2007 YAMAHA JOG50R engine

After normal use
Remove dirt with warm water, a mild
detergent, and a soft, clean sponge,
and then rinse thoroughly with clean
water. Use a toothbrush or bottle-
brush for hard-to-reach areas. Stub-
born dirt and insects will come off
more easily if the area is covered with
a wet cloth for a few minutes before
cleaning.
After riding in the rain, near the sea or
on salt-sprayed roads
Since sea salt or salt sprayed on the
roads during winter are extremely
corrosive in combination with water,
carry out the following steps after
each ride in the rain, near the sea or
on salt-sprayed roads.
NOTE:
Salt sprayed on roads in the winter
may remain well into spring.
1. Clean the scooter with cold water
and a mild detergent after the
engine has cooled down.
ECA10790
CAUTION
Do not use warm water since it
increases the corrosive action of
the salt.
2. Apply a corrosion protection
spray on all metal, including
chrome- and nickel-plated, surfa-
ces to prevent corrosion.
After cleaning
1. Dry the scooter with a chamois or
an absorbing cloth.
2. Use a chrome polish to shine
chrome, aluminum and stainless-
steel parts, including the exhaust
system. (Even the thermally indu-
ced discoloring of stainless-steel
exhaust systems can be removed
through polishing.)
3. To prevent corrosion, it is recom-
mended to apply a corrosion pro-
tection spray on all metal, inclu-
ding chrome- and nickel-plated,
surfaces.
4. Use spray oil as a universal clea-
ner to remove any remaining dirt.
5. Touch up minor paint damage
caused by stones, etc.6. Wax all painted surfaces.
7. Let the scooter dry completely
before storing or covering it.
EWA10940
s s
WARNING
Make sure that there is no oil or
wax on the brakes or tires. If
necessary, clean the brake
discs and brake linings with a
regular brake disc cleaner or
acetone, and wash the tires
with warm water and a mild
detergent.
Before operating the scooter
test its braking performance
and cornering behavior.
ECA10800
CAUTION
Apply spray oil and wax spa-
ringly and make sure to wipe
off any excess.
Never apply oil or wax to any
rubber and plastic parts, but
treat them with a suitable care
product.
Avoid using abrasive polishing
compounds as they will wear
away the paint.
7
SCOOTER CARE AND STORAGE
7-2
5RW-F8199-E3.qxd 08/09/2005 18:07 Página 49

NOTE:
Consult a Yamaha dealer for advice
on what products to use.
EAU26300
Storage
Short-term
Always store your scooter in a cool,
dry place and, if necessary, protect it
against dust with a porous cover.
ECA10820
CAUTION
Storing the scooter in a poorly
ventilated room or covering it
with a tarp, while it is still wet,
will allow water and humidity to
seep in and cause rust.
To prevent corrosion, avoid
damp cellars, stables (because
of the presence of ammonia)
and areas where strong chemi-
cals are stored.
Long-term
Before storing your scooter for seve-
ral months:
1. Follow all the instructions in the
“Care” section of this chapter.
2. Drain the carburetor float cham-ber by loosening the drain bolt;
this will prevent fuel deposits
from building up. Pour the drai-
ned fuel into the fuel tank.
3. Fill up the fuel tank and add fuel
stabilizer (if available) to prevent
the fuel tank from rusting and the
fuel from deteriorating.
4. Perform the following steps to
protect the cylinder, piston rings,
etc. from corrosion.
a. Remove the spark plug cap and
spark plug.
b. Pour a teaspoonful of engine oil
into the spark plug bore.
c. Install the spark plug cap onto
the spark plug, and then place
the spark plug on the cylinder
head so that the electrodes are
grounded. (This will limit sparking
during the next step.)
d. Turn the engine over several
times with the starter. (This will
coat the cylinder wall with oil.)
e. Remove the spark plug cap from
the spark plug, and then install
the spark plug and the spark plug
cap.
EWA10950
s s
WARNING
To prevent damage or injury from
sparking, make sure to ground the
spark plug electrodes while turning
the engine over.
5. Lubricate all control cables and
the pivoting points of all levers
and pedals as well as of the
sidestand/centerstand.
6. Check and, if necessary, correct
the tire air pressure, and then lift
the scooter so that both of its
wheels are off the ground. Alter-
natively, turn the wheels a little
every month in order to prevent
the tires from becoming degra-
ded in one spot.
7. Cover the muffler outlet with a
plastic bag to prevent moisture
from entering it.
8. Remove the battery and fully
charge it. Store it in a cool, dry
place and charge it once a
month. Do not store the battery in
an excessively cold or warm pla-
ce [less than 0 °C (30 °F) or more
than 30 °C (90 °F)]. For more
7
SCOOTER CARE AND STORAGE
7-3
5RW-F8199-E3.qxd 08/09/2005 18:07 Página 50

DimensionsOverall length
1740 mm
Overall width
675 mm
Overall height
1065 mm
Seat height
770 mm
Wheelbase
1210 mm
Ground clearance
132 mm
WeightWith oil and fuel
CS50 80.5 kg
CS50Z 83.7 kg
EngineEngine type
CS50 Air cooled 2-stroke
CS50Z Liquid cooled 2-stroke
Cylinder arrangement
Forward-inclined single cylinder
Displacement
49.2 cm3
Bore x stroke
40.0 x 39.2 mm
Compression ratio
CS50 10.20 :1
CS50Z 11.40 :1
Starting system
Electric starter and kickstarter
Lubrication system
Separate lubrication (Yamaha autolube)Type
YAMALUBE 2-cycle oil or 2-stroke engine
oil
Engine oil quantityQuantity
1.4 L
Transmission oilType
YAMALUBE 4 (10W30) or SAE10W30
type SE motor oil
Oil change quantity
0.10 L
Air filter element
Wet element
Fuel
Recommended fuel
Regular unleaded gasoline
Fuel tank capacity
5.5 L
CarburetorManufacturer
CS50 DELLORTO GURTNER
CS50Z DELLORTO
Type x quantity
CS50 PHVA 12 ZS/1 PY 12/1
CS50Z PHVA 12 ZS/1
Spark plug(s)Manufacturer/model
NGK/BR8HS
Spark plug gap
0.6-0.7 mm
Clutch type
Dry, centrifugal automatic
TransmissionPrimary reduction system
Helical gear
Primary reduction ratio
52/13 (4.000)
Secondary reduction system
Spur gear
Secondary reduction ratio
CS50 42/13 (3.230)
CS50Z 43 x 13 (3.310)
Transmission type
Single speed automatic
Operation
Centrifugal automatic type
ChassisCaster angle
25.00 degree
Trail
80.0 mm
Front tireSize
110/70-12 47L
Rear tireSize
120/70-12 51L 130/70-12 56L
Maximum load
CS50 161 kg
CS50Z 158 kg
Tire air pressure (measured on cold
tires)
Front
175 kPa
Rear
200 kPa
8
SPECIFICATIONS
8-1
5RW-F8199-E3.qxd 08/09/2005 18:07 Página 52

22-stroke engine oil .....................................3-5
AAcceleration and deceleration ...................5-2
Adjusting the Autolube pump ..................6-14
Adjusting the brake lever free play ..........6-11
Adjusting the carburetor ............................6-9
Adjusting the rear brake lever free play ...6-11
Adjusting the throttle cable free play .........6-9
BBattery......................................................6-17
Braking .......................................................5-2
CCare............................................................7-1
Changing the brake fluid..........................6-13
Checking and lubricating the cables .......6-13
Checking and lubricating the
centerstand ............................................6-14
Checking and lubricating the throttle
grip and cable ........................................6-14
Checking the front brake fluid level .........6-13
Checking the front brake pads and rear
brake shoes ...........................................6-12
Checking the front fork ............................6-15
Checking the spark plug ............................6-5
Checking the steering ..............................6-15
Checking the wheel bearings ..................6-15
Cleaning the air filter element ....................6-8
Clock ..........................................................3-3
Controls and instruments ..........................2-3
Coolant (only for liquid-cooled models).....6-6
EEngine break-in ..........................................5-2
FFinal transmission oil .................................6-6
Front brake lever ........................................3-4
Fuel ............................................................3-5
Fuel and 2-stroke engine oil tank caps .....3-4
Fuel gauge .................................................3-3
HHandlebar switches ...................................3-3
IIdentification numbers ...............................9-1
Indicator lights ...........................................3-1
KKickstarter ..................................................3-6
LLeft view .....................................................2-1
Lubricating the front and rear brake
levers .....................................................6-14
MMain switch/steering lock ..........................3-1
PParking .......................................................5-2
Periodic maintenance and lubrication
chart .........................................................6-2
Pre-operation check list .............................4-2
RRear brake lever .........................................3-4
Replacing a turn signal light bulb or the
tail/brake light bulb ................................6-16
Replacing the fuse ...................................6-18
Replacing the headlight bulb or a front
turn signal light bulb ..............................6-16
Replacing the license plate light bulb......6-17
Right view ..................................................2-2
SSeat ............................................................3-6
Speedometer unit ......................................3-2
Starting a cold engine ................................5-1
Starting off .................................................5-1
Storage.......................................................7-3
Storage compartment ................................3-6
TTires ...........................................................6-9
Troubleshooting .......................................6-19
Troubleshooting chart ..............................6-20
INDEX
5RW-F8199-E3.qxd 08/09/2005 18:07 Página 55