PERIODIC MAINTENANCE AND MINOR REPAIR
6-13
1
2
3
4
5
6
7
8
9
cover by removing the screws.
2. Remove the filter element holder
by removing the screw.
3. Pull the air filter element out, and
then clean it with solvent. After
cleaning, remove the remainingsolvent by squeezing the element.
WARNING
EWA10430
Use only a dedicated parts cleaning
solvent. To avoid the risk of fire or
explosion, do not use gasoline or
solvents with a low flash point.
CAUTION:
ECA10520
To avoid damaging the air filter ele-
ment, handle it gently and carefully,
and do not twist it.
4. Apply oil of the recommended type
to the entire surface of the sponge
material, and then squeeze the ex-
cess oil out.
NOTE:
The air filter element should be wet but
not dripping.
5. Insert the element into the air filter
case.
6. Install the filter element holder by
installing the screw.
7. Install the V-belt air filter case cov-
er by installing the screws.
1. V-belt air filter case cover
1. Air filter element holder
ZAUM00**
1
ZAUM00**
1
1. V-belt case air filter element
ZAUM00**
1
Recommended oil:
Yamaha foam air filter oil or other
quality foam air filter oil
PERIODIC MAINTENANCE AND MINOR REPAIR
6-23
1
2
3
4
5
6
7
8
9ways shield your eyes when
working near batteries. In case
of contact, administer the fol-
lowing FIRST AID.
EXTERNAL: Flush with plenty
of water.
INTERNAL: Drink large quan-
tities of water or milk and im-
mediately call a physician.
EYES: Flush with water for 15
minutes and seek prompt
medical attention.
Batteries produce explosive hy-
drogen gas. Therefore, keep
sparks, flames, cigarettes, etc.,
away from the battery and pro-
vide sufficient ventilation when
charging it in an enclosed
space.
KEEP THIS AND ALL BATTER-
IES OUT OF THE REACH OF
CHILDREN.
To charge the battery
Have a Yamaha dealer charge the bat-
tery as soon as possible if it seems to
have discharged. Keep in mind that the
battery tends to discharge more quicklyif the vehicle is equipped with optional
electrical accessories.
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
2. If the battery will be stored for more
than two months, check it at least
once a month and fully charge it if
necessary.
3. Fully charge the battery before in-
stallation.
4. Before installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
CAUTION:
ECAT1051
Always keep the battery
charged. Storing a discharged
battery can cause permanent
battery damage.
To charge a sealed-type (MF)
battery, a special (constant-volt-
age) battery charger is required.
Using a conventional battery
charger will damage the battery.
If you do not have access to asealed-type (MF) battery charg-
er, have a Yamaha dealer
charge your battery.
After installing the battery, be
sure to turn the main switch
from “ON” to “OFF” three times
in 3 seconds intervals to initial-
ize the idle speed control sys-
tem.
8-1
2
3
4
5
6
7
89
SPECIFICATIONS
EAU2633J
Dimensions:
Overall length:
1855 mm (73.0 in)
Overall width:
685 mm (27.0 in)
Overall height:
1130 mm (44.5 in)
Seat height:
785 mm (30.9 in)
Wheelbase:
1295 mm (51.0 in)
Ground clearance:
115 mm (4.53 in)
Minimum turning radius:
1900 mm (74.8 in)
Weight:
With oil and fuel:
120.0 kg (265 lb)
Engine:
Engine type:
Air cooled 4-stroke, SOHC
Cylinder arrangement:
Forward-inclined single cylinder
Displacement:
125.0 cm
3
Bore
×
stroke:
52.4
×
57.9 mm (2.06
×
2.28 in)
Compression ratio:
10.00 :1
Starting system:
Electric starter and kickstarterLubrication system:
Wet sump
Engine oil:
Type:
SAE20W40
Recommended engine oil grade:
API service SG type or higher, JASO stan-
dard MA
Engine oil quantity:
Periodic oil change:
0.90 L (0.95 US qt) (0.79 Imp.qt)
Final transmission oil:
Type:
SAE10W30 type SE motor oil
Quantity:
0.11 L (0.12 US qt) (0.10 Imp.qt)
Air filter:
Air filter element:
Oil-coated paper element
Fuel:
Recommended fuel:
Regular unleaded gasoline onlyFuel tank capacity:
7.4 L (1.96 US gal) (1.63 Imp.gal)
Fuel injector:
Manufacturer:
AISAN
Model/quantity:
4P91 01 / 1
Spark plug (s):
Manufacturer/model:
NGK/CR7E
Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)
Clutch:
Clutch type:
Dry, centrifugal automatic
Transmission:
Primary reduction system:
Helical gear
Primary reduction ratio:
38/13 (2.923)
Secondary reduction system:
Helical gear
Secondary reduction ratio:
40/12 (3.333)
Transmission type:
V-belt automatic
Operation:
Centrifugal automatic type
Chassis:
Frame type:
Steel tube backbone
Caster angle:
27.00 °
-20 -10 0
10 20 30
40
50 ˚C
SAE 10W-30
SAE 15W-40SAE 20W-40SAE 20W-50
SAE 10W-40
