l e .
2. Opening of the boot.
60
80
A. Interior control.
B. E x t e r i o r c o n t r o l .
C. B o n n e t s t r u t .
109
Bonnet
Page 44 of 207
46
COMFORT
FRONT SEATS
Seat consisting of a seat cushion, a seat
back and a head restraint which can all
be adjusted to adapt your position for
ease of driving and comfort. D r i v e r ' s s e a t h e i g h t a d j u s t m e n t S e a t b a c k a n g l e a d j u s t m e n t
F o r w a r d s - b a c k w a r d s a d j u s t m e n t
Raise the control and slide the seat
forwards or backwards.
Pull the control upwards to raise
or push it downwards to lower, as
many times as necessary, to obtain
the position required.
Push the control rearwards.
Page 45 of 207
!
47
COMFORT
Press the control located under the
front end of the armrest to release it.
Move it to the low position.
Raise it notch by notch to reach the
desired position.
To place the armrest in the vertical posi-
tion, raise it and push it backwards
beyond the point of resistance.
H e a d r e s t r a i n t h e i g h t a d j u s t m e n t
To raise the head restraint, pull it
upwards.
To remove the head restraint, press
the lug A and pull the head restraint
upwards.
To put the head restraint back in
place, engage the head restraint
stems in the openings keeping them
in line with the seat back.
To lower the head restraint, press
the lug A and the head restraint at
the same time. T h e h e a d r e s t r a i n t i s fi t t e d w i t h a
frame with notches which prevents
it from lowering; this is a safety
device in case of impact.
T h e a d j u s t m e n t i s c o r r e c t w h e n
t h e u p p e r e d g e o f t h e h e a d
r e s t r a i n t i s l e v e l w i t h t h e t o p o f
t h e h e a d .
Never drive with the head restraints
removed; they must be in place and
adjusted correctly.
A d j u s t i n g t h e a r m r e s t
A d d i t i o n a l a d j u s t m e n t s
Heated seats control
Use the adjustment dial, placed on
the side of each front seat, to switch
on and select the level of heating
required:
0 : Off.
1 : Low.
2 : Medium.
3 : High.
With the engine running, the front seats
can be heated separately.
Page 71 of 207
!
i
66
VISIBILITY In fog or snow, the brightness
s e n s o r m a y d e t e c t s u f fi c i e n t l i g h t .
Therefore, the lights will not come
on automatically.
Do not cover the brightness sen-
sor, linked with the rain sensor and
located in the centre of the winds-
creen behind the interior mirror; the
associated functions would no lon-
ger be controlled.
Linked with the "Guide-me-home"
lighting
Association with the automatic lighting
provides the "guide-me-home" lighting
with the following additional options:
- automatic activation of "guide-me-
home" lighting when automatic
lighting is switched on (in the vehicle
parameters of the multifunction dis-
p l a y c o n fi g u r a t i o n m e n u ) ,
- selection of the duration of main- taining of the lighting for 15, 30 or
60 seconds in the vehicle para-
meters of the multifunction display
c o n fi g u r a t i o n m e n u ( e x c e p t f o r
monochrome display A where this
i s p r e s e t ) .
Operating fault In the event of a malfunction
of the brightness sensor,
the lights come on, this war-
ning light is displayed on the
instrument panel and/or a message
appears on the multifunction display,
accompanied by an audible signal.
Consult a CITROËN dealer.
MANUAL HEADLAMP ADJUSTMENT
The initial setting is position "0" .
To avoid causing a nuisance to other
road users, the height of the halogen
headlamps should be adjusted in rela-
tion to the load in the vehicle.
0. 1 or 2 people in the front seats.
-. Less than 5 people.
1. 5 people.
-. 5 people + maximum authorised load.
2 - 3. Driver + maximum authorised load.
Page 72 of 207
!
i
66
VISIBILITY In fog or snow, the brightness
s e n s o r m a y d e t e c t s u f fi c i e n t l i g h t .
Therefore, the lights will not come
on automatically.
Do not cover the brightness sen-
sor, linked with the rain sensor and
located in the centre of the winds-
creen behind the interior mirror; the
associated functions would no lon-
ger be controlled.
Linked with the "Guide-me-home"
lighting
Association with the automatic lighting
provides the "guide-me-home" lighting
with the following additional options:
- automatic activation of "guide-me-
home" lighting when automatic
lighting is switched on (in the vehicle
parameters of the multifunction dis-
p l a y c o n fi g u r a t i o n m e n u ) ,
- selection of the duration of main- taining of the lighting for 15, 30 or
60 seconds in the vehicle para-
meters of the multifunction display
c o n fi g u r a t i o n m e n u ( e x c e p t f o r
monochrome display A where this
i s p r e s e t ) .
Operating fault In the event of a malfunction
of the brightness sensor,
the lights come on, this war-
ning light is displayed on the
instrument panel and/or a message
appears on the multifunction display,
accompanied by an audible signal.
Consult a CITROËN dealer.
MANUAL HEADLAMP ADJUSTMENT
The initial setting is position "0" .
To avoid causing a nuisance to other
road users, the height of the halogen
headlamps should be adjusted in rela-
tion to the load in the vehicle.
0. 1 or 2 people in the front seats.
-. Less than 5 people.
1. 5 people.
-. 5 people + maximum authorised load.
2 - 3. Driver + maximum authorised load.
Page 84 of 207
LAYOUT
REAR INTERIOR LAYOUT
They are located on the back of the
front seats.
Two boxes are available, located under
the rear passenger footwells.
To open them, lift the lid using the
groove
A . There is a bottle-holder located at the
rear of the central console.
Storage boxes Seat pockets Bottle-holder
Page 85 of 207
!
77
LAYOUT
It is located at the rear of the central
console if the lighter is installed in the
front.
12 volts socket (100 W max)
Lift up the control to release the table
and unfold it.
Aircraft style tables
Reading lamps are built into the back of
the front seats, behind the tables. With
the ignition on, they light up the top of
the table without inconveniencing other
passengers.
They are only accessible if the table is
unfolded.
Press the button to switch the light
on or off.
Individual reading lamps
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event
of sharp braking or impact.
As a safety precaution, if too much
pressure is exerted the table will
fold back downwards.
Page 87 of 207
!
77
LAYOUT
It is located at the rear of the central
console if the lighter is installed in the
front.
12 volts socket (100 W max)
Lift up the control to release the table
and unfold it.
Aircraft style tables
Reading lamps are built into the back of
the front seats, behind the tables. With
the ignition on, they light up the top of
the table without inconveniencing other
passengers.
They are only accessible if the table is
unfolded.
Press the button to switch the light
on or off.
Individual reading lamps
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event
of sharp braking or impact.
As a safety precaution, if too much
pressure is exerted the table will
fold back downwards.
