1 - 14
GEN
INFO
MULTI-FUNCTION DISPLAY
WARNING
Be sure to stop the machine before making
any setting changes to the multi-function
display.
The multi-function display is equipped with the
following:
BASIC MODE:
Speedometer
Clock
Two tripmeters (which shows the distance
that has been traveled since it was last set to
zero)
RACE MODE:
Timer (which shows the time that has been
accumulated since the start of timer mea-
surement)
Tripmeter (which shows the accumulated
travel distance in timer measurement)
Change tripmeter digits (capable of change
to any given ones)
DESCRIPTION
Operation buttons:
1Select button “SLCT 1”
2Select button “SLCT 2”
3Reset button “RST”
Screen display:
4Tripmeter indicator
5Tripmeter indicator
6Timer indicator
7Clock/Timer
8Speedometer
9Odometer/Tripmeter
NOTE:
The operation buttons can be pushed in the
following two manners:
Short push: Push the button. ( )
Long push: Push the button for 2 seconds or
more. ( )
MULTI-FUNCTION DISPLAY
1 - 16
GEN
INFO
MULTI-FUNCTION DISPLAY
Changing odometer and tripmeter A/B
(TRIP A/B)
1. Push the “SLCT2” button to change the
tripmeter display. The display will change
in the following order:
Odometer → TRIP A → TRIP B → TRIP A
→ Odometer.
NOTE:
To reset the digits, select the tripmeter
involved and push the “RST” button for 2 sec-
onds or more.
CHANGEOVER TO BASIC MODE/RACE
MODE
NOTE:
Measurement using the timer function can be
made in RACE MODE.
Indicator will light up as an identifier that
shows RACE MODE has been selected.
RACE MODE cannot display the functions as
in BASIC MODE.
Changeover to RACE MODE forces the dig-
its for tripmeter A (TRIP A) in BASIC MODE
to be reset.
Changeover from BASIC MODE to RACE
MODE
1. Push the “SLCT1” button and “SLCT2” but-
ton for 2 seconds or more at the same time
to change over to RACE MODE.
NOTE:
Changeover to RACE MODE will put manual
start measurement on standby causing
and to flash. (For manual start, refer to
“Putting measurement on standby” in “RACE
MODE”.)
