2007 YAMAHA XTZ125 brake

4-4
4-4 If brake fluid leakage is found, ask a Yamaha dealer or
other qualified mechanic for immediate repairs. Such
leakage could indicate a hazardous condition.
CAUTION:
Brake fluid may deteriorate painted surfaces or plastic
parts. Never spill any fluid. If spilled, clean it up
immediately.
Brake fluid leakage
Apply the brake for several seconds. Check to see if any
brake fluid leaks out from the pipe joints or the master
cylinder.
WARNING:
CAUTION:
OIL QUANTITY:
Total amount:
1.2 L ( 0.264 Imp gal, 0.317 US gal)
Periodic oil change:
1.0 L ( 0.220 Imp gal, 0.264 US gal)
Engine oil (See page 6-6 for details)
Make sure the engine oil is at the specified level. Add oil as
necessary.
Check the oil level in a daily manner and top it up if
necessary.
If brake fluid leakage is found, ask a Yamaha dealer or
other qualified mechanic for immediate repairs. Such
leakage could indicate a hazardous condition.
CAUTION:
Brake fluid may deteriorate painted surfaces or plastic
parts. Never spill any fluid. If spilled, clean it up
immediately.
Brake fluid leakage
Apply the brake for several seconds. Check to see if any
brake fluid leaks out from the pipe joints or the master
cylinder.
WARNING:
CAUTION:
OIL QUANTITY:
Total amount:
1.2 L ( 0.264 Imp gal, 0.317 US gal)
Periodic oil change:
1.0 L ( 0.220 Imp gal, 0.264 US gal)
Engine oil (See page 6-6 for details)
Make sure the engine oil is at the specified level. Add oil as
necessary.
Check the oil level in a daily manner and top it up if
necessary.

4-7
4-7 After extensive tests, the tires listed below have been
approved by Yamaha for this model. The front and rear
tires should always be by the same manufacturer and
of the same design. No guarantee concerning handling
characteristics can be given if a tire combination other
than one approved by Yamaha is used on this
motorcycle.
FRONT
REAR
Manufacturer
Minimum tire tread depth
(from and rear) !" #$% &'()'
*+,
#% &'()'
!+,1. It is dangerous to ride with a worn-out tire. When
the tire tread begin to show signs of wear, replace
the tire immediately. Brakes, tires and related wheel
parts should be left to a Yamaha dealer.
2. Patching a punctured tube is not recommended. If
it is absolutely necessary to do so, use great care
and replace the tube as soon as possible with a
good quality replacement.
WARNING:WARNING:
After extensive tests, the tires listed below have been
approved by Yamaha for this model. The front and rear
tires should always be by the same manufacturer and
of the same design. No guarantee concerning handling
characteristics can be given if a tire combination other
than one approved by Yamaha is used on this
motorcycle.
FRONT
REAR
Manufacturer
Minimum tire tread depth
(from and rear) !" #$% &'()'
*+,
#% &'()'
!+,1. It is dangerous to ride with a worn-out tire. When
the tire tread begin to show signs of wear, replace
the tire immediately. Brakes, tires and related wheel
parts should be left to a Yamaha dealer.
2. Patching a punctured tube is not recommended. If
it is absolutely necessary to do so, use great care
and replace the tube as soon as possible with a
good quality replacement.
WARNING:WARNING:

6-3
6-3 PERIODIC MAINTENANCE / LUBRICATION
Wheel bearings* Battery
Check looseness and damage. Check electrolyte level, routing breather pipe.
ITEM
How it sounds
/ Adjust if necessary.
REMARKS1,000KM
Fuel line Air filter
Carburetor*Valves*
Muffler
Brakes* Engine oil
Steering bearings* Rear arm pivot*Check fuel hose, for cracks or damage.Clean or replace if necessary.
Adjust
Check damage, Retighten.
Check operation, adjust.
Grease the brake cam. Replace / Check level
Check loosenes.
Repack every 12,000 km or 12 month.** Check rear arm assembly for looseness.
Moderately repack.***
EVERY
3,000KM
OR ERERY
6 MONTHS
Wheels and tires
Check tire pressure, runout and spoke tightness.
Spark plugCheck condition and clean if necessary.
Replace if necessary every 12,000 Km.
3,000KM
PERIODIC MAINTENANCE / LUBRICATION
Wheel bearings* Battery
Check looseness and damage. Check electrolyte level, routing breather pipe.
ITEM
How it sounds
/ Adjust if necessary.
REMARKS1,000KM
Fuel line Air filter
Carburetor*Valves*
Muffler
Brakes* Engine oil
Steering bearings* Rear arm pivot*Check fuel hose, for cracks or damage.Clean or replace if necessary.
Adjust
Check damage, Retighten.
Check operation, adjust.
Grease the brake cam. Replace / Check level
Check loosenes.
Repack every 12,000 km or 12 month.** Check rear arm assembly for looseness.
Moderately repack.***
EVERY
3,000KM
OR ERERY
6 MONTHS
Wheels and tires
Check tire pressure, runout and spoke tightness.
Spark plugCheck condition and clean if necessary.
Replace if necessary every 12,000 Km.
3,000KM

6-4
6-4
* : It is recommended that these items be serviced by a Yamaha dealer.
** : Molybdenum disulfide grease.
*** : Lithium soap based grease.
NOTE: ______________________________________________________________________________________________Brake fluid replacement:
_______________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally check the brake fluid level and add fluid as required.
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two years.
3. Replace the brake hoses every four years, or if cracked or damaged.
ITEM
Front forks*
Sidestand
Control cables: throttle /
clutch / front brakeRear shock absorber*
Drive chain
Fittings / fastenersCheck operation / oil leakage.
Check operation, looseness.
Adujst / Check operation
Lubricate every 12,000 Km. Check chain slack / lubricate, adjust if necessary.
Check looseness.REMARKS1,000KM
Lights and flashers
Nuts and bolts
Motorcycle AspectCheck operation.
Check tighten.
General Check
EVERY
3,000KM
OR EVERY
6 MONTHS3,000KM
Check operation / oil leakage.
Every 500 Km
* : It is recommended that these items be serviced by a Yamaha dealer.
** : Molybdenum disulfide grease.
*** : Lithium soap based grease.
NOTE: ______________________________________________________________________________________________Brake fluid replacement:
_______________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally check the brake fluid level and add fluid as required.
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two years.
3. Replace the brake hoses every four years, or if cracked or damaged.
ITEM
Front forks*
Sidestand
Control cables: throttle /
clutch / front brakeRear shock absorber*
Drive chain
Fittings / fastenersCheck operation / oil leakage.
Check operation, looseness.
Adujst / Check operation
Lubricate every 12,000 Km. Check chain slack / lubricate, adjust if necessary.
Check looseness.REMARKS1,000KM
Lights and flashers
Nuts and bolts
Motorcycle AspectCheck operation.
Check tighten.
General Check
EVERY
3,000KM
OR EVERY
6 MONTHS3,000KM
Check operation / oil leakage.
Every 500 Km

6-17
6-17
Front brake adjustment
A soft or spongy feeling in the brake lever can indicate the
presence of air in the brake system. This air must be
removed by bleeding the brake system before the
motorcycle is operated. Air in the brake system will
considerably reduce braking performance and could result
in a loss of control and possibly an accident. Inspect and if
necessary, bleed the brake system.

# 


Front brake adjustment
A soft or spongy feeling in the brake lever can indicate the
presence of air in the brake system. This air must be
removed by bleeding the brake system before the
motorcycle is operated. Air in the brake system will
considerably reduce braking performance and could result
in a loss of control and possibly an accident. Inspect and if
necessary, bleed the brake system.

# 



6-18
6-18For brake pedal adjustment, be sure to proceed as
follows (it is advisable to have a Yamaha dealer make
this adjustment.)
1. Pedal height.
a. Loosen the locknut.
b. By turning the adjuster clockwise or counterclockwise
adjust the brake pedal position so that its top end is
approximatelly 2 mm (0.08 in) below the footrest top
end.
c. Tighten the locknut.
Rear brake adjustment
1. Adjusting nut 2. locknut
a. Pedal height: 2 mm( 0.08 in)
WARNING:
For brake pedal adjustment, be sure to proceed as
follows (it is advisable to have a Yamaha dealer make
this adjustment.)
1. Pedal height.
a. Loosen the locknut.
b. By turning the adjuster clockwise or counterclockwise adjust the brake pedal position so that its top end is
approximatelly 2 mm (0.08 in) below the footrest top
end.
c. Tighten the locknut.
Rear brake adjustment
1. Adjusting nut 2. locknut
a. Pedal height: 2 mm( 0.08 in)
WARNING:

6-19
6-19
ADVERTENCIA
After adjusting the pedal height adjust brake pedal free
play.
2. Freeplay. The rear brake pedal free play should be adjusted to
20 ~ 30 mm (0.8 ~ 1.2 in) at the brake pedal end. Turn
the adjuster on the brake rod clockwise to reduce play
or counterclockwise to increase play.
ADVERTENCIA
Brake pedal free play should be checked whenever the
chain is adjusted or the rear wheel is removed and then
reinstalled.
If it is impossible to make proper adjustment, consult
a Yamaha dealer.
Check the operation of the brake light after adjusting
the rear brake.
1. Adjuster
a.Free play: 20 ~ 30 mm ( 0.8 ~ 1.2 in)
WARNING:
WARNING:
ADVERTENCIA
After adjusting the pedal height adjust brake pedal free
play.
2. Freeplay. The rear brake pedal free play should be adjusted to
20 ~ 30 mm (0.8 ~ 1.2 in) at the brake pedal end. Turn
the adjuster on the brake rod clockwise to reduce play
or counterclockwise to increase play.
ADVERTENCIA
Brake pedal free play should be checked whenever the
chain is adjusted or the rear wheel is removed and then
reinstalled.
If it is impossible to make proper adjustment, consult
a Yamaha dealer.
Check the operation of the brake light after adjusting
the rear brake.
1. Adjuster
a.Free play: 20 ~ 30 mm ( 0.8 ~ 1.2 in)
WARNING:
WARNING:

6-20
6-20
Brake light switch adjustment
The rear brake light switch is activated by the brake pedal
and is properly adjusted when the brake light comes on
just before braking takes effect. To adjust the rear brake
light switch, hold the switchbody so it does not rotate while
turning the adjusting nut.
Turn the adjusting nut in direction a to make the brake
light come on earlier.
Turn the adjusting nut in direction b to make the brake
light come on later. Checking the front brake pads and rear brake shoes
A wear indicator is provided on each brake. This indicator
allows checking of brake pad/shoe wear without
disassembling the brake.
1. Brake light switch 2. Adjusting nut
Brake light switch adjustment
The rear brake light switch is activated by the brake pedal
and is properly adjusted when the brake light comes on
just before braking takes effect. To adjust the rear brake
light switch, hold the switchbody so it does not rotate while
turning the adjusting nut.
Turn the adjusting nut in direction a to make the brake
light come on earlier.
Turn the adjusting nut in direction b to make the brake
light come on later. Checking the front brake pads and rear brake shoes
A wear indicator is provided on each brake. This indicator
allows checking of brake pad/shoe wear without
disassembling the brake.
1. Brake light switch 2. Adjusting nut