2008.5 Citroen C1 gearbox
[x] Cancel search: gearboxPage 3 of 99
6
FAMILIARISATION Manual air conditioning
T h i s a i r c o n d i t i o n i n g s y s t e m o p t i -
mises the distribution of the air and
its temperature inside the passenger
compartment.
33 SensoDrive gearbox
T h i s fi v e - s p e e d r o b o t i s e d m a n u a l
gearbox offers a choice between
the comfort of fully automatic
operation or the pleasure of manual
gear changing.
62
Auxiliary socket for portable
equipment
C o m p a t i b l e w i t h m a n y M P 3 p l a y -
e r s , t h i s s o c k e t a l l o w s y o u t o l i s t e n
t o y o u r f a v o u r i t e t r a c k s w h i l e t r a -
velling. Refer to the conditions of
use in the "Audio" section.
23 INTERIOR
Page 13 of 99
16
FAMILIARISATION "SensoDrive" gearbox
Starting the engine
W i t h t h e p a r k i n g b r a k e a p p l i e d , p r e s s
the brake pedal then select position N
to start the engine.
W i t h y o u r f o o t o n t h e b r a k e , s e l e c t
position R , E or M .
R e l e a s e t h e p a r k i n g b r a k e , t a k e y o u r
f o o t o f f t h e b r a k e p e d a l , t h e n a c c e l -
erate.
62 Select position
E using the gear lever.
The gear engaged is displayed on
the instrument panel screen.
The gearbox continuously selects
the most suitable gear.
63
Manual mode
Place the gear lever in position M ,
then change up or down through the
gears by pressing:
- r e a r w a r d s , "+" t o c h a n g e u p ,
- f o r w a r d s , "-" to change down.
The gear engaged is displayed on
the instrument panel screen.
63 Press the clutch pedal fully when
changing gear.
Reverse
T o e n g a g e r e v e r s e g e a r , p u s h t h e
g e a r l e v e r f u l l y t o t h e r i g h t t h e n t o -
wards the rear.
Reverse gear can only be engaged
when the vehicle is stationary, en-
gine at idle.
EASY mode (automatic mode)
Manual gearbox
Page 14 of 99
1
17
INSTRUMENTS and CONTROLS
INSTRUMENT PANEL
1. Total/trip distance recorder zero
reset button
2. Warning lamps and indicators
display
3. Direction indicators
4. Speedometer
5. Fuel gauge
6. Total/trip distance recorder
7. Rear foglamp indicator lamp
8. Main beam headlamps indicator
lamp
9. Dipped headlamps indicator
lamp
REV COUNTER
Approaching the maximum engine
speed, when the rev counter needle
crosses into the red zone, you must
change up.
10. " SensoDrive" gearbox gear and
gear lever positions indicator
Page 16 of 99
1
19
INSTRUMENTS and CONTROLS
Battery charge warning
lamp
This comes on each time the
ignition is switched on until
the engine is started.
Fixed lighting, with the engine run-
ning, indicates a malfunction.
Consult a CITROËN dealer.
Driver’s seat belt not
fastened warning lamp *
When the ignition is switched
o n , t h e w a r n i n g l a m p fl a s h e s u n t i l t h e
driver fastens his seat belt.
Above a speed of approximately
10 mph (15 km/h), the warning lamp
fl a s h e s a c c o m p a n i e d b y a n a u d i b l e
signal until the driver fastens their
seat belt.
The driver must ensure that all pas-
sengers have fastened their seat belt
correctly.
Airbags warning lamp
This comes on for a few sec-
onds each time the ignition is
switched on.
Flashing of this warning lamp indi-
cates a malfunction of the airbags.
They may no longer be triggered in
the event of a serious impact.
Consult a CITROËN dealer. Passenger airbag deactivated
If the passenger air bag is disarmed,
the warning lamp remains on.
SensoDrive gearbox
warning lamp
Fixed lighting of this warn-
ing lamp, with the engine running,
indicates a malfunction of the Senso-
Drive gearbox.
Emission control
system warning lamp
This comes on each time the
ignition is switched on until
the engine is started.
Fixed lighting, with the engine run-
ning, indicates an emission control
system fault.
Consult a CITROËN dealer. Diesel engine pre-heat
warning lamp
Wait until the warning lamp is
switched off before starting.
I f t h e t e m p e r a t u r e i s s u f fi c i e n t , t h e
w a r n i n g l i g h t c o m e s o n b r i e fl y , y o u
can start without waiting.
Water in diesel filter
warning lamp **
This comes on for a few
seconds each time the ignition is
switched on.
Fixed lighting, with the engine run-
ning, indicates a risk of damage to
the engine.
Consult a CITROËN dealer.
* According to version.
Note: it may also come on if
you run out of fuel (see "Run-
ning out of fuel").
** According to country.
Dynamic stability
control system
(ASR/ESP) activation
warning lamp
This comes on for a few seconds each
time the ignition is switched on.
With the engine running and the ve-
hicle moving, it comes on if the sys-
tem is activated. Dynamic stability
control system
(ASR/ESP) fault
warning lamp
This comes on for a few seconds each
time the ignition is switched on.
If this warning lamp comes on, with
the engine running, this indicates a
fault in the system.
Consult a CITROËN dealer.
Page 17 of 99
1
20
INSTRUMENTS and CONTROLS
DISPLAY SCREEN
To reset the trip recorder to zero,
when it is displayed, press and hold
button 1 . "SensoDrive" gearbox
indicator
Lever in EASY mode
(automatic mode)
"E" is displayed when this
operating mode is selected.
It is switched off on switching to manual
mode.
Lever in manual mode
"M" is displayed when this
operating mode is selected.
It is switched off on switching
to EASY mode.
"Neutral"
"Reverse"
Total/trip distance recorder
When the ignition is switched on,
the distance recorder selected when
the engine was switched off is dis-
played.
Press button 1 to alternate the dis-
tance display:
- total with "ODO" displayed,
- trip with "TRIP" displayed.
Page 18 of 99
1
20
INSTRUMENTS and CONTROLS
DISPLAY SCREEN
To reset the trip recorder to zero,
when it is displayed, press and hold
button 1 . "SensoDrive" gearbox
indicator
Lever in EASY mode
(automatic mode)
"E" is displayed when this
operating mode is selected.
It is switched off on switching to manual
mode.
Lever in manual mode
"M" is displayed when this
operating mode is selected.
It is switched off on switching
to EASY mode.
"Neutral"
"Reverse"
Total/trip distance recorder
When the ignition is switched on,
the distance recorder selected when
the engine was switched off is dis-
played.
Press button 1 to alternate the dis-
tance display:
- total with "ODO" displayed,
- trip with "TRIP" displayed.
Page 19 of 99
1
21
INSTRUMENTS and CONTROLS
Operating mode:
1st gear
2nd gear
3rd gear
4th gear
5th gear
If this warning lamp comes
on, with the engine running,
this indicates a malfunction of
the "
SensoDrive
" gearbox. Fuel gauge
This indicates the quantity of fuel
available:
-
1/1 and six segments, the fuel
tank is full.
- R a n d o n e s e g m e n t fl a s h i n g , t h e
fuel tank is on the reserve.
Low fuel level
When the minimum level in the fuel tank
i s r e a c h e d , t h e l a s t s e g m e n t fl a s h e s a c -
companied by an audible signal.
In certain driving conditions and depend-
ing on the engine, the distance which
can be travelled with the fuel remaining
may be less than 30 miles (50 km).
You have approximately 5 litres remaining.
W h e n t h e f r e q u e n c y o f t h e fl a s h i n g i n -
creases, you have approximately 3 litres
remaining .
At least 5 litres must be added
after running out of fuel. Running out of diesel fuel
After running out of fuel, you
can travel a short distance
after 10 pump repriming op-
erations (see corresponding
section).
A f t e r fi l l i n g t h e f u e l t a n k ( m i n i -
mum 5 litres), operate the repriming
pump at least 10 times (see corre-
sponding section).
"!" warning
lamp
Consult a CITROËN dealer.
Page 70 of 99
7
62
DRIVING Driver information
The symbol which corresponds to the
selection, R , N , E or M and the number
of the gear engaged 1 to 5 , are displayed on the instrument panel screen.
SENSODRIVE GEARBOX
T h e fi v e - s p e e d " S e n s o D r i v e " g e a r -
box offers a choice between the
ease of automatic operation or
t h e d r i v i n g p l e a s u r e o f manual gear
changing .
Driving mode
S e l e c t t h e d r i v i n g m o d e b y m o v i n g
t h e g e a r l e v e r .
R e v e r s e " R " . T h i s g e a r w i l l b e e n -
gaged when stationary or at a
speed below approximately 4 mph
(6 km/h).
E n g a g e m e n t o f r e v e r s e g e a r i s
accompanied by an audible signal.
N e u t r a l " N " .
P o s i t i o n t h e l e v e r t o t h e r i g h t i n p o s i -
tion N , to start the engine .
E a s y " E " : a u t o m a t i c g e a r c h a n g i n g .
M a n u a l ( + / - ) " M " : m a n u a l g e a r
changing. Starting the engine
With the parking brake applied, press
the brake pedal then select position
N to start the engine.
With your foot on the brake, select
position R , E or M .
R e l e a s e t h e p a r k i n g b r a k e , t a k e
your foot off the brake pedal, then
accelerate.
Notes: w i t h t h e e n g i n e r u n -
n i n g , i n t h e s e t h r e e p o s i -
tions, an audible signal is
h e a r d w h e n t h e d r i v e r ' s d o o r
is opened.
You can change from position E to
position M a n d v i c e v e r s a a t a n y
time.