8-50 
1
2
3
4
5
6
78
9
10
11
 
EBU25580 
Replacing the tail/brake light bulb  
If the tail/brake light bulb burns out, have a
Yamaha dealer replace it. 
EBU25650 
Removing a wheel  
1. Loosen the wheel nuts. 
FrontRear 
2. Elevate the ATV and place a suitable stand
under the frame.
3. Remove the nuts from the wheel.
4. Remove the wheel. 
EBU25670 
Installing a wheel  
1. Install the wheel and the nuts.
NOTE:
 
When installing a front wheel, make sure its arrow
mark   points toward the rotating direction of the 
wheel. 
1. Nut 
1. Nut 
         
        
         
9-1 
1
2
3
4
5
6
7
89
10
11
 
EBU25860 
CLEANING AND STORAGE 
EBU25900 
Cleaning  
Frequent, thorough cleaning of your ATV will not
only enhance its appearance but will improve its
general performance and extend the useful life of
many components.
1. Before cleaning the ATV:
a. Block off the end of the exhaust pipe to
prevent water entry. A plastic bag and
strong rubber band may be used.
b. Make sure the spark plug and all filler caps
are properly installed.
2. If the engine case is excessively greasy, apply
degreaser with a paint brush. Do not apply de-
greaser to the chain, sprockets or wheel ax-
les.
3. Rinse the dirt and degreaser off with a garden
hose. Use only enough pressure to do the job.
CAUTION:
 
ECB00710  
Excessive water pressure may cause water
seepage and deterioration of wheel bearings,
brakes, transmission seals and electrical de-
vices. Many expensive repair bills have result-ed from improper high-pressure detergent
applications such as those available in coin- 
operated car washers. 
4. Once most of the dirt has been hosed off,
wash all surfaces with warm water and mild,
detergent-type soap. An old toothbrush or bot-
tle brush is handy for hard-to-reach places.
5. Rinse the ATV off immediately with clean wa-
ter and dry all surfaces with a chamois, clean
towel or soft absorbing cloth.
6. Dry the chain and lubricate it to prevent it from
rusting.
7. Clean the seat with a vinyl upholstery cleaner
to keep the cover pliable and glossy.
8. Automotive type wax may be applied to all
painted and chrome plated surfaces. Avoid
combination cleaner-waxes. Many contain
abrasives which may mar the paint or protec-
tive finish. When finished cleaning, start the
engine and let it idle for several minutes.WARNING
 
EWB02310  
Wet brakes may have reduced stopping ability,