2007 YAMAHA FX HO maintenance

Maintenance and care
88

QSTS cables (pulley end)

QSTS cables (handlebar end)
Remove the QSTS cable housing. Spray a
rust inhibitor into the outer cables. Reinstall
the QSTS cable housing.

Shift cable (shift lever end)

Shift cable (reverse gate end)

Intermediate housing
Fill the intermediate housing with water-re-
sistant grease through the grease nipple
using a grease gun.
EJU34450Checking the battery
Check the level of the battery electrolyte and
make sure that the negative (–) and positive
(+) battery leads are tightened securely.
Grease quantity:
Initial 10 hours or 1 month:
33.0–35.0 cm³ (1.12–1.18 US oz)
(1.16–1.23 Imp.oz)
Every 100 hours or 12 months:
6.0–8.0 cm³ (0.20–0.27 US oz)
(0.21–0.28 Imp.oz)
1Grease nipple
UF1X71E0.book Page 88 Tuesday, September 26, 2006 9:52 AM

Maintenance and care
89
WARNING
EWJ00790
Battery electrolyte is poisonous and dan-
gerous, causing severe burns, etc. Elec-
trolyte contains sulfuric acid. Avoid
contact with skin, eyes, or clothing.
Antidotes
External: Flush with water.
Internal: Drink large quantities of water or
milk. Follow with milk of magnesia, beaten
egg, or vegetable oil. Call a physician im-
mediately.
Eyes: Flush with water for 15 minutes and
get prompt medical attention.
Batteries produce explosive gases. Keep
sparks, flames, cigarettes, etc., well away.
If using or charging the battery in an en-
closed space, make sure that it is well ven-
tilated. Always shield your eyes when
working near batteries.
KEEP OUT OF THE REACH OF CHILDREN.
CAUTION:
ECJ00230

Be careful not to place the battery on its
side.

Be sure to remove the battery from the
battery compartment when adding elec-
trolyte or charging the battery.
To replenish the battery:
(1) Make sure that the electrolyte level is be-
tween the maximum and minimum level
marks.
(2) Refill the battery with distilled water if
necessary.
CAUTION:
ECJ00240
Normal tap water contains minerals that
are harmful to a battery. Use only distilled
water for replenishing the battery.
To recharge the battery:
CAUTION:
ECJ00250
Do not attempt to charge a battery hastily.
Battery life could be shortened.
It is recommended to have a Yamaha dealer
charge the battery. If you charge the battery
yourself, carefully read the battery charger in-
structions before charging and follow the
points below.
(1) Remove all of the battery caps.
(2) If the electrolyte level is low, add distilled
water to raise it to the specified level.
(3) Set the charging rate to 1.9 ampere and
charge the battery slowly until the explo-
sive gases are discharged vigorously
from the battery cells.
1Maximum level mark
2Minimum level mark
UF1X71E0.book Page 89 Tuesday, September 26, 2006 9:52 AM

Maintenance and care
90
To install the battery:
(1) Place the battery in the battery compart-
ment and connect the battery leads to the
battery terminals.
(2) Connect the breather hose to the battery.
(3) Secure the battery in place.
WARNING
EWJ00400
Be sure to connect the breather hose to
the battery. Fire or explosion could result
if the breather hose is damaged, obstruct-
ed, or not connected properly.
CAUTION:
ECJ00260
After installation, make sure that the bat-
tery leads are properly connected to the
battery terminals.
EJU34490Fuel injection system
The fuel injection system was set at the
Yamaha factory. If the fuel injection system
needs to be adjusted, have a Yamaha dealer
service the watercraft.
CAUTION:
ECJ00220
Do not attempt to adjust the fuel injection
system. If the settings are disturbed by
someone who does not have the neces-sary technical knowledge, poor engine
performance and damage may result.
EJU34500Checking the trolling speed
(1) Place the watercraft in the water.
(2) Start the engine and warm it up. Use the
tachometer in the multifunction informa-
tion center to check the trolling speed.
If the trolling speed is out of specification,
have a Yamaha dealer service the watercraft.
1Positive (+) battery terminal: Red lead
2Negative (–) battery terminal: Black lead
3Breather hose
Trolling speed:
1650 ±50 r/min
UF1X71E0.book Page 90 Tuesday, September 26, 2006 9:52 AM

Index
Lubrication................................................ 77
Lubrication points ..................................... 87
M
Main components, location of .................. 20
Maintenance and adjustments ................. 79
Model information....................................... 2
Multifunction information center ......... 34, 60
O
Oil pressure warning indicator.................. 40
Operating your watercraft......................... 64
Operation ................................................. 61
Operation of controls and
other functions ...................................... 24
Operation requirements ........................... 12
Owner’s/operator’s manual and tool kit .... 80
P
Periodic maintenance chart...................... 81
Post-operation care .................................. 73
Pre-operation check list............................ 51
Pre-operation check points ...................... 53
Pre-operation checks ............................... 51
Primary Identification (PRI-ID) number ...... 1
Pull-up cleats
(for FX Cruiser High Output) ................. 33
Q
Quick Shift Trim System (QSTS) ............. 58
Quick Shift Trim System (QSTS)
selector ................................................. 30
R
Reboarding step ....................................... 32
Recommended equipment ....................... 14
Remote control transmitter ....................... 26
Reverse on waterways ............................. 72
Riding with passengers ............................ 65
Right multifunction display and
operation buttons
(for FX Cruiser High Output) ................. 42
Rough water operation ............................. 73
“RPM” indicator light................................. 36
S
Safe boating rules .................................... 19
Seat storage compartment ....................... 46
Seats ........................................................ 24
Shift cable, checking ................................ 85
Shift lever ................................................. 29Shift lever and reverse gate ..................... 57
Spark plugs, cleaning and adjusting ........ 86
“SPEED” indicator light ............................ 36
Start switch............................................... 27
Starting the engine ................................... 61
Starting the watercraft .............................. 65
Steering system ................................. 28, 57
Stern drain plugs ...................................... 55
Stern eyes ................................................ 33
Stopping the engine ................................. 63
Stopping the watercraft ............................ 72
Storage..................................................... 76
Storage compartments ............................. 45
Submerged watercraft .............................. 97
Switches ................................................... 60
T
Throttle cable, checking and adjusting ..... 85
Throttle lever ...................................... 28, 57
Tilt lever .................................................... 29
Towing the watercraft ............................... 97
Transporting ............................................. 75
Trolling speed, checking .......................... 90
Troubleshooting ....................................... 92
Troubleshooting chart .............................. 92
Turning the watercraft .............................. 70
U
“UNLOCK” indicator light .......................... 37
W
“WARNING” indicator light ....................... 37
Water separator ....................................... 54
Watercraft characteristics ......................... 15
Water-skiing ............................................. 17
Watertight compartment ........................... 47
Y
Yamaha Engine Management
System (YEMS) .................................... 33
Yamaha Security System ......................... 33
Yamaha Security System lock and
unlock modes........................................ 33
UF1X71E0.book Page 2 Tuesday, September 26, 2006 9:52 AM